Question is ⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about, Options are ⇒ (A) 0.02, (B) 0.1, (C) 0.2, (D) 0.4, (E) , Leave your comments or Download question paper.

Question is ⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about, Options are ⇒ (A) 0.02, (B) 0.1, (C) 0.2, (D) 0.4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a platinum RTD, the change in resistance for a temperature rise of 50° C is about
A.	0.02 [Wrong Answer]
B.	0.1 [Wrong Answer]
C.	0.2 [Correct Answer]
D.	0.4 [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The polar plot for positive frequencies is shown below. The gain margi
- 8.02 dB
6.02 dB
5 dB
none of these

⇒ An ideal op-amp has
infinite input and output resistance
low input and output resistance
low input and high output resistance
infinite input resistance and zero output resistance

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒

Assertion (A): A small section of high impedance line is equivalent to a series inductance.

Reason (R): A small section of a low impedance line is equivalent to a series resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ The reactance of coupling capacitors, for DC quantities, is
zero
low
infinite
zero or low

⇒ Commercial Frequency deviation of FM is
70 kHz
75 kHz
80 kHz
65 kHz

⇒ For stable network the real parts of poles and zeros of driving point functions must be
negative
negative or zero
zero
positive

⇒ Which is not a software?
DOS
Windows
MS WORD
Hard disk

⇒ In a dynamometer instrument, the moving coil is pressure coil.
TRUE
FALSE

⇒ If the current in a capacitor leads the voltage by 80°, the loss angle of capacitor is
80°
10°
100°
170°

⇒ In the circuit of figure β = 100 and quiescent value of base current is 20 μA. The quiescent value of colle
0.2 μA
2 μA
2 mA
20 mA

⇒ Which of the following statement is false?
A half-wave dipole is a resonant antenna
A horizontal antenna transmits radio signal with horizontal polarization
The field strength of 200 mV/m will produced 200 μV of signal in an antenna 2 m long
All of the above

⇒ Which one of following is a stataic system?
y(n) = x(n) - x(n - 1)
y(n) = x(2n) - x(2n-1)
y(n) = x(n - 1)
y(n) = e^x(n)

⇒ The slew rate of an ideal op-amp is
very slow
slow
fast
infinitely fast

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ If E is energy level of electron and E_F is fermi level, and T = 0 and E > E_F, then
the probability of finding an occupied quantum state of energy higher than E_F is zero
all quantum states with energies greater than E_F are occupied
some quantum states with energies greater than E_F are occupied
majority of quantum states with energies greater than E_F are occupied

⇒ In a sine wave, maximum rate of change of voltage occurs at
ascent of the waveform
+ ve maximum
- ve maximum
between maximum and minimum

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ Calculate the stability factor and change in I_c from 25°C to 100°C for, β = 50, R_B/R_E = 250, ΔI_CO = 19.9 nA for emitter bias configuration
42.553, 0.85 μF
40.91, 0.58 μF
38.53, 0.85 μF
41.10, 0.39 μF

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ Maximum power transfer theorem is applicable to circuits with one source only.
TRUE
FALSE

⇒ Which of the following instruments is used almost exclusively to measure radio frequency currents?
Moving coil
Rectifier
Moving iron
Thermocouple

⇒ Each cell of a static Random Access memory contains
6 MOS transistor
4 MOS transistor, 2 capacitor
2 MOS transistor, 4 capacitor
1 MOS transistor and 1 capacitor

⇒ The impurity added to extrinsic semiconductor is of the order of
1 in 100
1 in 1000
1 in 100, 0000
1 in 100, 000, 000

⇒ Secondary emission results
when temperature of metals is raised to a level above the crystallization temperature
when metals are subjected to strong magnetic fields
when light rays fall on the metal surface
when a high velocity beam of electrons strikes as metal surface

⇒ In amplitude modulation, carrier signals A cos ωt has its amplitude A modulated in proportion with message bearing (low frequency) signal m(t). The magnitude of m(t) is chosen to be __________ .
less than 1
less than or equal to 1
more than 1
none of these

⇒ A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
20 ∠20° A
10 ∠20° A
14.14 ∠20° A
10 ∠- 20° A

⇒ Negative feedback is used in audio amplifiers to
operate class C
reduce distortion
increase distortion
increase gain

⇒ In radar system which of the following is called A scope
deflection modulation of CRT
intensity modulation of CRT
computer display
none of the above