Question is ⇒ A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be, Options are ⇒ (A) 2.2 A, (B) less than 2.2 A, (C) 2.2 A or less than 2.2 A, (D) 2.2 A or less or more than 2.2 A, (E) , Leave your comments or Download question paper.

Question is ⇒ A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be, Options are ⇒ (A) 2.2 A, (B) less than 2.2 A, (C) 2.2 A or less than 2.2 A, (D) 2.2 A or less or more than 2.2 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be
A.	2.2 A [Wrong Answer]
B.	less than 2.2 A [Correct Answer]
C.	2.2 A or less than 2.2 A [Wrong Answer]
D.	2.2 A or less or more than 2.2 A [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the characteristic equation of a closed loop system is s² + 2s + 2, then the system is :
over damped
critically damped
under damped
undamped

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than
500 V
400 V
375 V
250 V

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 0.76
0.3, 0.95

⇒ What will be BCD number when the output is 0.37 V?
110111
10110111
11001000
1001000

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ In figure, V_C is approximately equa
2 V
4.6 V
8 V
7.6 V

⇒ As compared to operating current, the current drawn by a memory chip in stand by mode is
about the same
about one-eighth
about 1 / 64
about 1 / 500

⇒ Digital television is also called
High digital television
High definition television
High deflection television
High display television

⇒ Characteristic wave impedance is
ε/μ
(ε/μ)^1/2
E_x/H_y
H_y/E_x

⇒ The process of extension of a single-crystal surface by growing a film in such a way that the added atoms form a continuation of the single-crystal structure is called
Ion implantation
Chemical vapour deposition
Electroplating
Epitaxy

⇒ A total of 16 equally probable events exist. If it is required to select one out of them, the number of required bits is
2
4
3
5

⇒

Assertion (A): It is possible that a digital circuit gives the same output for different input voltages

Reason (R): A digital circuit is also called logic circuit.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is
01101100 00000000 00000000 10000100
00000000 01101100 00000000 10000100
00000000 01101100 10000100 00000000
01101100 00000000 10000100 00000000

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ In an ideal current source, the source resistance is zero.
TRUE
FALSE

⇒ Consider the following statements :

Tellegen's theorem is applicable to any lumped networks.
The reciprocity theorem is applicable to linear bilateral networks.
Thevenin's theorem is applicable to two- terminal linear active networks.
Norton's theorem is applicable to two-terminal linear active networks.

Which of these statement are correct?
1, 2, and 3
1, 2 and 4
1, 2, 3 and 4
3 and 4

⇒ Gain margin and phase margin can be determined from Bode plots as well as Nyquist plot.
TRUE
FALSE

⇒ The passage of current in an electrolyte is due to the movement of
electrons
molecules
atoms
ions

⇒ As comparated to an ordinary p-n diode, the extent of impurity atoms in a tunnel diode
is more
is less
may be more or less
is almost the same

⇒ The skip distance is
same for each layer
independent of frequency
independent of the state of ionisation
independent of transmitted power

⇒ In steady state condition inductor behave as
open circuit
short circuit
current source
voltage source

⇒ The IF frequencies in a TV receiver
38.9 MHz for video and 33.4 MHz for audio
38.9 MHz for both video and audio
33.4 MHz for both video and audio
33.4 MHz for video and 38.9 MHz for audio

⇒ A thyristor has a maximum allowable junction temperature of 120°C and the ambient temperature is 40°C. If thermal resistance is 1.6° C/W, the maximum allowable internal power dissipation is
20 W
50 W
92 W
128 W

⇒ In the circuit shown below, the op-amp is ideal, the transistor has V_BE = 0.6 V and β = 150. Decide whether the feedback in the circuit is positive or negative and determine the voltage V at the output of the op
Positive feedback, V = 10 V
Positive feedback, V = 0 V
Negative feedback, V = 5 V
Negative feedback, V = 2 V

⇒ 74HCT00 series is
NAND IC
interface between TTL and CMOS
inverting IC
NOR IC

⇒ Which inductor is linear?
Air cored
Cast iron cored
Sheet steel cored
Iron alloy cored

⇒ The value of the integral of the function g(x, y) = 4x³ + 10y⁴ along the straight line segment from the point (0, 0) to the point (1, 2) in the x-y plane is
33
35
40
56

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct