Question is ⇒ Schottky clamping is resorted to in TTL gates, Options are ⇒ (A) to reduce propagation delay, (B) to increase noise margin, (C) to increase packing density, (D) to increase fan out, (E) , Leave your comments or Download question paper.

Question is ⇒ Schottky clamping is resorted to in TTL gates, Options are ⇒ (A) to reduce propagation delay, (B) to increase noise margin, (C) to increase packing density, (D) to increase fan out, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Schottky clamping is resorted to in TTL gates
A.	to reduce propagation delay [Correct Answer]
B.	to increase noise margin [Wrong Answer]
C.	to increase packing density [Wrong Answer]
D.	to increase fan out [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ The merging of a hole and an electron is called
recombination
covalent bonding
thermal union
none of the above

⇒ In a tungsten filament lamp
the current at the instant of switching is less than operating current
the current at the instant of switching is more than operating current
the current at the instant of switching is equal to operating current
the current at the instant of switching may be less than or equal to operating current

⇒ A thyristor has a maximum allowable junction temperature of 120°C and the ambient temperature is 40°C. If thermal resistance is 1.6° C/W, the maximum allowable internal power dissipation is
20 W
50 W
92 W
128 W

⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒ Consider the equation s² + 2s + 2 + K(s + 2) = 0. Where do the roots of this equation break on the root loci plot?
-3.414
-2.414
-1.414
-0.414

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ In a microstrip transmission the signal can be easily redirected by changing the centre strip.
TRUE
FALSE

⇒ Which of the following oscillator is not in FM?
Crystal oscillator
Hartley oscillator
Colpitts oscillator
All of the above

⇒ In what condition does BJT act like an open switch
cut off
saturation
active
both (b) and (c)

⇒ The voltage e₀ in the fi
48 V
24 V
36 V
28 V

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ Magnetisation of a material is the magnetic dipole moment per m³.
TRUE
FALSE

⇒ A quantization error is an essential aspect of ADC
TRUE
FALSE

⇒ If operator 'a' = 1 ∠120° then (1 - a) =
3
3 ∠ - 30°
3 ∠ + 30°
3 ∠60°

⇒ For a depletion type NMOS, V_p = - 4 volts. For V_GS = 0, 1_D = 16 mA in the pinch off region of V_DS. For V_GS = - 2, the value of I_D in the pinch off region of V_DS is given by
64 mA
32 mA
16 mA
4 mA

⇒ What is the correct sequence of the following step in the fabrication of a monolithic, Bipolar junction transistor?

Emitter diffusion
Base diffusion
Buried layer formation
E pi-layer formation

Select the correct answer using the codes given below:
3, 4, 1, 2
4, 3, 1, 2
3, 4, 2, 1
4, 3, 2, 1

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the collector current will be
1.005 mA
0.985 mA
0.975 mA
0.955 mA

⇒ In using KCL it is necessary that current leaving a node is written as negative.
TRUE
FALSE

⇒ A 4 bit counter with four flip-flops will count upto decimal
8
15
31
63

⇒

Match the following:

	List I (Functional headings of instruction set of 8085)		List II (Functions performed)
A.	Branch group	1.	Compares, rotates etc.
B.	Logic group	2.	Moves, loads, stores etc.
C.	Data transfer group	3.	Initiates conditional or unconditional jumps, calls etc.

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ The number of key words in C is
4
8
16
32

⇒ Two passive elements are connected in series and a dc voltage is applied to the circuit. The time variation of the current is shown in figure. The two elements
one resistance and the other inductance
both resistances
one inductance and the other capacitance
one resistance and the other capacitance

⇒ For a plane good conductor, skin depth varies
directly as square root of permeability
directly as square root of frequency
inversely as permittivity
inversely as square root of conductivity

⇒ At room temperature the barrier potential in a silicon diode is
0.1 V
0.3 V
0.7 V
1 V

⇒ The angle δ for a mica capacitor is about
25°
15°
5°
1°