Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
In figure, the short circuit current through terminal AB wil | |
A. | 0.125 [Correct Answer] |
B. | 1.5 A [Wrong Answer] |
C. | 0.0833333333333333 [Wrong Answer] |
D. | 0.0416666666666667 [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will
be reduced by half
be doubled
be four times as high
be reduced to one fourth
⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers
⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either o.c or s.c
⇒
A-1, B-3, C-4, D-2
A-2, B-1, C-3, D-4
A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3
⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64
⇒ Which of the following stages has no phase inversion of the signal?
Two CE stages
Three CE stages
CE and CC stages
CE stage and emitter follower
⇒ Transient current in a loss free LC circuit when excited from an ac source is an __________ sine wave.
undamped
over damped
under damped
critically damped
⇒ For any transfer function, the constant phase angle loci are
a family of circles
a family of straight lines
either (a) or (b)
neither (a) nor (b)
⇒ The phase angle curve of G(jω) H(jω) is drawn by adding the phase angles of individual factors.
TRUE
FALSE
⇒ A carrier signal at frequency 100 MHz is frequency modulated with modulation index 2 by a signal at 2 kHz. At what frequencies are the sidebands produced?
102 MHz and 98 Mhz
100 MHz + 2 kHz, 100 MHz - 2 kHz
100 MHz ± Δf_{d} where f_{d} is frequency deviation
100 MHz ± 3n kHz, where n is 1, 2, ... S integer
⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons
⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only
⇒ The ROC of sequence in the Z.T. of sequence x[n] = a^{n} ∪ [n] is
z > a
z < a
|z| > a
|z| < a
⇒ In the given figure the phase angle of Fn is either 0 or &
TRUE
FALSE
⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong
⇒ An one sided abrupt junction has 10^{21}/m^{3} of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^{-19} C, ε_{r} =16, ε_{0} = 8.87 x 10^{-12} F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm
⇒ M = (μ_{r} - 1)H.
TRUE
FALSE
⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs
⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above
⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter
⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
1p rad/m
2p rad/m
0.2p rad/m
0.1p rad/m
⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode
⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies
⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
G(s) is an all-pass filter
G(s) has a zero in the right-half plane
G(s) is the impedance of a passive network
G(s) is marginally stable
⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors
⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open
⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply
⇒ Skip distance depends on time of day and angle of incidence.
TRUE
FALSE
⇒ In binomial arrays the elimination of secondary lobes takes place
at the cost of directivity
at the cost of gain
both (a) and (b)
none of the above
⇒ In a pure capacitive circuit if the supply frequency is reduced to 1/2, the current will
be reduced by half
be doubled
be four times as high
be reduced to one fourth
⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers
⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either o.c or s.c
⇒
Match the following:
List I | List II | ||
---|---|---|---|
A. | Sky wave | 1. | parasitic elements |
B. | Antenna feed | 2. | delta match |
C. | Reflector | 3. | long-wire antenna |
D. | Rhombic antenna | 4. | ionosphere |
A-1, B-3, C-4, D-2
A-2, B-1, C-3, D-4
A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3
⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64
⇒ Which of the following stages has no phase inversion of the signal?
Two CE stages
Three CE stages
CE and CC stages
CE stage and emitter follower
⇒ Transient current in a loss free LC circuit when excited from an ac source is an __________ sine wave.
undamped
over damped
under damped
critically damped
⇒ For any transfer function, the constant phase angle loci are
a family of circles
a family of straight lines
either (a) or (b)
neither (a) nor (b)
⇒ The phase angle curve of G(jω) H(jω) is drawn by adding the phase angles of individual factors.
TRUE
FALSE
⇒ A carrier signal at frequency 100 MHz is frequency modulated with modulation index 2 by a signal at 2 kHz. At what frequencies are the sidebands produced?
102 MHz and 98 Mhz
100 MHz + 2 kHz, 100 MHz - 2 kHz
100 MHz ± Δf_{d} where f_{d} is frequency deviation
100 MHz ± 3n kHz, where n is 1, 2, ... S integer
⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons
⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only
⇒ The ROC of sequence in the Z.T. of sequence x[n] = a^{n} ∪ [n] is
z > a
z < a
|z| > a
|z| < a
⇒ In the given figure the phase angle of Fn is either 0 or &
TRUE
FALSE
⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped
⇒
Assertion (A): The root locus of a control system is symmetrical about real axis.
Reason (R): For all polynomials with real coefficients, complex poles always occur in conjugate pairs.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong
⇒ An one sided abrupt junction has 10^{21}/m^{3} of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^{-19} C, ε_{r} =16, ε_{0} = 8.87 x 10^{-12} F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm
⇒ M = (μ_{r} - 1)H.
TRUE
FALSE
⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs
⇒ The action of bellows is similar to that of
mass
viscous friction
spring
none of the above
⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter
⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
1p rad/m
2p rad/m
0.2p rad/m
0.1p rad/m
⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode
⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies
⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
G(s) is an all-pass filter
G(s) has a zero in the right-half plane
G(s) is the impedance of a passive network
G(s) is marginally stable
⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors
⇒ In a P-N-P transistor, with normal bias, the emitter junction
is always reverse biased
offers very high resistance
offers a low resistance
remains open
⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply
⇒ Skip distance depends on time of day and angle of incidence.
TRUE
FALSE
⇒ In binomial arrays the elimination of secondary lobes takes place
at the cost of directivity
at the cost of gain
both (a) and (b)
none of the above