Question is ⇒ In microprocessor 8088, Options are ⇒ (A) 8 data bits are multiplexed with 8 least significant bits of address bus, (B) 8 data bits are multiplexed with 8 most significant bits of address bus, (C) 16 data bits are multiplexed with 16 bits of address bus, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In microprocessor 8088, Options are ⇒ (A) 8 data bits are multiplexed with 8 least significant bits of address bus, (B) 8 data bits are multiplexed with 8 most significant bits of address bus, (C) 16 data bits are multiplexed with 16 bits of address bus, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In microprocessor 8088
A.	8 data bits are multiplexed with 8 least significant bits of address bus [Correct Answer]
B.	8 data bits are multiplexed with 8 most significant bits of address bus [Wrong Answer]
C.	16 data bits are multiplexed with 16 bits of address bus [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a CE bipolar transistor operating in active region, collector current is independent of
V_CE
I_B
both V_CE and I_B
none of the above

⇒ The electron and hole concentration in a intrinsic semiconductor are n_i and P_i respectively when doped with a P type material, these change to n and P, respectively. Then
n + P = n_i + P_i
n + n_i = P + P_i
nP_i = n_iP
n_P = n_i P_i

⇒ A lag compensator
speeds up the transient response of the system
improves steady state behaviour of the system
improves steady state behaviour and speeds up the transient response of the system
improves steady state behaviour and preserves the transient response of the system

⇒

Match the following:

	List I (Circuit)		List II (Characteristics)
A.	Darlington pair	1.	uses pnp and npn transistors used as power amplifier
B.	CB amplifier	2.	Voltage gain nearly 1 and high input impedance
C.	Cascade amplifier	3.	low input impedance used for high frequency isolation

A-1, B-2, C-3
A-2, B-3, C-1
A-2, B-1, C-3
A-3, B-1, C-2

⇒ In a two tone AM system the two modulating frequencies are 2000 p and 4000 p rad/sec. If carrier frequency is 2p x 10⁶ rad/sec the frequencies of upper sidebands are
1.002 MHz and 1.004 MHz
1.001 MHz and 1.002 MHz
1.001 MHz and 1.004 MHz
1.002 MHz and 1.008 MHz

⇒ In sign magnitude numbers,
the leading bit stands for the sign
the leading bit is part of the magnitude
the leading bit is always 0
the leading bit is always 1

⇒ In the above case the hexadecimal notation for the last memory location is
0
FFFF
3FFF
5FFF

⇒ Audio-signal modulates a 125 MHz carrier, causing a frequency deviation of 5 kHz. The bandwidth of the narrowband FM signal is __________ kHz.
10
8
9
20

⇒ The Gaussian filter characteristic figure is realiza
TRUE
FALSE

⇒ A satellite link uses different frequencies for receiving and transmitting in order to
avoid interference from terrestrial microwave links
avoid interference between its powerful transmitted signal and weak in coming signal
minimise free-space losses
maximise antenna gain

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above

⇒ For a given operating frequency a waveguide has more power handling capacity than a coaxial line.
TRUE
FALSE

⇒ Which of the following is not an electromagnetic device?
Hall transducer
Transformer
Speedometer
Eddy current damping device

⇒

Assertion (A): A fully controlled bridge converter can operate in first and fourth quadrant.

Reason (R): A semi converter is cheaper than a full converter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of these has semi-conductor metal junction?
PIN diode
Photo diode
Tunnel diode
Schottky diode

⇒ The function Y = AC + BD + EF is
POS
SOP
Hybrid
none of the above

⇒ In synchronous detection of an AM signal
Carrier is completely suppressed
Both side hands are suppressed
Only one side band and part of carrier is suppressed
One side band and full carrier is suppressed

⇒ In all pure metals, temperature coefficient of resistance is positive.
TRUE
FALSE

⇒

Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors

Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The input impedance of short-circuited line of length l where λ/4 < l < λ/2, is
resistive
inductive
capacitive
none of the above

⇒ In operational Amplifier, Common mode voltage gain should be
0
∞
1
0.5

⇒ In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then
C = log₂ N
C = (δf) log₂ N
C = 2 (δf) log₂ N
C = 0.5 (δf) log₂ N

⇒ A Clapp's oscillator is
a modified Hartley oscillator
a modified Colpitt's oscillator
a modified RC oscillator
none of the above

⇒ In figure, V_C is approximately equa
2 V
4.6 V
8 V
7.6 V

⇒ In a sine wave, maximum rate of change of voltage occurs at
ascent of the waveform
+ ve maximum
- ve maximum
between maximum and minimum

⇒ The rate of change of digital signals between High and Low level is
very fast
fast
slow
very slow

⇒ In a junction transistor, the collector cut-off current 'I_CB0' reduces considerably by doping the
emitter with high level of impurity
emitter with low level of impurity
collector with high level of impurity
collector with low level of impurity

⇒ In 8085 microprocessor, what is the length of IR (instruction register)?
6 bits
8 bits
12 bits
16 bits

⇒ For a quadratic factor in transfer function the phase angle is not a function of damping factor.
TRUE
FALSE

⇒ The types of carriers in a semiconductor are
1
2
3
4