Question is ⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be, Options are ⇒ (A) out of phase by 90°, (B) in phase, (C) out of phase by 45°, (D) out of phase 180°, (E) , Leave your comments or Download question paper.

Question is ⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be, Options are ⇒ (A) out of phase by 90°, (B) in phase, (C) out of phase by 45°, (D) out of phase 180°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
A.	out of phase by 90° [Correct Answer]
B.	in phase [Wrong Answer]
C.	out of phase by 45° [Wrong Answer]
D.	out of phase 180° [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Industrial robots improve productivity.

Reason (R): Robots can handle monotonous and complex jobs without error in operation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after SBI 0B7H?
12 H, 0
12 H, 1
DDH, 0
DDH, 1

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ Which of the following circuits can be used as parallel-to-series converter?
Digital counter
Decoder
Demultiplexer
Multiplexer

⇒ Which of these commutation methods is used in AC-DC converters?
Class A
Class C
Class D
Class F

⇒ In a full bridge inverter, the waveshape of load current depends on
relative values of load parameters R, L and C
relative values of load parameters R and L
relative values of load parameters L and C
gating frequency

⇒ To neglect a current source the terminals across the source are
replaced by some resistance
replaced by capacitance
open-circuited
short-circuited

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ In a rare gas, the molecules of some atoms have an excess positive or negative charge. The electric field tends to shift positive ions relative to negative ions. This is known as ionic polarization.
TRUE
FALSE

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a four variable K map eight adjacent cells give
single variable term
two variable term
three variable term
four variable term

⇒ EM 84 tube is used in radio receivers as
audio amplifier
RF amplifier
full wave rectifier
magic eye

⇒ TDM
can be used with PCM only
interleaves pulses belonging to different transmissions
combines five groups into a super group
stacks 24 channels in adjacent frequency slots

⇒ Which of the following instruments can be used for dc as well ac upto a few MHz?

Moving iron instrument
Thermocouple instrument
Induction instrument
Moving coil instrument

Select the correct answer as per following codes
2 only
2 and 3 only
1, 2 and 3 only
2 and 4 only

⇒ A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either short circuited or open circuited

⇒ (SI - A)^-1 = adj(sI - A)/det (sI - A)
TRUE
FALSE

⇒ When iron rod is magnetised by the flowing through its coil, the polarities of its different points wil
Pole A is N-pole, B is S-pole and C is neutral
A is N, B and C is S
A is N, C is S
A is S, C is neutral, B is N

⇒ Statement 1
Statement 1 is true but statement 2 is false
Statement 1 is false but statement 2 is true
Both the statements are true
Both the statements are false

⇒ For a BJT a = 0.98, then β =
0.02
0.5
4.9
48

⇒ A folded dipole antenna is conveniently connected to
shielded line
two wire line
coaxial line
flat ribbon type transmission line

⇒ In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
100 v
0 v
∞
- 100 v

⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only

⇒ The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W, respectively
35 A, 350 W, respectively
5 A, 250 W, respectively
11 A, 1210 W, respectively

⇒
Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.
Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k10¹⁰
10⁷
1.414 x 10^-10
2 x 10^-20

⇒ Which of the following DO statements is invalid in FORTRAN 77?
DO 161 = 1, 15
DO 16 1 = 1, 10, 1
DO 16 I = - 5, 5, 2
none of the above

⇒ For a photoengraving the mask used is
master mask
slave mask
working mask
photo mask

⇒ The advantage of FET over BJT is
high input impedance
lower noise
no thermal runaway
all of the above

⇒ Which chopper circuit operates in all the 4 quadrants?
A
C
D
E

⇒ A two branch parallel tuned circuits has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. The bandwidth is 200 radians/sec. A load of resistance R_L is connected in parallel. The new bandwidth will be
200 rad/sec
more than 200 rad/sec
less than 200 rad/sec
200 rad/sec or less

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math