Question is ⇒ The effect of current shunt feedback in an amplifier is to, Options are ⇒ (A) increase the I/P resistance and decrease the O/P resistance, (B) increase both I/P and O/P resistance, (C) decrease both I/P and O/P resistance, (D) decrease the I/P resistance and increase O/P resistance, (E) , Leave your comments or Download question paper.

Question is ⇒ The effect of current shunt feedback in an amplifier is to, Options are ⇒ (A) increase the I/P resistance and decrease the O/P resistance, (B) increase both I/P and O/P resistance, (C) decrease both I/P and O/P resistance, (D) decrease the I/P resistance and increase O/P resistance, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The effect of current shunt feedback in an amplifier is to
A.	increase the I/P resistance and decrease the O/P resistance [Wrong Answer]
B.	increase both I/P and O/P resistance [Wrong Answer]
C.	decrease both I/P and O/P resistance [Wrong Answer]
D.	decrease the I/P resistance and increase O/P resistance [Correct Answer]
View Answer 8 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Magnetic tape can be accessed only sequentially.

Reason (R): Magnetic tape consists of magnetised spots or tracks.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): From the slope of the line in Figure, we can find permanent dipole moment of the molecules.

Reason (R): Total polarization of a polyatomic gas is given by P = N(a_e + a_i + μ²_p / 3kT
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A resistance and an inductance are connected in parallel and fed from 50 Hz ac mains. Each branch takes a current of 5 A. The current supplied by source is
0.416666666666667
7.07 A
0.208333333333333
zero

⇒ KCL is a statement of principle of conservation of energy.
TRUE
FALSE

⇒ The secondary lobes in binomial arrays can be reduced by
maintaining spacing between two consecutive radiating sources less than λ/2
maintaining the amplitudes in radiating sources, from outer towards the centre source, proportional to the coefficients of the successive terms of the binomial series
both (a) and (b)
none of the above

⇒ Decimal number 9 in gray code =
1100
1101
110
1111

⇒ Measurement of non-electrical quantity involves the following subsystems

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒ Which of the following is/are not a property/properties power spectral density function Sx(ω)?
Sx(ω) is real function of ω
Sx(ω) is a even function of ω
Sx(ω) is non-positive function of ωSx(ω) ≤ 0 for all ω
All of the above

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Noise with uniform power spectral density of N₀ω/H_z is passed through a filter H(ω) = 2 exp (-J ω t_y) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is
2 N₀B
4 N₀B
8 N₀B
16 N₀B

⇒ A permeable substance is one
which is strong magnet
which is a weak magnet
which is a good conductor
through which magnetic lines of force can pass easily

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ In Fermi-Dirac statistics, the probability of electron occupation of an energy level equal to Fermi level is
0
0.25
0.5
1

⇒ The most important set of specifications of transformer oil includes
dielectric strength and viscosity
dielectric strength and flash point
flash point and viscosity
dielectric strength, flash point and viscosity

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ An open coil has
zero resistance and inductance
zero resistance and high inductance
infinite resistance and zero inductance
infinite resistance and normal inductance

⇒ One electron volt is equivalent to
1.6 x 10^-10 joule
1.6 x 10^-13 joule
1.6 x 10^-16 joule
1.6 x 10^-19 joule

⇒ A 3-digit voltmeter having a resolution of 100 mV can be used to measure a maximum of
100 V
200 V
1000 V
5000 V

⇒ During testing of an energy meter, the energy recorded by meter was 0.05 kWh and correct energy was found to be 0.09 kWh. The error and correction respectively are
-0.01 kWh and 0.01 kWh
0.01 kWh and -0.01 kWh
-0.01 kWh and ± 0.01 kWh
± 0.01 kWh and 0.01 kWh

⇒ A transmission line having 50 Ω impedance is terminated in a load of (40 + j 30) Ω. The VSWR is
j 0.033
0.8.+ j 0.6
1
2

⇒ Which of the following is non-saturating?
TTL
CMOS
ECL
Both (a) and (b)

⇒ Assume that op-amp in figure is ideal. If input V_i is triangular, the output V₀ wil
square wave
sine wave
triangular wave
parabolic wave

⇒ On which of the following effect do thermocouples work?
Thomson effect
Seeback effect
Peltier effect
Joule effect

⇒ A series R-L circuit has R = 1 Ω and L = 1 H. It is excited by a V battery at t = 0. The steady state condition is reached at
t = 1 s
t = 0.1 s
t = 0 s
t = ∞

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ For the amplifier in figure, β = 800. The mid-band voltage gain V₀/V_{i0
< 1
≈ 1
800}

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ The voltage applied to an R-L circuit at t = 0 when switch is closed is 100 cos (100 t + 30°). The circuit resistance is 80 Ω and inductance is 0.6 H (in which initial current is zero). What is the maximum amplitude of current flowing through the circuit?
0.0416666666666667
0.0833333333333333
0.208333333333333
0.416666666666667

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder