Question is ⇒ Which of the following is best suited for parity checking and parity generation?, Options are ⇒ (A) AND, OR, NOT gates, (B) XOR, Exclusive NOR gate, (C) NAND gates, (D) NOR gates, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is best suited for parity checking and parity generation?, Options are ⇒ (A) AND, OR, NOT gates, (B) XOR, Exclusive NOR gate, (C) NAND gates, (D) NOR gates, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is best suited for parity checking and parity generation?
A.	AND, OR, NOT gates [Wrong Answer]
B.	XOR, Exclusive NOR gate [Correct Answer]
C.	NAND gates [Wrong Answer]
D.	NOR gates [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following antenna is obtained by modifying a waveguide?
Microstrip Antenna
Helical Antenna
Horn Antenna
Dipole Antenna

⇒ To determine the polarity of voltage drop across a resistor, it is sufficient to know
direction of current through the resistor
direction and magnitude of current through the resistor
direction and magnitude of current and value of resistance
magnitude of current through the resistance

⇒

Assertion (A): For an underdamped system with damping ratio ξ, the maximum overshoot is e-ξp/(1-ξ²)^0.5

Reason (R): Peak time of a second order under damped system = p/ω_d where ω_d is frequency of damped oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A tachometer has a sensitivity of 4 V/1000 rpm. Express the gain constant of the tachometer in the units volts/(rad/sec).
0.0489
0.0381
2
none of these

⇒ The resolution of a 12-bit D/A converter using a binary ladder with + 10V as the full scale output will be
2.44 mV
3.50 mV
4.32 mV
5.12 mV

⇒ In MF range, increasing the transmitter power
increases the range of transmitter
does not increase the range of transmitter because propagation is limited by tilt
decreases the range of transmitter because propagation is limited by tilt
increases the range of transmitter because propagation is through space waves

⇒ Integral error compensation changes a second order system to
first order system
third order system
fourth order system
either (a) or (b) depending on the system

⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate
12000 bps
1000 bps
6000 bps
3000 bps

⇒ The current wave in figure is passed through 3 H inductor. The voltage across inductance during the period 2 < t < 3 second
12 V
- 12 V
6 V
- 6 V

⇒ Twelve resistance each 2 ohm are connected to form a cube, one resistance being in each arm of cube. The resistance between any two diagonally opposite comers is
1 Ω
2 Ω
4 Ω
8 Ω

⇒ The mean free path of conduction electrons in copper is about 4 x 10^-8 m. For a copper block, find the electric field which can give, on an average, 1 eV energy to a conduction electron
2.62 x 10⁷ V/m
2.64 x 10⁷ V/m
2.5 x 10⁷ V/m
2.58 x 10⁷ V/m

⇒ A real number consists of
integer part
integer part and fraction part
integer part, fraction part along with positive or negative sign
none of the above

⇒ Efficiency of class A power amplifier is very poor.
TRUE
FALSE

⇒ At half power frequencies the current in R-L-C series circuit is __________ times current at resonance
1/3
1/4
1/2
42737

⇒ It is difficult to write a program in a machine language.
TRUE
FALSE

⇒ Measurement of Hall coefficient enables the determination of
recovery time of stored carrier
type of conductivity and concentration of charge carriers
temperature coefficient and thermal conductivity
Fermi level and forbidden energy gap

⇒ Which of the following oscillators is used for the generation of high frequencies?
R-C phase shift oscillator
Wien bridge oscillator
L-C oscillator
Blocking oscillator

⇒

Assertion (A): A half cycle of sine wave can be expressed as sum of sine wave and another sine wave shifted by T/2 where T is the time period.

Reason (R): The function u(t - t₀) - u(t - t₀ - T) is a gate function occuring at t = t₀ and of duration T.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following methods is used for solving differential equations numerically?
Runge-Kutta method
Gauss-elimination method
Newton-Raphson method
Any one of these

⇒ For a second order system, damping ratio ζ is such that 0 < ζ <. Then the roots of characteristic equation are
real but not equal
real and equal
complex conjugate
imaginary

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
10
2
1
infinity

⇒ 'Burst refresh' in DRAM is also called
Concentrated refresh
Distributed refresh
Hidden refresh
None of the above

⇒ Transformer oil is
refined vegetable oil
refined mineral oil
mixture of vegetable and mineral oil
none of the above

⇒ Transverse electric (TE) waves have
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ A short circuited stub is preferred to an open circuited stub because an open circuited stub
is more difficult to fabricate and construct
is made of transmission line of different Z₀
is liable to radiate
is incapable of giving full range of reactance

⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong