Question is ⇒ The reflection coefficient on a line is 0.2 ∠45°. The SWR is, Options are ⇒ (A) 0.8, (B) 1.1, (C) 1.2, (D) 1.5, (E) , Leave your comments or Download question paper.

Question is ⇒ The reflection coefficient on a line is 0.2 ∠45°. The SWR is, Options are ⇒ (A) 0.8, (B) 1.1, (C) 1.2, (D) 1.5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The reflection coefficient on a line is 0.2 ∠45°. The SWR is
A.	0.8 [Wrong Answer]
B.	1.1 [Wrong Answer]
C.	1.2 [Wrong Answer]
D.	1.5 [Correct Answer]
View Answer 5 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As per BIS, solid insulators are classified into 6 categories.
TRUE
FALSE

⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^-t. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^-t
2 sin (t + 45°) + e^-t
sin (t - 45°) + e^-t
sin (t + 45°) + e^-t

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒

Assertion (A): FET is a unipolar device.

Reason (R): BJT is bipolar device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The problem of current lagging is associated with
DCTL gates
DTL gates
ECL gates
CMOS gates

⇒ If an inverter is placed at the input to an SR flip-flop, the result is
T flip-flop
D flip-flop
JK flip-flop
BCD decade counter

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75

⇒ A major advantage of TWT over a Klystron lies in its
higher bandwidth
higher gain
higher frequency
higher output

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ MS Excel is an application software for financial planning.
TRUE
FALSE

⇒ A silicon diode is forward biased and total applied voltage is 5 V. The voltage across p-n junction is
5 V
Slightly less than 5 V
0.7 V
0

⇒ Read the following statements as regards register pairs in microprocessor 8085

B represents B, C pair with B as high order register and C as low order register.
D represents D, E pair with D as high order register and E as low order register.
H represents H, L pair with H as high order register and L as low order register.

Which of the above statements are correct?
All
1 and 3
1 and 2
2 and 3 only

⇒ The circuit in figure(1) is replaced by that in figure(2). It remains same R₀ wil
zero
R
2R
4R

⇒ Harmonic distortion in CB amplifier may be least when the load resistance is
negligible
very low
very high
infinite

⇒ In CCD
a small charge is deposited for logical 1
a small charge is deposited for both logical 1 and 0
a small charge is deposited for logical 0 and large charge for logical 1
none of the above

⇒

Assertion (A): Magnetic tape can be accessed only sequentially.

Reason (R): Magnetic tape consists of magnetised spots or tracks.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0⁺ the current through
0.166666666666667
2.5 A
3.1 A
0

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ 268₁₀ = __________ .
10A₁₆
10B₁₆
10C₁₆
10D₁₆

⇒ Which of the following is a valid expression in FORTRAN 77?
B * - 3
B * (- 3)
B * * - 3
B * + 2

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): TWT uses a focussing mechanism to prevent the electron beam from spreading.

Reason (R): In a TWT the electron beam has to travel a much longer distance than in klystron.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The range of a cordless telephone is about
1000 m
500 m
100 m
10 m

⇒ MUF is highest in periods of greatest sunspot activity.
TRUE
FALSE