Question is ⇒ Which type of modulator amplifier is used in AM transmitter?, Options are ⇒ (A) Class A, (B) Class B, (C) Classes AB, (D) Class C with negative feedback, (E) , Leave your comments or Download question paper.

Question is ⇒ Which type of modulator amplifier is used in AM transmitter?, Options are ⇒ (A) Class A, (B) Class B, (C) Classes AB, (D) Class C with negative feedback, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which type of modulator amplifier is used in AM transmitter?
A.	Class A [Wrong Answer]
B.	Class B [Wrong Answer]
C.	Classes AB [Wrong Answer]
D.	Class C with negative feedback [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The constant magnitude of G(s) plane are
a family of straight horizontal lines
a family of straight inclined lines with positive slope
a family of straight inclined lines with negative slope
a family of circles

⇒ In anti-ferromagnetic materials, the graph of susceptibility versus temperature shows a sharp maximum at a certain temperature. This temperature is known as
Curie temperature
Neel temperature
Weiss temperature
Bitter temperature

⇒ An electron rises through a voltage of 100 V. The energy acquired by it will be
100 eV
100 joules
(100)^1.2 eV
(100)^1.2 joules

⇒ An iron specimen has µ_r = 1000 when B = 0.3 T. If B = 0.35 T, µ_r
will be 1000
will be less than 1000
will be more than 1000
may be more or less than 1000

⇒ For a quadratic factor in denominator of transfer function the phase angle at corner frequency (in Bode phase angle plot)
is -90°
is +90°
depends on the damping factor
none of the above

⇒ To ensure that a zener diode does not get destroyed
the applied voltage should not exceed breakdown voltage
the current should not exceed rated current
the current should be less than magnitude of barrier potential
both (a) and (b)

⇒ A 3 phase series inverter has
12 thyristors
6 thyristors
3 thyristors
3 or 6 thyristors

⇒ The resonance frequency is
ω_r = a
ω_r = b
ω_r = k
ω_r = ba

⇒ The symbol in figure is
SUS
SBS
Shockley diode
UJT

⇒ A continuous time LTI system is describe
(e^t - e^3t) u(t)
(e^-t - 3e^-3t) u(t)
(e^-t + e^-3t) u(t)
(e^t + e^3t) u(t)

⇒ For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as
2E
3E
4E
6E

⇒ The probability density function of the envelope of narrow band noise is :
Uniform
Gaussian
Rayleigh
None

⇒ A crowbar circuit is generally needed for protection under fault conditions.
TRUE
FALSE

⇒ The configuration of figure
Hartley oscillator
Precision Integrator
Wienbridge oscillator
Butterworth high pass filter

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒ A potential of 7 V is applied to a silicon diode. A resistance of 1 K ohm is also in series with the diode. The current is
7 mA
6.3 mA
0.7 mA
0

⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above

⇒ The poles with greater displacement from the real axis correspond to
higher frequencies of oscillations
stable response
lower frequencies of oscillations
unbounded output

⇒ In a JFET, the lower end is called the __________ and the upper end is called the __________ .
source, channel
channel, drain
source, drain
drain source

⇒ ALU processes
decimal numbers
binary numbers
hexadecimal numbers
all of the above

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒ The following circuit is implementation of:

sum of full adder

carry of half adder

difference of full subtractor

1 only
3 only
2 only
1 and 2 both

⇒ Which of the following is not an electromagnetic device?
Hall transducer
Transformer
Speedometer
Eddy current damping device

⇒ In the TTL circuit in the figure, S₂ to S₀ are select lines and X₇ to X₀ are input lines. S₀ and X₀ are LSBs. The output
Indeterminate
A ⊕ B
A ⊕ B
C . A ⊕ B + C . (A ⊕ B)

⇒ A virtual ground is a ground for
voltage
current
both voltage and current
voltage but not for current

⇒ A line of characteristic impedance 400 Ω is terminated by a resistance of 400 Ω. The reflected quantities are
zero
equal to incident quantities
half the incident quantities
double the incident quantities

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ A Schottky diode clamp is used along with a switching BJT for
reducing the power
reducing the switching time dissipation
increasing the value of β
reducing the base current

⇒ In the design of a single mode step index optical fiber close to upper cut-off, the single mode operations is NOT preserved if
radius as well as operating wavelength are halved
radius as well as operating wavelength are doubled
radius is halved and operating wavelength is doubled
radius is doubled and operating wavelength is halved