Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A pulse function having magnitude E and duration from t = 0 to t = a can be represented as |

A. | sum of two pulse functions [Wrong Answer] |

B. | difference of two pulse functions [Wrong Answer] |

C. | difference of two step functions each of magnitude E and one originating at t = 0 and the other at t = a [Correct Answer] |

D. | none of the above [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Ohmic range of carbon composition resistors is

10 to 100 ohms

10 to 10 K ohms

10 to 200 ohms

10 to 25 M ohms

⇒ The current

*i*(

*t*), though a 10 Ω resistor in series with an inductance, is given by

*i*(

*t*) = 3 + 4 sin (10

*t*+ 45°) + 4 sin (300

*t*+ 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are

41 A, 410 W, respectively

35 A, 350 W, respectively

5 A, 250 W, respectively

11 A, 1210 W, respectively

⇒ In a

*p*type material the Fermi level is 0.3 eV above valence band. The concentration of acceptor atoms is increased. The new position of Fermi level is likely to be

0.5 eV above valence band

0.28 eV above valence band

0.1 eV above valence band

below the valence band

⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________

Decaying sinusoidal sequence

Growing sinusoidal sequence

Decaying non sinusoidal sequence

Growing non sinusoidal sequence

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.

B2, 01000011

2B, 01000011

2B, 00110100

B2, 01000100

⇒ A push pull amplifier is a

power amplifier

voltage amplifier

current amplifier

both power and current amplifier

⇒ In a multicavity klystron amplifier the electron velocity of the order of

10 m/s

10

^{3}m/s

10

^{6}

*m*/

*s*

10

^{12}

*m*/

*s*

⇒ Pirani gauge is used to measure

very low pressure

high pressure

pressure in the range of 1 atmosphere

fluid flow

⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is

50 Hz

0 Hz

100 Hz

75 Hz

⇒ In the circuit of figure, the switch is closed at

*t*= 0 with

*i*

_{L}(0) = 0 and V

_{C}(0) = 0. In the steady state n

_{c}equ

100

*v*

0

*v*

∞

- 100

*v*

⇒ In PCM, the quantization noise depends on

sampling rate

signal power

number of quantization level

signal energy

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is

100

75

66.6

50

⇒ Diamond is a paramagnetic material.

TRUE

FALSE

⇒ If a signal band limited for

*f*is sampled at a rate less than 2

_{m}*f*the reconstructed signal will be

_{m}smaller in amplitude

distorted

having higher frequencies suppressed

none of the above

⇒ Thermal run away of a transistor occurs when

heat dissipation from transistor is excessive

transistor joints melt due to high temperature

there is excessive leakage current due to temperature rise

none of the above

⇒ The operator precedence in Java is in the order

arithmetic operation, increment and decrement operation, comprassion, logical operation and assignment operation.

increment and decrement operation, arithmetic operation, comparison, logical operation and assignment operation.

comparison, arithmetic operation, increment and decrement operation, logical operation and assignment operation.

arithmetic operation, comparison operation, increment and decrement operation, logical operation and assignment operation.

⇒ For a given line voltage, four heating coils will produce maximum heat when connected

all in parallel

all in series

with two parallel pairs in series

one pair in parallel with the other two in series

⇒ In an R-C circuit, the impedance is 40 Ω at a frequency of 100 Hz. At 200 Hz the impedance should be

40 Ω

80 Ω

20 Ω

more than 20 Ω but less than 40 Ω

⇒ In figure, which value of Z

_{L}will cause maximum power to be transferred to the l

2 +

*j*2 Ω

2 -

*j*2 Ω

- 2 Ω

2 Ω

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M

_{1M1 = (P OR Q) XOR RM1 = (P AND Q) XOR RM1 = (P NOR Q) XOR RM1 = (P XOR Q) XOR R}

⇒ Which one of the following is true?

Characteristic impedance of twin wire feeder and coaxial cable are nearly the. same

The characteristic impedance of coaxial cable is more than that of twin wire cable

The characteristic impedance of twin wire cable is more than that of coaxial cable

The characteristic impedance of a twin wire feeder may be more or less than that of coaxial cable

⇒ Given two numbers A and B in sign magnitude representation in an eight bit format A = 00011110 and B = 10011100 then A ⊕ B gives

10000010

11111

10011101

11100001

⇒ The figures shows the symbo

p channel depletion MOSFET

p channel enhancement MOSFET

complementary MOSFET

p channel JFET

⇒ In 8085 microprocessor based system running at 3 MHz clock frequency what should be the minimum pulse width of the INTR signal, so that it is recognized successfully?

0.33 μs

0.666 μs

5.8 μs

none of these

⇒ What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

- Emitter diffusion
- Base diffusion
- Buried layer formation
- E pi-layer formation

3, 4, 1, 2

4, 3, 1, 2

3, 4, 2, 1

4, 3, 2, 1

⇒ For an R-C impedance function, the residues at all poles are

real

imaginary

real and positive

positive

⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is

same as BPSK

half of that in BPSK

one-fourth of that in BPSK

none of the above

⇒ The given figure shows three Nyquist plots of G(

*s*) H(

*s*) =

*e*/[

^{-sT}*s*(

*s*+ 1)] for different values of T. The curves 1, 2, 3 ca

for T = 0, 0.5 and 1 respectively

for T = 1, 0.5 and 0 respectively

for T = 0.5, 1 and 0 respectively

for T = 0, 1 and 0.5 respectively

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be

very low

low

high

almost zero

⇒ A telephone user while talking to a person via a satellite has to wait for reply for about __________ millisecond.

100

270

470

540