Question is ⇒ In AM, if modulation index is more than 100%, then, Options are ⇒ (A) bandwidth increases, (B) the wave gets distorted, (C) power of the wave increases, (D) efficiency of transmission increases, (E) , Leave your comments or Download question paper.

Question is ⇒ In AM, if modulation index is more than 100%, then, Options are ⇒ (A) bandwidth increases, (B) the wave gets distorted, (C) power of the wave increases, (D) efficiency of transmission increases, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In AM, if modulation index is more than 100%, then
A.	bandwidth increases [Wrong Answer]
B.	the wave gets distorted [Correct Answer]
C.	power of the wave increases [Wrong Answer]
D.	efficiency of transmission increases [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a mod-12 counter the input clock frequency is 10 kHz. The output frequency is
0.833 kHz
1.0 kHz
0.91 kHz
0.77 kHz

⇒ A sine wave of voltage varies from zero to maximum of 200V. How much is the voltage at the instant of 30° of the cycle?
50 V
82.8 V
100 V
173.2 V

⇒ If load impedance Z_L >> Z₀, then
Z₀ = Z_L (VSWR)
Z_L = Z₀ (VSWR)
Z_L = Z₀ (VSWR - 1)
Z_L = Z₀ VSWR

⇒ When two port networks are connected in cascade, it is more convenient to use hybrid parameters.
TRUE
FALSE

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ A gate function which occurs at t = t₀ and lasts for duration T can be written as
u (t - t₀ - T)
u(t - t₀) = u(t - t₀ - T)
u(t - t₀) - u(t - t₀ - T)
u(t - t₀) - u(t - t₀ + T)

⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz

⇒ What are the contents of the accumulator after the RIC has been executed?
40 H
41 H
42 H
43 D

⇒ Which modes of circular wave guides have circular symmetry?
TE₁₁
TE₁₁ and TE₂₁
TE₀₁
TE₀₁ and TM₀₁

⇒ Which one of the following is a passive device/Component?
Transformer
Oscillator
Generator
None

⇒ The effective length of an λ/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.13 λ² and η = 120 p is __________ .
0.6348 λ
0.317 λ
0.158 λ
0.371 λ

⇒ A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?
R₀ = 1110 0010
R₁ = 0101 0111
R₂ = 0011 1100
R₃ = 1011 1111

⇒ The scale of hot wire ammeter is
linear
non-linear
cramped
absolute linear

⇒ In low pass filter of figure R₀ = 1 Ω and cut off frequency is 1 rad/sec. The values of L and C
1 H and 2 F
1 H and 1 F
2 H and 1 F
1 H and 2 F

⇒ Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz
30, 60 and 70 kHz
3, 6 and 7 kHz
30, 60 and 70 MHz
3, 6 and 7 GHz

⇒ The most noise resistant modulation system is
PCM
SSB suppressed carrier
FM
pulse position modulation

⇒ The residual resistivity of a binary alloy at 0°K is
the sum of the residual resistivities of the component metals
the difference of the residual resistivities of the component metals
the product of the residual resistivities of the component metals
depend on the concentration of the minor component in the alloy

⇒ An electrostatic voltmeter is suitable for
low voltage at high frequency
high voltage
low voltage at low frequency
all ac and dc voltages

⇒ In a JK flip flop toggle means
set Q = 1 and Q = 0
set Q = 0 and Q = 1
change the output to the opposite state
no change in output

⇒ Magnetic effect of current is used in generators but not in motors.
TRUE
FALSE

⇒ A Read/Write memory chip has a capacity of 64 k bytes. Assuming separate data and address line and availability of chip enable signal, what is the minimum number of pins required in the IC chip?
28
26
24
22

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ In a reverse biased P-N junction, the current through the junction increases abruptly at
zero voltage
1.2 V
0.72 V
breakdown voltage

⇒ Which of the following memories normally has highest storage capacity?
Magnetic disc
Magnetic tape
Semiconductor memory
Core memory

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ A padder is basically a/an
insulator
variable resistor
capacitor
inductor

⇒ Find the Fourier transform of the half cosine pulse as shown bel
0.5 {sin c [0.25(f - 1)] + sin c [2.5(f + 1)]}
0.5 {sin c [0.5(f - 1)] + sin c [0.5(f + 1)]}
0.25 {sin c [0.25(f - 1)] + sin c [0.25 (f - 1)]}
0.25 {sin c [0.5(f - 1)] + sin c [0.5(f - 1)]}

⇒ The circuit of figure is generally employed
bridge
low-pass filter
peaking network
high-pass filter

⇒ System satellites orbit the Earth once in
24 hours
12 hours
1 hours
6 hours

⇒ In an air cored coil, a current of 0.7 A causes a flux of 5 x 10^-6 Wb. If the core is made of cast iron and the coil is similar, the same current can set up a flux of about
5 x 10^-6 Wb
5 x 10^-8 Wb
10^-2 Wb
5 x 10^-4 Wb