Question is ⇒ In the circuit of figure, the switch is closed at t = 0 with iL (0) = 0 and VC (0) = 0. In the steady state nc equ, Options are ⇒ (A) 100 v, (B) 0 v, (C) ∞, (D) - 100 v, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit of figure, the switch is closed at t = 0 with iL (0) = 0 and VC (0) = 0. In the steady state nc equ, Options are ⇒ (A) 100 v, (B) 0 v, (C) ∞, (D) - 100 v, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
A.	100 v [Correct Answer]
B.	0 v [Wrong Answer]
C.	∞ [Wrong Answer]
D.	- 100 v [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following identifiers is invalid in Pascal?
BETA
MAX 40
2ND
A MAX

⇒ A voltage wave containing 10% third harmonic is applied to a scries R-L circuit. The percentage third harmonic content in the current wave will be
more than 10%
10% or less than 10%
less than 10%
10% or more or less

⇒ The ideal op-amp has the following characteristics
R_i = ∞, A = ∞, R₀ = 0
R_i = 0, A = ∞, R₀ = 0
R_i = ∞, A = 0, R₀ = 0
R_i = 0, A = ∞, R₀ = ∞

⇒ The binary addition 1 + 1 =
11
10
111
100

⇒

Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.

Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): Heaviside partial expansion gives a simple procedure to find inverse Laplace transform of the terms having a complex conjugate pair of roots.

Reason (R): If I(s) = P(s)/Q(s) and all roots of Q(s) = 0 are simple, i(t) will have terms with exponentials having real exponents only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A CE amplifier has a high input signal. In the wave shape of emitter current
positive and negative half cycles will be symmetrical
positive half cycle will be elongated and negative half cycle will be compressed
positive half cycle will be compressed and negative half cycle will be elongated
the half cycles may be either elongated or compressed

⇒

Match the following:

	List I		List II
A.	PMMC	1.	Square law type scale
B.	Moving iron	2.	Very good response
C.	Thermo-couple	3.	Linear scale
D.	Electrostatic	4.	Voltmeter

A-4, B-1, C-2, D-3
A-3, B-2, C-1, D-4
A-4, B-2, C-1, D-3
A-3, B-1, C-2, D-4

⇒ A linear discrete time system has the char. equation z³ - 0.81z = 0, the system is
stable
marginally stable
unstable
stability cannot be assessed from the given information

⇒ Which op-amp circuit uses a capacitor in series with input and resistance in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
None of the above

⇒ A transmitter radiates a power 20 KW and its base current is 18A. The radiation resistance of the antenna is
1111 Ω
900 Ω
75 Ω
62 Ω

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represe
unit circles
constant resistance circles
constant reactance circles
constant reflection coefficient circles

⇒ Find R_L for maximum power tran
3 Ω
1.125 Ω
4.17 Ω
none

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above

⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t²
t
t
1/t

⇒ A 6 bit ladder A/D converter has input 101001. The output is (assume 0 = 0 V and 1 = 10 V)
4.23
6.41
5.52
9.23

⇒ One of the function of the Sio₂ layer in an IC is to
act as a dielectric for capacitors
prevent shorting of elements by interconnections
from cathodes for diodes
afford protection from the radiations

⇒ Which of the following are included in the architecture of a computer?

Addressing modes, CPU
Instruction set, data formats
Secondary memory, operating system

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
3 only

⇒ Each cell of static RAM contains
4 MOS transistors
4 MOS transistors and 1 capacitor
2 MOS transistors
4 MOS transistors and 2 capacitors

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ In fi
the collector currents of T₁ and T₂ are equal
the collector current of T₁ is more than that of T₂
the collector current of T₁ is double that of T₂
the collector currents of T₂ is more than that of T₁

⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of
30 Ω
10 Ω
9 Ω
zero

⇒ The circuit in figure will act as ideal current source with respect to terminals A and B when frequenc
0
1 rad/sec
4 rad/sec
16 rad/sec

⇒ The shape of torque-speed curve of a two phase servo- motor mostly depends on
ratio of rotor reactance to rotor resistance
ratio of stator reactance to rotor resistance
ratio of rotor reactance to rotor resistance and also the ratio of stator reactance to stator resistance
magnitude of stator voltages

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ For a high pass filter attenuation = 0 at f = 0.
TRUE
FALSE

⇒ The leads in a TRIAC are denoted by
anode cathode, gate
T₁ T₂, gate
T₁, T₂, anode
T₁, T₂, T₃