Question is ⇒ Hay bridge is suitable for measuring inductance of which one of the following inductors?, Options are ⇒ (A) Having Q value less than 10, (B) Having Q value greater than 10, (C) Having any value of Q, (D) Having phase angle of reactance very large, (E) , Leave your comments or Download question paper.

Question is ⇒ Hay bridge is suitable for measuring inductance of which one of the following inductors?, Options are ⇒ (A) Having Q value less than 10, (B) Having Q value greater than 10, (C) Having any value of Q, (D) Having phase angle of reactance very large, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Hay bridge is suitable for measuring inductance of which one of the following inductors?
A.	Having Q value less than 10 [Wrong Answer]
B.	Having Q value greater than 10 [Correct Answer]
C.	Having any value of Q [Wrong Answer]
D.	Having phase angle of reactance very large [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a P-N-P transistor, with normal bias
the collector junction has negligible resistance
only holes cross the collector junction
the collector-base junction is reverse biased and the emitter base junction is forward biased
only majority carriers cross the collector junction

⇒ In a colour TV receiver, which of the following incorporates colour saturation control?
Chroma detector
Colour killer circuit
SAW filter
Chroma amplifier

⇒ A 'n' bit sequence generator employing SR flip-flop has maximum length of the sequence as :
2ⁿ
n
2ⁿ - 1
2ⁿ^-1

⇒ Which of the following statement about receivers is false?
Double conversion is used to improve image rejection
Double conversion is used to improve selectivity
Variable sensitivity is used to improve selectivity
Variable sensitivity is used to eliminate selective fading

⇒

Assertion (A): If the duty cycle of chopper is low the current would not become discontinuous

Reason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): An electron having charge - e and mass m and lying in an electric field E is subjected to an acceleration - (e/m) E.

Reason (R): If there are n electrons/m³ moving with velocity v_x and each electron has a charge - e, the current density J = - n ev_x.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ For a semiconductor, the conductivity is a function of the products of the number of charge carriers and their mobilites. As result, if the temperature of a slab of intrinsic silicon increases, how does its conductivity vary?
Decreases
Increases
Remains unaffected
Increases or decreases depending upon the rise in temperature

⇒ The concentration of minority carriers in an extrinsic semiconductor under equilibrium is
directly proportional to the doping concentration
inversely proportional to doping concentration
directly proportional to intrinsic concentration
inversely proportional to the intrinsic concentration

⇒ The symbol shown in figure represen
P-channel MOSFET
UJT with N-type base
N-channel DEMOSFET with internal zener protection
P-channel DEMOSFET with internal zener protection

⇒ In the case of an amplifier, the normalised voltage gain is given
f_P >> f₀
f_P = f₀
f_P << f₀
f₀ = 2 f_P

⇒ Consider the following features of monochrome TV

Number of lines per picture 625
Interlace ratio 2 : 1
Aspect ratio 4 : 3
Channel bandwidth 8 MHz

As regards CCIR system B, which of the above are correct?
1, 2, 3, 4
1, 2, 3
1, 2, 4
2, 3, 4

⇒ In CE approximation, the upper end of d.c. load line is called the __________ point and the lower end is the __________ point.
Q, base
base, Q
saturation, cut off
cut off, saturation

⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^-128 each
2^-28 and 2^-127
2^-127 and 2^-128
2^-127each

⇒ Which of the following circuits come under the class of combinational logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 only
3 and 4
4 and 5
1, 2 and 3

⇒ Terra-watt is equal to
10³ W
10⁶ W
10⁹ W
10¹² W

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?
Satellite communication
Ground propagation
Polarized communication
None of the above

⇒ A microstrip line has dielectric having relative permittivity ∈_r. The effective dielectric constant is
more than ∈_r
equal to 1
less than ∈_r
either a or b

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W

⇒ In a TV studios, flying spot scanner is a device for
mixing video and audio signals
telecasting feature films
live telecast of outdoor programs
telecast of indoor music programs

⇒ Find R_L for maximum power trans
3 Ω
1.125 Ω
4.1785 Ω
None of these

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ S is closed for a long time and steady state is reached. S is opened at t(0^-). The voltage marked V is V₀ at t = 0⁺ and V_f at t = ∞. Then value of V₀ and V_f are respecti
8, 8
0, 1
4, 0
4, 8

⇒ If two network is connected in series-parallel connection then
h = [h_a] + [h_b]
[a_a] + [b_b]
[Z] = [Z_a] - [Z_b]
none

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒

Assertion (A): The expression E = - ΔV, where E is the electric field and V is the potential is not valid for time varying fields.

Reason (R): The curl of a gradient is identically zero.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Two meters X and Y require 40 mA and 50 mA for full scale deflection. Then
X is more sensitive
Y is more sensitive
both are equally sensitive
it is not possible to determine from given data

⇒ If ROC of x[n] is R₁ then ROC of aⁿ x[n] is
R₁a
R₁/a
a/R₁
R₁ + a

⇒ The process of extension of a single-crystal surface by growing a film in such a way that the added atoms form a continuation of the single-crystal structure is called
Ion implantation
Chemical vapour deposition
Electroplating
Epitaxy

⇒ The fixed count that should be used so that the output register will represent the input for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
110
10
1111
11101

⇒ Fields are said to be circularly polarized if
their magnitudes are equal
their magnitudes are equal and they differ in phase by ± 90°
their magnitudes are unequal and they differ in phase ± 90°
their magnitudes are unequal and they are in phase