Question is ⇒ Almost all high level languages have provision for logical operations., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Almost all high level languages have provision for logical operations., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Almost all high level languages have provision for logical operations.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A generator is feeding power to a transmission line of characteristic impedance Z₀. The line is terminated in impedance Z_L. Standing waves will be set up if
Z_L = Z₀
Z_L < Z₀
Z_L > Z₀
both (b) and (c)

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒ Which of the following is not correct in respect of electrostatic instrument?
It is essentially a voltmeter
It is suitable for only high voltages
It has a uniform scale
It can be used for both ac and dc

⇒ For a nonlinear resistance
v-i plot is not a straight line
resistance increases as current increases
resistance decreases as current increases
current decreases as voltage increases

⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to
increase its I_QL
reduce its I_0H
increase its speed of operation
reduce power dissipation

⇒

Match the following:

	List I (Memories)		List II (Characteristic)
A.	Static PLA	1.	erasable, programmable
B.	CCD	2.	ultra high speed
C.	ECL	3.	stores large volume of data
D.	GAL	4.	Does not need refreshing
		5.	Non-volatile

A-4, B-3, C-2, D-1
A-4, B-2, C-3, D-1
A-5, B-1, C-2, D-3
A-3, B-5, C-2, D-1

⇒ The purpose of connecting a coupling capacitor in the output circuit of an amplifier is
to increase voltage gain
to increase collector current
to block dc collector voltage
all of the above

⇒

Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical

⇒ Cache memory size is about
a few KB
about 500 KB
about 1 MB
about 50 MB

⇒ A 6 bit ladder A/D converter has input 101001. The output is (assume 0 = 0 V and 1 = 10 V)
4.23
6.41
5.52
9.23

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ In common base configuration, the input characteristics of bipolar junction transistor are drawn between
V_EB and I_E
V_CB and I_C
I_C and V_CE
I_E and V_CE

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒ In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is r₀ the dc beam current is
r₀v₀
r₀^/v₀
v₀^/r₀
(v₀^/r₀)²

⇒ In crystalline solids, atoms are stacked in a regular manner.
TRUE
FALSE

⇒ For a class B amplifier using a supply of V_CC = 30 V and driving a load of 16 Ω the maximum efficiency will be __________ .
0.724
0.7854
0.624
0.6854

⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open

⇒

Assertion (A): The equation D = ∈₀∈_rE is applicable only to isotropic materials.

Reason (R): In polycrystalline materials, the directional effects are absent.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is not correct?
P(A) = P(A) - 1
0 ≤ P ≤ 1
If A and B are mitual exclusive then P(A + B) = P(A) + P(B)
P(A) = 1 - P(A)

⇒ In figure, the current through 10 V batter
0
0.5 A charging
0.5 A discharging
none of the above

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ In the above circuit, if the power dissipated in the 6 Ω resistor is zero then
20 2∠ 45°
20 ∠ 30°
20 ∠ 45°
20 2∠ 30°

⇒ In gases the flow of current is due to
positive ions only
electrons only
electrons, positive ions and negative ions
electrons and positive ions

⇒ Typical values of voltage gain for CE, CB and CC amplifiers are
100, 100 and 1 respectively
100, 1 and 100 respectively
100, 1 and 1 respectively
1, 100 and 100 respectively

⇒ A trimmer is basically a
insulator
inductor
capacitor
variable resistor