Question is ⇒ Consider the following statement S1 and S2</su, Options are ⇒ (A) S1 is False, S2 is true, (B) S1 and S2 both are true, (C) S1 and S2 both are false, (D) S1 is true, S2 is false, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider the following statement S1 and S2</su, Options are ⇒ (A) S1 is False, S2 is true, (B) S1 and S2 both are true, (C) S1 and S2 both are false, (D) S1 is true, S2 is false, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider the following statement S₁ and S₂
A.	S₁ is False, S₂ is true [Wrong Answer]
B.	S₁ and S₂ both are true [Wrong Answer]
C.	S₁ and S₂ both are false [Wrong Answer]
D.	S₁ is true, S₂ is false [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a negative feedback amplifier A = 100, β = 0.04 and V_s = 50 mV, then feedback will be
4
8
10
2

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒ Which 8085 instruction causes exchange of contents of stack pointer with the contents of H L register pair?
XTHL
PCHL
LHLD
MVIA

⇒ Accumulator is an 8 bit register and is also known as register B.
TRUE
FALSE

⇒ Antenna efficiency of antenna is, if radiation resistance is 370 Ω and loss resistance is 100 Ω
0.8
0.87
0.78
0.2127

⇒ Which of the following effects is used in measurement of magnetic flux?
Hall effect
Seeback effect
Piezo electric effect
Photoelectric effect

⇒ Bellows converts
pressure difference into displacement
pressure difference into voltage
displacement into pressure difference
either (a) or (c)

⇒

Assertion (A): If power gain doubles the power gain increases by 3 dB

Reason (R): The bel power gain of cascaded stages is equal to sum of each bel power gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An amplitude modulated signal occupies a frequency range from 395 kHz to 405 kHz. If can be demodulated by which of the following?
Using an envelope detector and filter
Multiplying with a 395 kHz local signal
Multiplying with a 405 kHz local signal
Low pass filtering with cut off at 400 kHz

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
648 bits
786432 bits
144 bits

⇒ In CE approximation, the upper end of d.c. load line is called the __________ point and the lower end is the __________ point.
Q, base
base, Q
saturation, cut off
cut off, saturation

⇒ In a Weston synchronoscope the deflecting torque is zero when
currents in fixed and moving coils are in phase
currents in fixed and moving coils are out of phase by 90°
currents in fixed and moving coils are out of phase by 60°
none of the above

⇒

Assertion (A): In C it is possible for functions to call themselves.

Reason (R): C makes use of 'Pointers'.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Energy content of atmospheric noise
does not depend on frequency
decreases as frequency is increased
increases as frequency is increased
either (a) or (c) depending on the temperature

⇒ Electric dipole is located at origin in a medium with ε_r = 6, has a moment P = (4a_x - 2a_y + a_z ) nC. Then potential at (2, 4, 4) is:
0.062
0.027
0.042
0.072

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ In figure, the switch is initially open. At t = 0 switch is closed. v_c (0⁺) and i_L (0⁺)
60 V and - 0.3 A
150 V and zero
zero and 0.3 A
90 V and - 0.3 A

⇒ In a series inverter
the commutating elements carry full load current
the commutating elements carry upto 50% of load current
the commutating elements do not carry load current
any of the above

⇒ In a conventional AM superhetrodyne receivers, the detectors employed to extract intelligence include
Peak detectors
Ratio detectors
PLL
Slope detectors

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ The M circle for M = 1 is the
straight line at x = - 0.5
critical point (-l, jo)
circle with r = 0.33
circle with r = 0.67

⇒ In the above circuit, if the power dissipated in the 6 Ω resistor is zero then
20 2∠ 45°
20 ∠ 30°
20 ∠ 45°
20 2∠ 30°

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒ High frequency waves are
absorbed by the F₂ layer
reflected by the D layer
affected by the solar cycle
none of the above

⇒ Which one of the following statements is wrong. The radar cross-section of a target?
depends on frequency
may be reduced by special coating of non-spherical target
depends on the aspect of target if it is non-spherical
is equal to actual cross-sectional area for small targets

⇒ A XOR gate has inputs A and B and output Y. Then the output equation is
Y = AB
Y = AB + A B
Y = A B + A B
Y = A B + A B

⇒ The current wave in figure is passed through 3 H inductor. The voltage across inductance during the period 2 < t < 3 second
12 V
- 12 V
6 V
- 6 V

⇒ For measurement of surface temperature of solids the elements of RTD is usually in the shape of
bar
coil
flat grid
either (a) or (b)

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ Which of the following describe the correct properties of an emitter follower circuit?

It is a voltage series feedback circuit.
It is a current series feedback circuit.
Its voltage gain in less than unity.
Its output impedance is very low.

Select the correct answer from the codes given below:
1, 3 and 4
2, 3 and 4
2 and 3 only
2 and 4 only