Question is ⇒ In a 4 bit full adder how many half adders and OR gates are required, Options are ⇒ (A) 8 and 4, (B) 7 and 4, (C) 7 and 3, (D) 8 and 3, (E) , Leave your comments or Download question paper.

Question is ⇒ In a 4 bit full adder how many half adders and OR gates are required, Options are ⇒ (A) 8 and 4, (B) 7 and 4, (C) 7 and 3, (D) 8 and 3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a 4 bit full adder how many half adders and OR gates are required
A.	8 and 4 [Wrong Answer]
B.	7 and 4 [Wrong Answer]
C.	7 and 3 [Correct Answer]
D.	8 and 3 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The main advantage of superheterodyne receiver is
better tracking
simple cut
better alignment
improvement in selectivity and sensitivity

⇒ To avoid creep in an energy meter
two shading bands are put on shunt magnet
two shading bands are put on series magnet
two holes are cut in the disc on opposite sides of spindle
the potential coil is made of very thin wire

⇒ In tape recorder erase head is active during recording.
TRUE
FALSE

⇒ Which one of the following is not a negative resistance device?
Gunn diode
Tunnel diode
Impatt diode
Varactor diode

⇒ In bridge circuit of figure, equivalent resistance between A and B
1 Ω
0.5 Ω
2 Ω
1.5 Ω

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ A nickel cadmium cell is an alkaline cell.
TRUE
FALSE

⇒ If the mantissa has a sign bit of 0 and the exponent is changed from a negative number to a more positive number the result is
a positive number and closer to zero
a positive number and away from zero
a negative number
a negative number and closer to zero

⇒ The ac input voltage of an amplifier
is always equal to ac signal voltage
may be equal to or more than ac signal voltage
is always less than ac signal voltage
may be equal or more or less than ac signal voltage

⇒ A Darlington pair is used for
low distortion
high frequency range
high power gain
high current gain

⇒ Voltage V_L in the circuit when V_s < 0 where D is an ideal diode. (Take R₁ = R_s = R_L = 1 &o
0
1
1.5
cannot find

⇒ An electron for which l = 0 has zero orbital magnetic dipole moment.
TRUE
FALSE

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be
38.5 W
400 W
512.5 W
615.5 W

⇒ Which one of the following is true?
Characteristic impedance of twin wire feeder and coaxial cable are nearly the. same
The characteristic impedance of coaxial cable is more than that of twin wire cable
The characteristic impedance of twin wire cable is more than that of coaxial cable
The characteristic impedance of a twin wire feeder may be more or less than that of coaxial cable

⇒ Which of the following ICs has only one NAND gate?
7410
7420
7430
7447

⇒ If a sample of germanium and a sample of Si have the impurity density and are kept at room temperature then
both will have equal value of resistivity
both will have equal -ve resistivity
resistivity of germanium will be higher than that of silicon
resistivity of Si will be higher than of germanium

⇒ Cassegrain feed is used with a parabolic reflection to
reduce the size of the main reflector
increase the gain of the system
increase the beamwidth of the system
allow the feed to be placed at a convenient point

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ The ripple factor of a full wave rectifier is about 0.5.
TRUE
FALSE

⇒ In a dynamometer instrument, the moving coil is pressure coil.
TRUE
FALSE

⇒ Figure shows the equivalent circuit of resistor. The resistor is non-inductive w
R = L/C
LR = L/C
L = CR²
C = LR²

⇒ Line of sight transmission is used in
radio frequencies below 1 MHz
VHF only
audio signals only
VHF and UHF

⇒ Choose correct option for a stable system :

Roots of the characteristic equation of the system are real and negative
Area within the impulse response is finite

I is true, II is true
I is true, II is false
I is false, II is true
I is false, II is false

⇒ Integral control action
removes offset
may lead to oscillatory response
both (a) and (b)
neither (a) nor (b)

⇒ The function δ'(t - b) is a unit doublet.
TRUE
FALSE

⇒ The lowest frequency used in satellite communications is __________ GHz.
0.8
3
18
30

⇒ The relation between bandwidth B, modulating frequency f_m and frequency deviation Δf for a sinusoidally modulated FM signal is
B = Δf + f_m
B = 2(Δf + f_m)
B = f_m - Δf/
B = 2(f_m - Δf)

⇒ If the Nyquist plot does not encircle the (-1 + j0) point the system is always stable.
TRUE
FALSE

⇒ When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.
TRUE
FALSE

⇒ Which one of the following effects is used in measuring power?
Seeback
Ferrari
Induction
Hall