Question is ⇒ The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be, Options are ⇒ (A) horizontally polarized, (B) vertically polarized, (C) at 45° within respect to horizontal polarization, (D) at 45° with respect to vertical polarization, (E) , Leave your comments or Download question paper.

Question is ⇒ The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be, Options are ⇒ (A) horizontally polarized, (B) vertically polarized, (C) at 45° within respect to horizontal polarization, (D) at 45° with respect to vertical polarization, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be
A.	horizontally polarized [Correct Answer]
B.	vertically polarized [Wrong Answer]
C.	at 45° within respect to horizontal polarization [Wrong Answer]
D.	at 45° with respect to vertical polarization [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Conductivity σ, mobility μ and Hall coefficient K_H are related as
μ = σK_H
σ = μK_H
K_H = μσ
K_H =(μσ)^1.1

⇒ A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be
9.76 V
1 μV
23.56 μV
6.94 μV

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ In a CE amplifier the Q point is very close to cutoff point on the load line. This results in
saturation clipping
cut off clipping
both saturation and cut off clipping
either saturation clipping or cut off clipping

⇒ In an R-S latch, race condition occurs when
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ A voltage doubler circuit is fed by a voltage V_m sin ωt. The output voltage will be nearly 2 V_m only if
load resistance is small
load resistance is large
load resistance is neither small nor large
either (a) or (c)

⇒ The purpose of series quadrature windings in amplidyne is to
neutralize the effect of armature reaction
reduce commutation difficulties
increase the gain
increase response time

⇒ Consider the following statements about mutual inductances:

The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ Consider the following line 15
line 25
line 35
any of the lines 15 or 25, 35

⇒ A TV receiver is 40 cm wide and 30 cm high. The EHT supply required is about
2kV
20 kV
53 kV
10 W

⇒ A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency f_OH with a second order HP filter having lower cut off frequency f_OL provided
f_OL < f_OH
f_OL > f_OH
f_OH = f_OL
f_OH < 0.5 f_OL

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒

Assertion (A): A sine wave with slew rate distortion looks rectangular

Reason (R): The maximum rate of output voltage change is called slew rate

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ From the noise point of view, bandwidth should
be large
not be too large
should be as large as possible
should be infinite

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒
Assertion (A): In state space analysis, capacitors are taken to be in tree.
Reason (R): State variable analysis is very suitable for computer solution.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In FM noise can be decreased by a feature that AM does not have
increasing deviation
decreasing deviation
reducing modulation index
increasing modulation index

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ In figure, voltage across R₂ = + 10 V. If V_BE = 0.7 V and V_E = 0.7 V and R_E = 10 kΩ, current through R_{E1 mA
0.93 mA
2 mA
1.86 mA}

⇒ For aeroplane and navigation frequency band is
VLF
UHF
VHF
EHF

⇒ How many maximum number of functions can be defined with two symbols which are Boolean in nature:
4
8
2
16

⇒ Virus is a
computer hardware problem
an operating system
a computer program
a computer language

⇒ How is an N-channel junction Field Effect Transistor operated as an amplifier?
With a forward bias gate source junction
With a reverse bias gate-source junction
With a open gate source junction
With a shorted gate source junction

⇒ The input to integrating op-amp is a rectangular wave. The output will be
a sine wave
a rectangular wave
a triangular wave
none of the above

⇒ The fourier transform of the half cosine pulse as shown below is _______
0.5 {sin [0.5(f - 1)] + sin [0.5 (f + 1)]}
0.25 [sin c[0.25 (f - 2)1 + sin c[0.25(f + 2)]]
0.5 {sin c [0.5 (f - 1)] + sin c [0.5 (f + 1)]}
sin c(f - 0.5) + sin c (f + 0.5)

⇒ RF amplifiers are used in radio receivers for
better sensitivity
improved signal-to-noise ratio
better coupling of receiver to the antenna
all of the above

⇒ At a frequency equal to cutoff frequency in a rectangular wave guide
the flow of electromagnetic energy is zero
the flow of electromagnetic energy is infinite
the flow of electromagnetic energy is 50% of maximum
the flow of electromagnetic energy is 10% of maximum

⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola

⇒ In given figure the switch was closed for a long time before opening at t = 0. The voltage V_x at t = 0^{+25 V
50 V
-50 V
0 V}

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math