Question is ⇒ In cell communication, cell stands for, Options are ⇒ (A) Geographical Area, (B) Battery, (C) Location, (D) No meaning, (E) , Leave your comments or Download question paper.

Question is ⇒ In cell communication, cell stands for, Options are ⇒ (A) Geographical Area, (B) Battery, (C) Location, (D) No meaning, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In cell communication, cell stands for
A.	Geographical Area [Correct Answer]
B.	Battery [Wrong Answer]
C.	Location [Wrong Answer]
D.	No meaning [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a transistor push pull amplifier
there is no dc present in the output
there are no even harmonics in the output
both (a) and (b)
neither (a) nor (b)

⇒ A cut set schedule shows
incidence of branches to loops
incidence of branches to nodes
incidence of nodes to loops
none of the above

⇒ The noise figure is
3 dB
6 dB
6.6 dB
12 dB

⇒ In telephone systems the relation between load r, number of calls initiated during a specified interval λ and average duration of a call (h) is
r = λh
r = λh²
λ = rh
h = λr

⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above

⇒ LCD uses
nematic crystals
sematic crystals
cholesteric crystals
twisted nematic crystal

⇒ Convolution of x(t + 5) with impulse function δ(t - 7) is equal to
x(t - 2)
x(t + 12)
x(t - 12)
(t + 2)

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ In a ferromagnetic material, the internal field seen by a dipole is
equal to applied field
equal to applied field minus a contribution from neighbouring dipoles
equal to applied field plus a contribution from neighbouring dipoles
equal to or less than applied field

⇒

Match the following:

	List I (μP)		List II (Number of bits in register)
A.	8085	1.	32 bit
B.	8086	2.	16 bit
C.	68000	3.	8/16 bit

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-3, B-1, C-2

⇒ A hot wire instrument is not affected by stray magnetic fields.
TRUE
FALSE

⇒ When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about
1000 V
200 V
50 V
1 V

⇒ Which one of the following is not necessarily an advantage of the phase cancellation method of obtaining SSB over the filter method?
It is possible to generate SSB at any frequency
SSB with lower audio frequencies present can be generated
Switching from one sideband to other is simpler
There are more balanced modulators; therefore the carrier is suppressed better

⇒ Ferromagnetic materials
shows spontaneous magnetisation below a certain temperature
have resistivity very high as compared to that of iron
can be used even at microwave frequencies
all of the above

⇒ In rectifier circuits, ripple factor RF and form factor FF are related as
RF = (FF² - 1)^0.5
RF = FF
RF = FF - 1
RF = (FF - 1)^0.5

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light

⇒ The equivalent inductance seen at terminals A -
14 H
20 H
10 H
4 H

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ The dual of quantity charge is
current
Voltage
flux
dΦ/dt

⇒ Most small signal transistors are
N-P-N, silicon, in a plastic package
P-N-P, silicon, in a plastic package
N-P-N, germanium in a metallic case
P-N-P, germanium in a metallic case

⇒ When load is coupled to class A amplifier through transformer, efficiency decreases.
TRUE
FALSE

⇒ The input impedance of CRO is about
zero
10 Ω
100 Ω
one mega ohm

⇒ In which group of 8085 instructions condition flags are not affected?
Data transfer group
Arithmetic group
Logical group
Both (a) and (c)

⇒ If A = 0101, then A' is
1010
1011
1001
110

⇒ Medium scale integration refers to ICs with
more than 12 but less than 30 gates on the same chip
more than 50 gates on the same chip
more than 20 but less than 100 gates on the same chip
more than 12 but less than 100 gates on the same chip

⇒ Which statement is incorrect for the signal x(t) = 5 sin (2p x 10³t) sin (2p x 10⁶t)?
Upper side band frequency is 1001000
Carrier amplitude is 5
Lower sideband frequency is 990000
x(t) is DSB-SC

⇒ For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (V_SB > 0), the threshold voltage V_T of the MOSFET will
remain unchanged
decrease
change Polarity
increase

⇒ A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as
6000 bits/sec
4500 bits/sec
3000 bits/sec
1500 bits/sec

⇒ For a second order system ω_n is natural frequency, ω_d is frequency of damped oscillations and ζ is damping factor. Then
ω_d = ω_n ξ
ω_d = ω_n (1 - ξ)²
ω_d = ω_n (1 - ξ)^0.5
ω_d = ω_n (1 - ξ²)^0.5

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on