Question is ⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is, Options are ⇒ (A) 1.39 V, (B) 0.75 V, (C) 13.9 V, (D) 7.45 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is, Options are ⇒ (A) 1.39 V, (B) 0.75 V, (C) 13.9 V, (D) 7.45 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A standard cell of 1.0185 V is used with a slide wire potentiometer. The balance was obtained at 60 cm. When an unknown emf was connected, the balance was obtained at 82 cm. The magnitude of unknown emf is
A.	1.39 V [Correct Answer]
B.	0.75 V [Wrong Answer]
C.	13.9 V [Wrong Answer]
D.	7.45 V [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When the circuit is switched on, the loop gain of a Wien bridge oscillator is
1
more than 1
less than 1
about 0.5

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the direction of current
antiparallel to magnetic field
in arbitrary direction

⇒ Which of the following DO statements is invalid in FORTRAN 77?
DO 161 = 1, 15
DO 16 1 = 1, 10, 1
DO 16 I = - 5, 5, 2
none of the above

⇒ In a single phase full wave controlled rectifier using centre tap transformer, the voltage across each half of secondary is V_m sin ωt. The peak inverse voltage is
2 V_m
V_m
0.5 V_m
0.25 V_m

⇒ In an ideal current source, the source resistance is zero.
TRUE
FALSE

⇒ The heat sink disposes off heat mainly by
radiation
natural convection
forced convection
conduction

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The relation between bandwidth B, modulating frequency f_m and frequency deviation Δf for a sinusoidally modulated FM signal is
B = Δf + f_m
B = 2(Δf + f_m)
B = f_m - Δf/
B = 2(f_m - Δf)

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ A power supply has full-load voltage of 20 V. What will be its no load voltage when its voltage regulation is 100%
0 V
10 V
20 V
40 V

⇒ In most transistor the collector region is made physically larger than the emitter region
for dissipating heat
to distinguish it from other regions
as it is sensitive to ultraviolet rays
to reduce resistance in the path of flow of electrons

⇒ Circuit shown in the figur
astable multivibrator
monostable multivibrator
VCO
ramp Generator

⇒ For the network in figure, which of the following expressions gives the value of net inductance between terminals A and B
1 only
1 and 2
3 and 4
2 and 4

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒
Assertion (A): Gate triggering is the most commonly used method for triggering of an SCR.
Reason (R): Even a small gate current is sufficient to turn on an SCR.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a bistable multivibrator, commutating capacitors are used to
increase the base storage charge
provide ac coupling
increase the speed of response
alter the frequency of the output

⇒ An antenna is 30 metre high. The frequency is 1 MHz. The radiation resistance is about
1500 Ω
150 Ω
15 Ω
1.5 Ω

⇒ When a CE transistor is cut off
voltage across collector reduces to zero
voltage across collector is maximum
maximum collector current flows
maximum voltage appears across the load resistance

⇒ What is the frequency of pulse at the points a, b, c in the circ
3 MHz
7.8 KHz
10 KHz
1 MHz

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k10¹⁰
10⁷
1.414 x 10^-10
2 x 10^-20

⇒ A waveguide behave as
high Pass filter
low Pass filter
band Pass filter
all Pass filter

⇒
Assertion (A): A Smith chart can be used for a number of calculations of a transmission line
Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if
A = 1, B = 1, S = 1
A = 1, B = 1, S = 0
A = 1, B = 0, S = 1
A = 1, B = 0, S = 0

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ If there are no permanent dipoles in a dielectric material, the dielectric constant is independent of temperature.
TRUE
FALSE

⇒ The derating factor for a BJT transistor is about
0.5 mW/°C
2.5 mW/°C
10 mW/°C
25 mW/°C

⇒ If two networks are connected in series of individual Z parameter as Z_a and Z_b then equivalent Z is
[Z] = [Z_a] + [Z_b]
[Z] = [Z_a] [Z_b]
[Z] = [Z_a]/[Z_b]
[Z] = [Z_a] - [Z_b]

⇒ At room temperature kT = 0.03 eV.
TRUE
FALSE

⇒ CW Doppler radar is capable of giving accurate measurements of relative velocities.
TRUE
FALSE

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math