Question is ⇒ The absolute values of pinch-off voltage and gate-source cut-off voltage are, Options are ⇒ (A) nearly zero, (B) complementary to each other, (C) never equal, (D) equal, (E) , Leave your comments or Download question paper.

Question is ⇒ The absolute values of pinch-off voltage and gate-source cut-off voltage are, Options are ⇒ (A) nearly zero, (B) complementary to each other, (C) never equal, (D) equal, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The absolute values of pinch-off voltage and gate-source cut-off voltage are
A.	nearly zero [Wrong Answer]
B.	complementary to each other [Wrong Answer]
C.	never equal [Wrong Answer]
D.	equal [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Hysteresis curve is associated with motion of domain walls.
TRUE
FALSE

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ Which class of amplifiers operates with least distortion?
Class A
Class B
Class C
Class AB

⇒ Evaluate the power stored in inductor and capac
25 J, 12.5 J
12.5 J, 25 J
25 J, 50 J
12.5 J, 50 J

⇒ Which one of the following is the correct statement of the system characterized by the equation y(t) = ax(t) + b?
linear for any value of b
linear if b > 0
linear if b < 0
non-linear

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ Waves of frequencies higher than 30 MHz penetrate the atmosphere.
TRUE
FALSE

⇒ In a zener diode
the forward current is very high
sharp breakdown occurs at a certain reverse voltage
the ratio v-i can be negative
there are two p-n junctions

⇒ In figure, D₂ turns on
v_i is more positive than V₁
v_i is less positive than V₁
v_i is more negative than V₂
v_i is less negative than V₂

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒ Master control facility (MCF) for INSAT-2 series satellites is located at
Madras
New Delhi
Leh
Hassan

⇒

Assertion (A): Increasing the system gain improves steady state behaviour but may result in instability.

Reason (R): A compensator is inserted into a system to ensure specified performance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A FM signal with modulation index M_f is passed through a frequency doubler. The wave in the output of the doubler will have modulation index of
M_f
M_f/2
2M_f
UM_f

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒ Half bridge and full bridge inverters of one type use different commutation methods.
TRUE
FALSE

⇒ In a positive edge triggered JK flip flop, J = 1, K = 0 and clock pulse is rising Q will
be 0
be 1
show no change
toggle

⇒ In a minimum function
the degree of numerator and denominator are equal
the degree of numerator and denominator are unequal
the degree of numerator is one more than degree of denominator
the degree of numerator is one less than degree of denominator

⇒ Consider the following statements

If ensemble and time averages of a random process are identical, the process is ergodic.
If ensemble and time average of a random process are not identical, the process is ergodic.
An ergodic process is stationary.
A stationary process is necessarily ergodic.

Which of the above statements are correct?
1 only
1 and 3 only
1, 3 and 4 only
1 and 4 only

⇒ In 8085 the time required to add two 32 bit numbers is (if clock frequency is 5 MHz)
about 1 ns
about 1 μs
about 30 μs
about 100 μs

⇒ Pre-emphasis circuit is used
after modulation
before modulation
before detection
after detection

⇒ PROM is
Permanent Read Only Memory
Polarized Read Only Memory
Positive Read Only Memory
Programmable Read Only Memory

⇒ The commonly employed filter in SSB generation is
high pass filter
RC filter
LC filter
mechanical filter

⇒ Two sinusoidal voltage sources v₁ = 50 sin (100t) and v₁ = 50 sin (100t + p) are connected in parallel and fed an inductance X_L = 2Ω. The cuirent through X_L is
25 A
about 17.5 A
zero
50 A

⇒ The signal m(t) = 10 cos 100 pt is sampled at the rate of F_s = 75 H_z, then determine signal after sampling.
4 cos 100 pt + 8 sin 200 pt
4 cos 100 pt + 8 sin 200 pt + cos 75 pt
4 cos 25 pt + 8 sin 50 pt + cos 75 pt
none

⇒ Schrodinger wave equation is a
linear equation
differential equation
partial differential equation
none of the above

⇒ The minimum value of h_fe of a transistor used in RC phase shift oscillator is
54.4
45.4
44.5
29

⇒ If it is desired to have low output impedance in an amplifier circuit then we should use
common collector circuit
common base circuit
common emitter circuit
either (b) or (c)

⇒ A CMOS amplifier when compared to an N-channel. MOSFET, has the advantage of
higher cut off frequency
higher voltage gain
higher current gain
lower current drain from the power supply, there by less dissipation

⇒

Assertion (A): The small signal analysis of a transistor amplifier is done to obtain the current gain, voltage gain and the conversion efficiency of an amplifier.

Reason (R): The small signal analysis of a transistor amplifier uses the small signal parameters of the transistor.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Fields are said to be circularly polarized if
their magnitudes are equal
their magnitudes are equal and they differ in phase by ± 90°
their magnitudes are unequal and they differ in phase ± 90°
their magnitudes are unequal and they are in phase