Question is ⇒ Greatest mobility can be expected in case of, Options are ⇒ (A) holes, (B) protons, (C) electrons, (D) negative ions, (E) , Leave your comments or Download question paper.

Question is ⇒ Greatest mobility can be expected in case of, Options are ⇒ (A) holes, (B) protons, (C) electrons, (D) negative ions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Greatest mobility can be expected in case of
A.	holes [Wrong Answer]
B.	protons [Wrong Answer]
C.	electrons [Correct Answer]
D.	negative ions [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is
[0, - 2 + 2j, 2, - 2 - 2j]
[2, 2 + 2j, 6, 2 - 2j]
[6, 1 - 3j, 2, 1 + 3]
[6, - 1 + 3j, 0, - 1 - 3j]

⇒ For the logic circuit of the given figure the simplified Boolean expression
A ⊕ B
A + B
AB
A + B

⇒ Which of the following is the disadvantage of PDM and PPM?
It requires pulses of larger widths
More samples are needed per second
More powerful transmitter is required
None of the above

⇒ A diode detector load consists of 0.01 μF capacitor in parallel with a 5 k ohms resistor. The maximum depth of modulation without diagonal clipping at modulating frequency of 1000 Hz and 10 kHz is
0.76, 0.24
0.95, 0.3
0.24, 0.76
0.3, 0.95

⇒ A switch tail ring counter is made by using a single D FF. The resulting circuit is a
SR FF
JK FF
D FF
T FF

⇒

Assertion (A): Secondary instruments require calibration at frequent intervals.

Reason (R): Secondary instruments have many errors.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Beamwidth of an antenna depends upon
shape of radiation pattern
dimensions
wavelength
all of the above

⇒ Which statement is true for an ac circuit?
Active power is always less than apparent power
Active power cannot be more than apparent power
Active power is always more than reactive power
Active power cannot be more than reactive power

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ The term __________ applies to troposcatter propagation
fading
Faraday rotation
SIDS
atmospheric storms

⇒

Assertion (A): Two equal and opposite travelling waves result in a standing wave.

Reason (R): The ratio of maximum to minimum value of a standing wave is called SWR.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
ω₁ = ω₀ + bandwidth
ω₁ = ω₀ + 0.5 (bandwidth)
ω₁ = ω₀ - 0.5 (bandwidth)
ω₁ = ω₀ + bandwidth

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒ The permeability of soft iron can be increased by
purifying it
reducing carbon percentage
alloying with cobalt
increasing percentage

⇒ Which of the following statements about the matched filter in a communication receiver are correct?

Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.

Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒ In JK flip flop toggle state exists if
J = 0, K = 1
J = 1, K = 0
J = 0, K = 0
J = 1, K = 1

⇒ For transistor 2 N 338 the manufacturer specifies P_max = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
10° C/W
100° C/W
1000° C/W
5000° C/W

⇒ In 2's complement representation, a certain negative number - N is 1011. The representation for + N is
100
101
110
11

⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt²
volt/sec
volt-sec

⇒ A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is
10 Ω
(6.9 + j 7.24) Ω
(1.75 + j 3.098) Ω
(2 - j 5) Ω

⇒ The switching expression corresponding
C D + B C
C ⊙ D
C ⊕ D
CD

⇒ The total number of leads in SUS, SBS and SCS respectively are
3, 3, 4,
3, 3, 3
2, 3, 3
3, 3, 5

⇒ The reading of the voltmeter in figure will be __________ v
100
150
zero
200

⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
5/δ
Intermediate
δ/5
δ

⇒

Assertion (A): When the phase margin of a control system is improved using a lead network, noise transmission increases.

Reason (R): Phase lead compensation increases bandwidth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A unity feedback system has the following open loop frequency resp
0 dB, -17°
3.86 dB, -180°
0 dB, 10°
3.86 dB, 10°

⇒ Geosynchronous satellites are always launched in the equatorial plane because it is the only plane which provides
24-hour orbit
stationary satellite
global communication
zero-gravity environs

⇒ In an ac series RLC circuit the maximum phase difference between any two voltages can be
90°
45°
- 90°
180°

⇒ The transient currents are due to
resistance of the circuit
impedance of the circuit
voltage applied to the circuit
changes in stored energy in inductors and capacitors

⇒ An air gap provided in the iron core of an inductor prevents
flux leakage
hysteresis loss
core saturation
heat generation