Question is ⇒ A JFET operates in ohmic region when, Options are ⇒ (A) VGS = 0, (B) VGS is less than pinch off voltage, (C) VGS = is Positive, (D) VGS = VDS, (E) , Leave your comments or Download question paper.

Question is ⇒ A JFET operates in ohmic region when, Options are ⇒ (A) VGS = 0, (B) VGS is less than pinch off voltage, (C) VGS = is Positive, (D) VGS = VDS, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A JFET operates in ohmic region when
A.	V_GS = 0 [Wrong Answer]
B.	V_GS is less than pinch off voltage [Correct Answer]
C.	V_GS = is Positive [Wrong Answer]
D.	V_GS = V_DS [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the K map of the given figure the simplified Boolean expressio
A + BC
A + BC
A + B C
A + B C

⇒ A five bit binary adder is used to add 01001 and 00111. The adders from LSB position are numbered as FA₀, FA₁, FA₂ and FA₃. The outputs of FA₂ are
SUM = 0
SUM = 0, CARRY = 1
SUM = 1, CARRY = 0
SUM = 1, CARRY = 1

⇒ The average value of the wavefor
2 V
0 V
4 V
3 V

⇒ A parallel plate capacitor with air as dielectric has a capacitance C. If the dielectric has a dielectric constant ∈_r and the remaining dimensions are the same, the capacitance will be
C/∈_r
∈_rC
∈²_rC
∈³_rC

⇒ Some advantages of optical fibre cables are

small diameter
Immunity to cross talk and EM interference
Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?
1 only
1 and 2
1, 2, 3
2, 3

⇒ The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback would be.
0.4
0.05
0.2
0.8

⇒ An ideal voltage source can not be converted into an equivalent current source.
TRUE
FALSE

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ The number of TV channels which can be accommodated in a spectrum of 300 MHz is about
5
10
50
200

⇒ A 20 m antenna gives a certain uplink gain at frequencies of 4/6 GHz. For getting same gain in the 20/30 GHz band, antenna size required is metre.
100
4
1
10

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ The unit of thermal resistance of a semi-conductor device is
Ohms
Ohms/°C
°C/ohm
°C/watt

⇒ Select the correct relation
∇(AB) = A ∇ B + B ∇ A
∇ . (AB) = ∇ A . B + A ∇ B
∇ x (AB) = ∇ A x B + A ∇ B
All of the above

⇒ A binary ladder network D/A converter requires
resistors of one value only
resistors of many different values
resistors of two different values
none of the above

⇒ Which of the following alphanumeric characters is not allowed in Basic?
capital letters A to Z
lower case letters a to z
digits 0 to 9
special characters +, -, *, / etc

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒ In 8085 microprocessor, if interrupt service requests have been received from all of the following interrupts, then which one will be serviced first?
RST 5.5
RST 6.5
RST 7.5
None

⇒ The amount of photoelectric emission current depends on the frequency of incident light.
TRUE
FALSE

⇒ Addition of a small amount of antimony to germanium will result in
formation of P-type semiconductor
more free electrons than holes in the semiconductor
antimony concentrating on the edges of the crystals
increased resistance

⇒ A parallel polarized wave is incident from air into paraffin having relative permittivity 3, the value of its Brewster angle is
0°
30°
45°
60°

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ In Gunn diode electrons are transferred from
Ridge guide is essentially a form of capacitively loaded guide
low to high mobility energy bands
valley to domain formation
domain to valley formation

⇒ If PRIN = 200.0 and BINT = 0.0525 the result of expression INCOME = PRIN * (1 + BINT) will be
210
210.5
210.5
210.5

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ Which of the following statement about the photo electric emission is incorrect?
The maximum velocity of emission varies with the frequency of incident light
The maximum velocity of emission varies with the intensity of light
The amount of photoelectric emission is directly proportional to the intensity of light
The quantum yield depends on the frequency and not the intensity of incident light

⇒ The Nyquist plo
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the second quadrant
will start from (ω = ∞) in the fourth quadrant and will terminate (ω = 0) in the second quadrant
will start form (ω = ∞) in the second quadrant and will terminate (ω = 0) in the fourth quadrant
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the fourth quadrant

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒ For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives
h₁₂
y₁₂
h₂₁
y₂₁

⇒ In a FM signal, the modulation index increases, then the power
increases
decreases
remains constant
none of the above