Question is ⇒ A diode can have a very high forward resistance., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ A diode can have a very high forward resistance., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A diode can have a very high forward resistance.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Radar principle is used in
detection of aircraft
burglar alarms
garage door openers
all of the above

⇒ An input voltage V(t) = 10 2 cos (t + 10°) + 10 3 cos (2t + 10°)V is applied to a series combination of resistance R = 1 kΩ inductance L = 1H. The resulting steady-state current i(t) in ampere is
10 cos (t + 55°) + 10 cos (2t + 10° tan^-12)
10 cos (t + 55°) + 103/2 cos (2t + 55°)
10 cos (t - 35) + 10 cos (2t + 10° - tan^-12)
10 cos (t - 35) + 103/2 cos (2t + 35°)

⇒ A series R, L, C circuit has R = 2Ω, L = 1H, C = 1 μF. It is connected to an ac variable frequency source of peak voltage 10 V. At resonance the power supplied by the source will be
50 Ω
25 Ω
12.5 Ω
6.25 Ω

⇒ A very reliable service has to be established between two points on earth separated by 1000 km. The band that will be used as
MF
VHF
VLF
HF

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A TV receiver is 40 cm wide and 30 cm high. The EHT supply required is about
2kV
20 kV
53 kV
10 W

⇒ Which of the following combinations has no phase inversion of the signal?
Two CE stages
CE and CC stages
Three CE stages
CE stages and emitter follower

⇒ Fourier transform and F(jω) of a signal f(t) has the property
F(jω) = F(-jω)
F(jω) = -F(-jω)
F(jω) = F^*(jω)
F(jω) = -F^*(-jω)

⇒ The function (s + 2) (s + 4)/[(s + 1)(s + 3)]
is a reactance function
is an RC function
may be a reactance function or an RC function
may be RC function or an RL function

⇒ Quantizing error occurs in
TDM
FDM
PCM
PWD

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒ It is desired that transmission line and load should match for a range of frequencies. The best method is
to use a balun
to use a single stub of adjustable position
to use a double stub
to use a broad band amplifier

⇒ In a conductor which of the following relations hold good?
∇ x D = r
∇ . D = r
∇ x D = 0
∇ . D = 0

⇒ The port of PC to which mouse is connected is called
serial port
parallel port
input port
scanner port

⇒ Consider the following statements as regards DPSK and DEPSK

DPSK demodulator requires a device which operates at carrier frequency and provides a delay of bit time T_b
In DPSK, synchronous demodulation recovers the signal b(t) and the decoding of b(t) to generate d(t) is done at base band
In both DPSK and DEPSK errors always occur in pairs

Which of the above statements are correct?
1 and 3
1 and 2
2 and 3
1, 2 and 3

⇒ PWM can be generated
by a free running multivibrator
by integrating the signal
by a monostable multivibrator
by differentiating pulse position modulation

⇒ Which of the following materials in not an insulator?
Diamond
Graphite
Bakelite
Lucite

⇒ The command ^C in MS WORD
copies the text in clip board
copies the text in secondary storage device
copies the text in file
None of the above

⇒ Hystresis loss least depends on
frequency
magnetic field intensity
volume of the material
grain orientation of material

⇒ If (225)_Y = (165)₈ find value of Y
7
8
9
11

⇒ Which of the following transducers requires a high input impedance preamplifier for proper measurements?
Thermocouple
Piezoelectric
Thermistor
L.V.D.T

⇒ In the circuit, the value of the voltage sour
-22 V
-12 V
+12 V
-10 V

⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system

⇒

Assertion (A): In 8085 SP and PC are 8 bit each.

Reason (R): 8085 is an 8 bit microprocessor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Figure shows basic Hartley oscillator configuration. Do you think the polarities marked for the split coiled are corr
yes they are
no they are not
it really doesn't matter
none of the above

⇒ Cross talk is due to reception of portions of a signal from one channel into another.
TRUE
FALSE

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ A coil is wound having a diameter d. Its inductance is 10 mH. If it is rewound on the same core with a wire having diameter 0.5 d and total weight of the wire is the same as before, the inductance will be
5 mH
10 mH
160 mH
40 mH

⇒ A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =
20000
2000
200
20