Question is ⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 1012 cm-3. Density of electrons = 8 x 1013 cm-3, mobility of conduction electron = 2.3 x 104 cm2/ V-sec and mobility of holes = 100 cm2/V-sec., Options are ⇒ (A) 0.43 Ω-m, (B) 0.34 Ω-m, (C) 0.42 Ω-m, (D) 0.24 Ω-m, (E) , Leave your comments or Download question paper.

Question is ⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 1012 cm-3. Density of electrons = 8 x 1013 cm-3, mobility of conduction electron = 2.3 x 104 cm2/ V-sec and mobility of holes = 100 cm2/V-sec., Options are ⇒ (A) 0.43 Ω-m, (B) 0.34 Ω-m, (C) 0.42 Ω-m, (D) 0.24 Ω-m, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
A.	0.43 Ω-m [Wrong Answer]
B.	0.34 Ω-m [Correct Answer]
C.	0.42 Ω-m [Wrong Answer]
D.	0.24 Ω-m [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The first geostationary satellite launched in 1965 was called
ANIK
EARLY BIRD (Intelsat-I)
WESTAR
MOLNIYA

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ Tape recorders use
cone type loudspeakers
horn type loudspeakers
either cone type or horn type loudspeakers
none of the above

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts
23.7 mA
14.2 mA
13.7 mA
24.2 mA

⇒ The circuit of figure give an output which
a frequency modulated signal
an amplitude modulated signal
a phase modulated signal
none of the above

⇒ For a symmetrical network
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ z₂₂ and z₁₂ = z₂₁
z₁₁ z₁₂ - z₁₂² = 0

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒ In figure, I_D = 4 mA. Then V_{DS20 V
16 V
4 V
0.4 V}

⇒ In an ac circuit, the maximum and minimum values of power factor can be
2 and 0
1 and 0
0 and -1
1 and -1

⇒ In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will
be reduced by half
be doubled
be four times as high
be reduced to one fourth

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ In order to achieve accuracy, the slide wire of a potentiometer should be
as long as possible
as short as possible
neither too long nor too short
very thin

⇒ The binary number 101100.110 in octal number will be
152.6
154.6
145.6
174.6

⇒ Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than
500 V
400 V
375 V
250 V

⇒ If a system is to follow arbitrary inputs accurately the bandwidth should be
large
small
very small
neither small nor large

⇒ In a three variable K map four adjacent cells give
single variable term
two variable term
three variable term
either (a) or (b)

⇒ Which of the following is likely to be associated with FM radio broadcasting?
90 Hz
90 kHz
900 kHz
90 MHz

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a digital voltmeter the oscillator frequency is 400 kHz and the ramp voltage falls from 8 V to 0 V in 20 ms. What is the number of pulses counted by the counter?
800
2000
4000
8000

⇒ In a CE amplifier the output coupling capacitor is short circuited. The dc collector voltage
will increase
may increase or decrease
will remain the same
will decrease

⇒ In a cycloconverter it is possible to vary
only output frequency
only output voltage
both output voltage and frequency but not simultaneously
both output voltage and output frequency simultaneously

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ Least expensive logic
RTL
DTL
TTL
ECL

⇒ What is the effect of cut in voltage on the wave form of output as compared to input in a semiconductor diode?
The duration of output waveform is less than 180°
Output voltage is less than input voltage
Output voltage is more than input voltage
Both (a) and (b)

⇒ The standard FORTRAN exponential form of decimal number - 0.000000023 is
2.3 E - 8
-2.3 E - 8
2.3 E - 7
-2.3 E - 7

⇒ The resolution of a wire wound potentiometer is about
0.00001
0.001
0.01
0.05

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ Occasionally a discrete amplifier user RF chokes instead of collector resistors. Such amplifiers are inherently
low pass amplifiers
high pass amplifiers
band pass amplifiers
none of the above