Question is ⇒ A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency., Options are ⇒ (A) 0 Hz, (B) 0.75 kHz, (C) 0.5 kHz, (D) 0.25 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency., Options are ⇒ (A) 0 Hz, (B) 0.75 kHz, (C) 0.5 kHz, (D) 0.25 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 1 kHz sinusoidal signal is ideally sampled at 1500 samples/sec and the sampled signal is passed through an ideal low pass filter with cut off frequency 800 Hz. The output signal has the frequency.
A.	0 Hz [Wrong Answer]
B.	0.75 kHz [Wrong Answer]
C.	0.5 kHz [Correct Answer]
D.	0.25 kHz [Wrong Answer]
View Answer 3 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the K map of the given figure the simplified Boolean expressio
AC + A B
A BC + A B C + A B C + AB C
AC + A B + AC
A C + A B + AB

⇒

Assertion (A): CMOS devices have very low power consumption

Reason (R): CMOS devices have high noise margin.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage

⇒ The depletion layer width of Junction
decreases with light doping
is independent of applied voltage
is increased under reverse bias
increases with heavy doping

⇒ If two networks are connected in parallel then equivalent y parameter of both is
[y] = [y_a] [y_b]
[y] = [y_a] + [y_b]
[y] = [y_a]/[y_b]
none

⇒ A magnetic circuit has an iron length of 20 cm and air gap length 0.1 cm. If μ_r = 200 then
mmf for iron and air gap are equal
mmf for iron is much less than that for air gap
mmf for iron is much more than that for air gap
either (a) or (c)

⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of
1
-1
0
3

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ The real part of complex frequency s corresponds to oscillations.
TRUE
FALSE

⇒ For an ideal noise free transistor amplifier the noise factor is
zero
zero dB
1 dB
depends on other factors

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A message signal x(t) is amplitude modulated with carrier c(t2ω
3ω
1ω
0.5ω

⇒ In a series resonant circuit, the resonant frequency is
geometric mean of half power frequencies
arithmetic mean of half power frequencies
difference of half power frequencies
none of the above

⇒ In a synchro transmitter, which coil acts as primary?
Rotor
Stator
Partly rotor and partly stator
Tertiary

⇒ In a backward wave oscillator the wave travelling along the line winds itself back and forth
TRUE
FALSE

⇒ In figure (A) and
A represents PCM and B represents AM
A represents FM and B represents AM
A represents AM and B represents FM
A represents PCM and B represents FM

⇒ If f(t) is an even function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ Who developed the concept of time varying electric field producing a magnetic field?
Gauss
Faraday
Hertz
Maxwell

⇒ In parallel in-parallel out shift register all bits are loaded and read simultaneously.
TRUE
FALSE

⇒
Match the following:
List I List II
A. p type semiconductor 1. silicon
B. n type semiconductor 2. holes are majority carriers
C. Intrinsic semiconductor 3. electrons are majority carriers
D. Tungsten 4. is a metal

A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-1, C-2, D-4

⇒ India's first domestic geostationary satellite 1NSAT-IA was launched on 10th April 1982 from
USSR
USA
UK
UP

⇒ Identification of highest priority interrupt can be achieved in a minimum time by which of the following schemes?
Hardwired polling
Priority encode circuit
Software polling
Subdivision of interrupt register into a number of sub registers which are checked parallely

⇒ Which connection is rarely used?
CE
CB
CC
Both (a) and (b)

⇒ To protect an SCR against high di/dt we connect
a capacitance in series with SCR
a capacitance in parallel with SCR
an inductance in parallel with SCR
an inductance in series with SCR

⇒ Read the following statements about Excel
It supports many arithmetic functions like SUM, ABS, EXP, INT, MOD etc.
It supports many trigonometric functions.
It supports IRR function to calculate interest rate.
It supports PV function to calculate the present value of future receipts.
Which of the above are correct?
All
1, 2 and 3 only
1, and 2 only
1 only

⇒ If f(t)↔ F(jω), and f(t) is real, then F(- jω)
F(jω)
F*(j↔)
F*(- jω)
none of these

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ A moving coil meter has 10 Ω resistance and requires 40 mA for full scale deflection. The shunt resistance required to convert it into 0-2 A ammeter is
0.1021 Ω
0.2041 Ω
0.256 Ω
0.4210 Ω

⇒
Assertion (A): Data communication using digital data must be very accurate.
Reason (R): In analog signals redundancy is available but in digital signals redundancy is not available.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

	List I		List II
A.	p type semiconductor	1.	silicon
B.	n type semiconductor	2.	holes are majority carriers
C.	Intrinsic semiconductor	3.	electrons are majority carriers
D.	Tungsten	4.	is a metal

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math