Question is ⇒ For the transport lag G(jω) = e-jωT, the polar plot is, Options are ⇒ (A) a semi circle, (B) a circle, (C) a unit circle, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ For the transport lag G(jω) = e-jωT, the polar plot is, Options are ⇒ (A) a semi circle, (B) a circle, (C) a unit circle, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the transport lag G(jω) = e^-jωT, the polar plot is
A.	a semi circle [Wrong Answer]
B.	a circle [Wrong Answer]
C.	a unit circle [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The current rating of a cable depends on
length of cable
diameter of cable
both length and diameter of cable
none of the above

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ How many lines are there in address bus of 8085 μp?
6
8
12
16

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ A single phase cycloconverter feeds a resistance heating load. The heating power is provided by
only the fundamental component of output wave
only higher harmonics in the output wave
both fundamental and higher harmonics in the output wave
either (a) or (b)

⇒ Which component is allowed to pass through it by a choke filter?
Dc
Ac
Both dc and ac
Only high frequency ac

⇒ An instruction using immediate addressing mode in 8085 is
2 bytes long
3 bytes long
2 or 3 bytes long
1 or 2 or 3 bytes long

⇒

Assertion (A): In n-p-n transistor conduction is mainly due to electrons.

Reason (R): In n type materials electrons are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ An amplifier operating over a frequency range of 18 to 20 MHz has 10 kΩ input resistance. At a temperature of 27° C, the noise voltage at input of amplifier is (Boltzman constant k = 1.38 x 10^-23 J/K)
18.2 μV
182 μV
16.2 μV
162 μV

⇒

Assertion (A): In the interaction region of magnetron an electron is subjected to three forces: force due to electric field, force due to magnetic field and centrifugal force.

Reason (R): The mechanism of generation of microwaves, in a magnetron, involves interaction of electromagnetic fields with electrons moving in static electric and magnetic fields oriented at right angles to each other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): Secondary instruments require calibration at frequent intervals.

Reason (R): Secondary instruments have many errors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Tropospheric scatter is used with frequencies in the
HF
VHF
UHF
VLF

⇒ On load tap changer using thyristors can have a maximum of two taps.
TRUE
FALSE

⇒ Which of these has 3 layers?
PIN diode
Zener diode
Schottky diode
Photo diode

⇒ Measurement of Hall coefficient enables the determination of
mobility of charge carriers
type of the conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
fermi level and forbidden energy gap

⇒ For a NPN bipolar transistor, what is the main stream of current in the base region?
Drift of holes
Diffusion of holes
Drift of electrons
Diffusion of electrons

⇒ Bit is
smallest piece of electronic hardware
a drilling tool
an abbreviation for binary digit
the smallest number

⇒ In a digital counter the number of flip-flops is
always 2
always even
always odd
equal to the number of bits required in the final binary count

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6

⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above

⇒ For parallel plane waveguides, which is the mode with lowest cut-off frequency?
TE₁₀
TM₁₀
TEM
TE₁₁

⇒ Consider the following statements in connection with CMOS inverter in figure where both the MOSFET are of enhancement type and both have a threshold voltage of
Only statement 1 is true
Only statement 2 is true
Both the statement are true
Both the statements are false

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒ Accumulator is an 8 bit register and is also known as register B.
TRUE
FALSE

⇒ Which of the following flip-flop do not have race problem?
T flip-flop
D flip-flop
JK flip-flop
Master-slave flip-flop

⇒ A half wave diode rectifier and full wave diode bridge rectifier both have an input frequency of 50 Hz. The frequencies of outputs respectively are
100 Hz and 50 Hz
50 Hz and 100 Hz
100 Hz each
50 Hz each

⇒ The modulation index of wideband FM signal is
less than unity
unity
greater than unity
nearly 0.67

⇒ The abbreviation DTL stands for
Digital Timing Logic
Diode Transistor Logic
Dynamic Transient Logic
Delayed Tracking Logic