Question is ⇒ Which one of the following power amplifier has the maximum efficiency?, Options are ⇒ (A) Class A, (B) Class B, (C) Class AB, (D) Class C, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following power amplifier has the maximum efficiency?, Options are ⇒ (A) Class A, (B) Class B, (C) Class AB, (D) Class C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following power amplifier has the maximum efficiency?
A.	Class A [Wrong Answer]
B.	Class B [Wrong Answer]
C.	Class AB [Wrong Answer]
D.	Class C [Correct Answer]
View Answer 5 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Octal 16 is equal to decimal
13
14
15
16

⇒

Assertion (A): In CE amplifier the emitter is at ground potential for ac signals

Reason (R): A CE amplifier has near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I		List II
A.	CTFS	1.	Periodic
B.	DTFS	2.	Non-periodic
C.	CTFT
D.	DTFT

A-2, B-1, C-2, D-2
A-2, B-1, C-2, D-1
A-1, B-2, C-2, D-2
A-1, B-2, C-2, D-1

⇒ In 8085 microprocessor, if instruction RST is written in a program then the program will jump to location
0020 H
0024 H
0028 H
002 CH

⇒ Inverter 74 LS04 has following specifications I_0H max = - 0.4 mA, I_{0L max} = 8 mA, I_{IH max} = 20 μA, I_{IL max} = 0.
10
20
60
100

⇒ Which of the following is not an internal DOS command?
VER
COPY
MEM
DATE

⇒ The units for apparent power are watts.
TRUE
FALSE

⇒ (1111.11)₂ is
(1.01)₁₀
(0.75)₁₀
(15.3)₁₀
(15.75)₁₀

⇒ As compared to TTL, CMOS logic has
higher speed of operation
higher power dissipation
smaller physical size
all of the above

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ Signal to noise ratio of microphone is defined as the ratio of output when the sound pressure is __________ to the output in the absence of any sound signal.
0.5 Pa
0.2 Pa
0.1 Pa
0.01 Pa

⇒ Surge current rating of an SCR is
the maximum repetitive surge current in which the SCR can withstand
the maximum non-repetitive surge current in which the SCR can withstand
the maximum repetitive or non repetitive surge current in which the SCR can withstand
the maximum surge current in which the SCR can withstand if both surge current and steady current exist together

⇒ Specific resistance of silver is about
0.16 x 10^-8 Ω-m
1.64 x 10^-8 Ω-m
16 x 10^-8 Ω-m
164 x 10^-8 Ω-m

⇒ The transfer function G₁₂ (s) for a two port is
V₂/V₁
V₂ (s)/V₁ (s)
V₂ (s)/I₁ (s)
I₂ (s)/I₁ (s)

⇒ In figure I_D = 4 mA. Then V_{S20 V
4.4 V
0.4 V
0.44 V}

⇒ In using mesh current method it is necessary that at least one mesh current links every element.
TRUE
FALSE

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒ In a second order system ω_n = 10 rad/sec and ζ = 0.1, then ω_d =
9.1 rad/sec
9.95 rad/sec
9 rad/sec
1 rad/sec

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The INTELSAT-IV satellite launched in 1974 had two earth coverage antenna and two narrower-angle antennas subtending 4.5°. The signal from narrow-angle antenna was stronger than that from earth- coverage antenna by a factor of
17.34/4.5
17.34 x 4.5
(17.34/4.5)²
(17.34/4.5)⁴

⇒ A device which converts BCD to seven segment is called
encoder
decoder
multiplexer
none of these

⇒

Assertion (A): Both sodium and ferrous are ferromagnetic.

Reason (R): Both sodium and ferrous have body centred cubic structure.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with ε_r = 4. The reflection coefficient for the normal incidence is
zero
0.5 ∠180°
0.33 ∠0°
0.33 ∠180°

⇒ Radio broadcasts are generally
amplitude modulation
frequency modulation
both amplitude and frequency modulation
neither amplitude nor frequency modulation

⇒ A 'n' bit sequence generator employing SR flip-flop has maximum length of the sequence as :
2ⁿ
n
2ⁿ - 1
2ⁿ^-1

⇒ The channel of JFET consists of
p type material only
n type material only
conducting material
either p or n type material

⇒ Which of the following statement regarding link loss for a satellite is wrong?
For fixed antenna, it is inversely proportional to f²
For fixed frequency, it is inversely proportional to the product of the antenna aperture areas
For a given satellite operating at a given frequency, it is inversely proportional to
Loss in down-link is negligible as compared to that in uplink