Question is ⇒ In a microstrip transmission the signal can be easily redirected by changing the centre strip., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ In a microstrip transmission the signal can be easily redirected by changing the centre strip., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a microstrip transmission the signal can be easily redirected by changing the centre strip.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ADI A4H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ The breakdown voltage in a zener diode
is almost constant
is very small
may destroy the diode
decreases with increase in current

⇒ For a type 1 system and unit parabolic input, the steady state error is
0
∞
1
1/K_v

⇒ If noise margin is high, there is lesser chance of false operation.
TRUE
FALSE

⇒ In the below figure the average load current is 15 A. The rms value of transformer secondary current
15 A
10.61 A
7.5 A
14.14 A

⇒ A communication channel with additive white Gaussian noise, has a bandwidth of 4 kHz and an SNR of 15. Its channel capacity is
1.6 kbps
16 kbps
32 kbps
256 kbps

⇒ Windows can run several tasks simultaneously.
TRUE
FALSE

⇒ The circuit of the given figure realizes the func
Y = (A + B) C + DE
Y = A + B + C + D + E
AB + C +DE
AB + C(D + E)

⇒ Consider the following program in Pascal 2
2.6
2.63
26.3

⇒ M circles are symmetrical with respect to
real and imaginary axis
M = 1 straight line and real axis
M = 1 straight line and imaginary axis
M = 1 straight line

⇒ FM amplifier in a superheterodyne receiver
increases selectivity
suppresses noise
provides improved tracking
improves the rejection of the image frequency

⇒ In a JFET, gates are always
forward biased
reverse biased
either forward or reverse biased
unbiased

⇒ Consider the following statements

ECL has least propagation delay
TTL has largest fan out
CMOS has highest noise margin
TTL has lowest power dissipation

Which of these are correct?
1 and 3
2 and 4
3 and 4
1 and 2

⇒ How many interrupts are there of 8085 μP?
4
5
6
8

⇒ In a single stage differential amplifier, the output offset voltage is mainly dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ In a piezoelectric crystal, application of a mechanical stress would produce
plastic deformation of the crystal
magnetic Dipoles in the crystal
electric polarization in the crystal
shift in the Fermi level

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ For a rectangular waveguide (a x b, a > b) to support only the TE₁₀ mode at wavelength which one of the following pairs of in equalities is to be satisfied?
b < λ < 2b; λ > 2a
b < λ < 2b; λ < 2a
a < λ < 2b; λ < 2a
a < λ < 2b; λ > 2a

⇒ A function of one of more variables which conveys information on the nature of physical phenomenon is called
Noise
Interference
System
Signal

⇒ In figure it is desired that output wave is symmetrical.
both diodes should be similar and |V₁| = |V₂|
both diodes should be similar
|V₁| = |V₂|
either (a) or (b)

⇒ A digital voltmeter has a 4 1/2 digit display. The 1 V range can measure voltage up to
0.9999 V
1.9999 V
0.199 V
9.999 V

⇒ f_unity of an op-amp is about 1 kHz.
TRUE
FALSE

⇒ A coaxial RF cable has a characteristic impedance of 50 Ω and C equal to 40 pF/m. The inductance is
1 μ H/m
10 μ H/m
0.1 μ H/m
0.01 μ H/m

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ Coulomb friction is
the force of sliding friction between dry surfaces
the force of friction between moving surfaces separated by viscous fluid
the force required to initiate motion between two contacting surfaces
all of the above

⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ ROC of sequence x[n] = (3)ⁿ ∪[n] + (4)ⁿ ∪[- n - 1]
|z| > 4
3 < |z| < 4
|z| < 4
|z| > 3