Question is ⇒ A <i>Q</i> meter uses the principle of, Options are ⇒ (A) variation of self inductance, (B) variation of mutual inductance, (C) series resonance, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A <i>Q</i> meter uses the principle of, Options are ⇒ (A) variation of self inductance, (B) variation of mutual inductance, (C) series resonance, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Q meter uses the principle of
A.	variation of self inductance [Wrong Answer]
B.	variation of mutual inductance [Wrong Answer]
C.	series resonance [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a push pull circuit the most favoured biasing method is
self bias
emitter bias
diode bias
collector bias

⇒ A stepper motor is
a two phase induction motor
is a kind of rotating amplifier
is an electromagnetic transducer used to convert an angular position of shaft into electrical signal
is an electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis

⇒ The secondary constants of a line are
Z₀
Z₀ and γ
Z₀, γ and wave velocity
Z₀, γ and L

⇒

Match the following:

	List I		List II
A.	CLP	1.	Displays DOS version being used
B.	MSAV	2.	Partitions hard disk
C.	F DISK	3.	Anti-virus program
D.	VER	4.	Cleans screen

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1
A-2, B-1, C-4, D-3

⇒

Assertion (A): Inter-digitated geometry is widely used for microwave transistors.

Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The electrical power to a megger is provided by
battery
inverter
permanent magnet dc generator
ac generator

⇒

Assertion (A): SSB transmitter is generally smaller than AM transmitter

Reason (R): SSB systems mostly use combined transmitter receiver.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The current through the coil of an electromagnet is doubled. The magnetic field around the coil
is halved
is doubled
becomes four times
remains the same

⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W

⇒ The number of product terms in the minimized sum of product expression obtained through the following K-map, where d, don't c
2
3
4
5

⇒ The system with given pole-zero diagram is _______
Causal
Anti-causal
Both sided
Cannot be determined

⇒ If the transfer function has zeros only on jω axis or in left half plane, it is a minimum phase function.
TRUE
FALSE

⇒ Gauge factor of a strain gauge is
unit change in resistance per unit change in length
change in resistance per unit change in length
unit change in length per unit change in resistance
none of the above

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE

⇒ A frequency multiplier stage should operate as
class A
class B
class AB
class C

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒ The term VLSI generally refers to a digital IC having
more than 1000 gates
more than 100 gates
more than 1000 but less than 9999 gates
more than 100 but less than 999 gates

⇒ A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is
V_m
0.5 V_m
zero
0.5 V_m - voltage drop across inductance

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which wave is also called surface wave?
Ground wave
Sky wave
Space wave
Both (b) and (c)

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ The maximum phase difference between the applied voltage and current in a RLC series current with finite values of R, L, C, and f can be
less than 90°
less than 45°
180°
30°

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :
62831.9 V/sec
125663.8 V/sec
31415.95 V/sec
None

⇒

Assertion (A): Moving iron instrument can be used on ac or dc.

Reason (R): In a moving iron instrument deflecting torque is proportional to square of current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The divergence of the electric field intensity at any point equals
1/4 pε₀ times the volume charge density
l/ε₀ times the volume charge density at that point
ε₀ times the volume charge density at that point
the volume charge density at that point

⇒

Match the following:

	List I (Oscillator)		List II (Features)
A.	Wien Bridge	1.	RF oscillator, uses two inductors and one capacitor
B.	Colpitt's	2.	LC oscillator for radio frequencies uses three capacitances and one inductance
C.	Hartley	3.	RC oscillator for audio frequencies
D.	Clapp	4.	RF oscillator, uses two capacitances and one inductance

A-2, B-1, C-4, D-3
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ In a N-P-N transistor the function of the emitter is
to emit or inject holes into the collector
to emit or inject electrons into the collector
to emit or inject electrons into the base
to emit or inject holes into the base

⇒ A constant k band stop filter has cutoff frequencies of 1000 and 4000 Hz. The attenuation will be maximum when frequency is
4000 Hz
3000 Hz
2000 Hz
1000 Hz