Question is ⇒ Master control facility (MCF) for INSAT-2 series satellites is located at, Options are ⇒ (A) Madras, (B) New Delhi, (C) Leh, (D) Hassan, (E) , Leave your comments or Download question paper.

Question is ⇒ Master control facility (MCF) for INSAT-2 series satellites is located at, Options are ⇒ (A) Madras, (B) New Delhi, (C) Leh, (D) Hassan, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Master control facility (MCF) for INSAT-2 series satellites is located at
A.	Madras [Wrong Answer]
B.	New Delhi [Wrong Answer]
C.	Leh [Wrong Answer]
D.	Hassan [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In radar system if the antenna diameter is increased by a factor of 4, the minimum range will increased by a factor of
1
2
22
4

⇒ In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
be doubled
be increased four times
remain the same
become half

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒ In figure if C is replaced by short circuit then R_B wil
425 K
412 K
474 K
400 K

⇒ The access time of a word in 4 MB main memory is 100 ms. The access time of a word in a 32 kb data cache memory is 10 ns. The average data cache bit ratio is 0.95. The efficiency of memory access time is
9.5 ns
14.5 ns
20 ns
95 ns

⇒ Choose the correct option

Transit period is the time between two steady state
Transient Response is the response due to internal energy stored in circuit
Transit response is also called natural response
Transit response arises due to presence of C and L in the circuit
Transit is due to R, L, C in the circuit

4, 3, 2 , 1
5, 4, 3, 2
5, 4, 3, 1
5, 1, 4

⇒ Which of the following pairs of octal and binary numbers are not equal?
111 11011₂ = 767₈
110110101₂ = 665₈
11010₂ = 3₈
10101.11₂ = 25.6₈

⇒ In a series RLC circuit for lower frequency power factor is ________
leading, Lagging
lagging, Leading
independent of frequency
same

⇒ The diameter and thickness of CD are
6 cm and 1.2 mm
6 cm and 0.6 mm
12 cm and 0.6 mm
12 cm and 1.2 mm

⇒ A D.C. amplifier amplify
D.C. only
A.C. only
both A.C. and D.C.
none of the above.

⇒

Assertion (A): Fourier series can also be written in exponential form.

Reason (R): sin (n ωt) and cos (n ωt) can be expressed as sum or difference of exponentials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A two branch parallel tuned circuits has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. The bandwidth is 200 radians/sec. A load of resistance R_L is connected in parallel. The new bandwidth will be
200 rad/sec
more than 200 rad/sec
less than 200 rad/sec
200 rad/sec or less

⇒ In the BJT amplifier shown in the figure is the transistor is biased in the forward active region. Putting a capacitor across R_E
decrease the voltage gain and decrease the I/P impedance
increase the voltage gain and decrease the I/P Impedance
decrease the voltage gain and Increase the I/P impedance
none of the above

⇒ Consider the following statements about advantages of phase discriminator over slope detector

Fewer tuned circuits
Greater limiting
Better linearity
Easy alignment

Which of the above are true?
1, 2, 3, 4
2, 3, 4
1, 2, 3
1, 3, 4

⇒ Four memory chips of 16 x 4 size have their address buses connected together. This system will be of size
64 x 4
16 x 16
32 x 8
256 x 1

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Shift left and shift right operations occur in a calculator.
TRUE
FALSE

⇒

Assertion (A): In circular waveguide the attenuation of TE₀₁ mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TE_Q1 mode are completely circumferential.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following statements in FORTRAN 77 is non executable?
GO TO
RETURN
STOP
PARAMETER

⇒ The input differential stage of op-amp. 741 is baised at about 10 μA current such a low current of the input stage gives

high CMRR
high differential gain
low differential
high input impedance

Which of these are correct?
1 and 2
1, 2 and 4
3 and 4
1, 2, 3 and 4

⇒ No load d.c. output will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ In the circuit shown in the figure, the approximate voltage at the transist
base and emitter respectively are -8 V and -7.3 V
base and collector respectively are -8 V and -5 V
Collector and emitter respectively are -5 V and -7.3
base, emitter and collector respectively are -8 V, 7.3 V and -5 V

⇒ Quantization error occurs in
D/A converter
A/D converter
both D/A and A/D converter
neither D/A nor A/D converter

⇒ Commercial ECL gates use two ground lines and one negative supply to
reduce power consumption
increase fan out
reduce loading effect
eliminate the effect of power line glitches on the biasing circuit

⇒ A plane EM wave is travelling in an unbound loss less dielectric having μ_y = 1 and ε_y = 4, the time average Poynting vector of the wave is 5 W/m³ . The phase velocity v_p (assuming velocity of light as 3 x 10⁸ m/sec) is
1.5 x 10⁸ m/sec
3 x 10⁸ m/sec
2.5 x 10⁸ m/sec
0.5 x 10⁸ m/sec

⇒

Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statement regarding single-sideband (SSB) transmission is not correct?
In such transmission only or sideband is transmitted, leaving of the other sideband and the carrier
It has gained general acceptance of use in home-entertainment equipment
It is generally reserved for point-to-point communication
The amount of power and bandwidth necessary to be transmitted for a given amount of information are appreciable reduced

⇒ DS directive in 8085
forces the assembler to reserve one byte of memory
forces the assembler to reserve a specified number of bytes in the memory
forces the assembler to reserve a specified number of consecutive bytes in the memory
none of the above

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ TTL logic is preferred to DRL logic because
greater fan-out is possible
greater logic levels are possible
greater fan-in is possible
less power consumption is achieve