Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
In a CE amplifier, the collector resistance is 6 kΩ and load resistance is 3 kΩ. The ac load resistance is | |
A. | 9 kΩ [Wrong Answer] |
B. | 6 kΩ [Wrong Answer] |
C. | 3 kΩ [Wrong Answer] |
D. | 2 kΩ [Correct Answer] |
View Answer
Explanation:-
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ Each term in POS form is called max terms.
TRUE
FALSE
⇒ In figure we need an ac ground. The proper value of
1000 μF
100 μF
10 μF
1 μF
⇒
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability
⇒ The trignometric Fourier series of an even function of time does not have
dc term
cosine term
sine term
odd harmonic terms
⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps
⇒ The current I flowing in the branc
-12 A
0
0.125
-3 A
⇒ If operator 'a' = 1 ∠120° then (1 + a + a^{2}) =
-a
-a^{2}
1
0
⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I^{2}/2 pr
I^{2}/4 pr
⇒ In SSB generation, the most commonly used filter is
low pass
RC
LC
mechanical
⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE
⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved
⇒ A short vertical grounded antenna is required to radiate at 1 MHz. The effective height of the antenna is 302 m. The calculated value of radiation resistance is
1.58 Ω
158 Ω
15.8 Ω
none
⇒ A device with input x(t) and y(t) is characterized by y(t) = x^{2}(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is
370 kHz
190 kHz
380 kHz
95 kHz
⇒ The disturbance from adjacent power lines is known as
cross talk
cross fire
inductive disturbance
none of the above
⇒ Which of the following statements about the matched filter in a communication receiver are correct?
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4
⇒ The given characteristic polynomial s^{4} + s^{3} + 2s^{2} + 2s + 3 = 0 has
zero root in RHS of s-plane
one root in RHS of s-plane
two roots in RHS of s-plane
three roots in RHS of s-plane
⇒ An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is
0.707 V
1 V
1.44 V
indeterminate as value of R is not given
⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter
⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________
Decaying sinusoidal sequence
Growing sinusoidal sequence
Decaying non sinusoidal sequence
Growing non sinusoidal sequence
⇒ A digital watch contains
quartz crystal oscillator
RC oscillator
LC oscillator
either quartz or RC oscillator
⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA
⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V
⇒ Which of the following has a major role in implementation of functions calls in C?
Processor's registers
Data segment
The heap
System stack
⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier
⇒ The input resistance of FET in the low frequency small signal operation is
infinitely high
around 1 kΩ
around 50 Ω
very small
⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region
⇒ The power rating of radio transmitters is around
100 mW
10 W
10 kW
10 MW
⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively
⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt^{2}
volt/sec
volt-sec
⇒ Each term in POS form is called max terms.
TRUE
FALSE
⇒ In figure we need an ac ground. The proper value of
1000 μF
100 μF
10 μF
1 μF
⇒
Assertion (A): The duty cycle of a class C amplifier affects the power dissipation of transistor
Reason (R): At higher harmonics the efficiency of a class C amplifier becomes poor
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability
⇒ The trignometric Fourier series of an even function of time does not have
dc term
cosine term
sine term
odd harmonic terms
⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps
⇒ The current I flowing in the branc
-12 A
0
0.125
-3 A
⇒ If operator 'a' = 1 ∠120° then (1 + a + a^{2}) =
-a
-a^{2}
1
0
⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I^{2}/2 pr
I^{2}/4 pr
⇒ In SSB generation, the most commonly used filter is
low pass
RC
LC
mechanical
⇒ A 4 bit binary adder has 4 full adders.
TRUE
FALSE
⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved
⇒ A short vertical grounded antenna is required to radiate at 1 MHz. The effective height of the antenna is 302 m. The calculated value of radiation resistance is
1.58 Ω
158 Ω
15.8 Ω
none
⇒ A device with input x(t) and y(t) is characterized by y(t) = x^{2}(t). An FM signal with frequency deviation of 90 kHz and modulating signal bandwidth of 5 kHz is applied to this device. The bandwidth of the output signal is
370 kHz
190 kHz
380 kHz
95 kHz
⇒ The disturbance from adjacent power lines is known as
cross talk
cross fire
inductive disturbance
none of the above
⇒ Which of the following statements about the matched filter in a communication receiver are correct?
- Its impulse response depends on the signed shape
- It maximizes the SNR at the detection shape.
- It produces ISI.
- It may produce phase error if synchronization is improper.
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4
⇒ The given characteristic polynomial s^{4} + s^{3} + 2s^{2} + 2s + 3 = 0 has
zero root in RHS of s-plane
one root in RHS of s-plane
two roots in RHS of s-plane
three roots in RHS of s-plane
⇒ An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is
0.707 V
1 V
1.44 V
indeterminate as value of R is not given
⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter
⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________
Decaying sinusoidal sequence
Growing sinusoidal sequence
Decaying non sinusoidal sequence
Growing non sinusoidal sequence
⇒ A digital watch contains
quartz crystal oscillator
RC oscillator
LC oscillator
either quartz or RC oscillator
⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA
⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V
⇒ Which of the following has a major role in implementation of functions calls in C?
Processor's registers
Data segment
The heap
System stack
⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier
⇒ The input resistance of FET in the low frequency small signal operation is
infinitely high
around 1 kΩ
around 50 Ω
very small
⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region
⇒ The power rating of radio transmitters is around
100 mW
10 W
10 kW
10 MW
⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively
⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt^{2}
volt/sec
volt-sec