Question is ⇒ The antenna most commonly used for TV broadcasting in the UHF band is, Options are ⇒ (A) turnstile antenna, (B) dipole antenna, (C) yagi antenna, (D) rhombic antenna, (E) , Leave your comments or Download question paper.

Question is ⇒ The antenna most commonly used for TV broadcasting in the UHF band is, Options are ⇒ (A) turnstile antenna, (B) dipole antenna, (C) yagi antenna, (D) rhombic antenna, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The antenna most commonly used for TV broadcasting in the UHF band is
A.	turnstile antenna [Wrong Answer]
B.	dipole antenna [Wrong Answer]
C.	yagi antenna [Correct Answer]
D.	rhombic antenna [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In low power factor wattmeter, the compensating coil is connected
in series with current coil
in parallel with current coil
in series with pressure coil
in parallel with pressure coil

⇒ n channel FETs are better as compared to p-channel FET because
they are more efficient
they have high switching time
they have higher input impedance
mobility of electrons is more than that of holes

⇒ A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is
64 K
16 K
8 K
4 K

⇒ For a 16 bit computer the range of integer constants in C is
-32768 to + 32767
-32767 to + 32768
-65536 to + 65535
-65535 to + 65536

⇒ Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz
30, 60 and 70 kHz
3, 6 and 7 kHz
30, 60 and 70 MHz
3, 6 and 7 GHz

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ In the circuit shown in the given figure, the current flowing through resistance of 100 Ω woul
8 mA
10 mA
20 mA
100 mA

⇒ If ROC of x[n] is R₁ then ROC of aⁿ x[n] is
R₁a
R₁/a
a/R₁
R₁ + a

⇒

Match the following:

	List I		List II
A.	h_ie	1.	siemens
B.	h_oe	2.	no units
C.	h_fe	3.	ohms

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-2, C-1

⇒ An n channel JFET has I_DS whose value is
maximum for V_GS = 0 and minimum for V_GS negative and large
minimum for V_GS = 0 and maximum for V_GS negative and large
maximum for V_GS = 0 and minimum for V_GS positive and large
minimum for V_GS = 0 and maximum for V_GS positive and large

⇒ For a wave propagating in air filled rectangular waveguide.
guide wavelength is never less than free space wavelength.
wave impedance is never less than the free space impedance
TEM mode is possible if the dimension of the waveguide are properly chosen.
propagation constant is a real quantity.

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ Two voltmeters are each 0-300 V range. Their internal resistances are 10 kΩ and 20 kΩ They are connected is series and a voltage of 400 V is applied. Their readings respectively will be
266.6 and 133.3 V
133.3 and 266.6 V
200 V each
100 and 300 V

⇒ Find I in 4 Ω resis
0.0416666666666667
0.5 A
0.75 A
0.95 A

⇒

Match the following:

	List I (VCR system)		List II (Azimuth angle)
A.	VHS	1.	7°
B.	Video 2000	2.	15°
C.	Betamax	3.	6°

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-1, C-2
A-3, B-2, C-1

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒

Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load.

Reason (R): A wattmeter measures apparent power.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ An RL series circuit has an impedance of 20 Ω when frequency is 25 Hz. At f= 50 Hz, the impedance will be
40 Ω
20 Ω
less than 40 W but more than 20 Ω
less than 20 W but more than 10 Ω

⇒ The drift velocity of electrons and holes is proportional to electric field strength.
TRUE
FALSE

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV

⇒

Assertion (A): An inverter does not require forced commutation

Reason (R): A series inverter is a forced commutation inverter.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ R.M.S. value of the waveform shown wil
3.53 V
1 V
7.07 V
8.56 V

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will accumulator (A) and carry (CY) contain after ANA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ What happens when a paramagnetic material is heated above Curie temperature?
It becomes diamagnetic
It becomes nonmagnetic
It becomes ferromagnetic
It becomes anti-ferromagnetic

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ A cascade amplifier stage is equivalent to
common emitter stage followed by a common base stage
common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒ The block diagram of AM transmitter in which high level modulation is used as shown in figure. The block X could
audio power amplifier
buffer RF amplifier
compressor amplifier
none of the above

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped

⇒ The volt ratio box is basically a
potential divider
current transformer
a high resistance voltmeter
either (a) or (c)