Question is ⇒ Robotic manipulator arms mostly use, Options are ⇒ (A) hydraulic actuator, (B) pneumatic actuator, (C) electric motor actuator, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Robotic manipulator arms mostly use, Options are ⇒ (A) hydraulic actuator, (B) pneumatic actuator, (C) electric motor actuator, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Robotic manipulator arms mostly use
A.	hydraulic actuator [Wrong Answer]
B.	pneumatic actuator [Wrong Answer]
C.	electric motor actuator [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A pure tone at 1000 Hz has a dB level of 40 dB. If the required dB level is 100, the number of such tones is
2.5
60
10⁴
10⁶

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ MS outlook is a software for DTP.
TRUE
FALSE

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For global communication, the number of satellites needed is
1
3
10
5

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒ The circuit shown in figure will ac
differentiator
adder
clipper
clamper

⇒ Which one of the following cannot be used to remove the unwanted sideband in SSB?
Balanced modulator
Phase shift method
Filter system
Third method

⇒ The current I_CBO flows in
base and emitter leads
base and collector leads
collector and emitter leads
collector, emitter and base leads

⇒ With respect to the Miller integrator sweep shown below, the sweep rate wil
2
4
1.5
2.5

⇒ If V = 20 + j20, then log_e(A) A is
3.342 + j 45
28.28 ∠45°
400 ∠45°
3.342 + j 0.785

⇒ At a particular time it is observed that the frequencies of F layer at Delhi is 3 MHz the maximum electron density is
11 x 10¹⁰
1.1 x 10¹⁰
0.11 x 10¹⁰
11 x 10¹²

⇒ In the given figure shows a 3 bit shift register using TTL flip flops. Initially all the flip flops are set to 0 state. After 8 clock pul
A = 1, B = 1, C = 1
A = 1, B = 1, C = 0
A = 0, B = 1, C = 1
A = 0, B = 0, C = 1

⇒ An enhancement mode MOSFET is off when the gate voltage is
zero
negative
less than threshold value
none of the above

⇒ N-type silicon is obtained by doping silicon with
germanium
aluminium
boron
phosphorus

⇒ Signal flow graph is used to find :
stability of the system
controllability of the system
transfer function of the system
poles of the system

⇒ The number of address lines in EPROM 4096 x 8 is
2
4
8
12

⇒ A parity detector can detect
single error only
single error or odd number of errors
two errors
single or two errors

⇒

Assertion (A): Logical group of instructions contains instructions for logic operations.

Reason (R): Data transfer group instruction is basically a copying instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Conductivity is measured in terms of
mho/metre
ohm/metre
mho/metre²
ohm/metre²

⇒ The maximum positive and negative numbers which can be represented in 2's complement form using n bits are respectively
+(2^{n + 1} - 1), - (2^{n - 1} - 1)
+(2^{n + 1} - 1), - 2^{n - 1}
+2^{n - 1}, - 2^{n - 1}
+2^{n + 1}, - (2^{n - 1} + 1)

⇒ The high voltage level of a digital signal in positive logic is
1
0
either 1 or 0
-1

⇒ For the time domain response shown in figure the
lies in left half plane
lies on imaginary axis
lies along the positive real axis
may be complex or imaginary

⇒ The magnitude plot of a composite signal x(t) = e^3jt + e^4jt is __________ .
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ In figure, I_D = 4 mA. Then V_{DS20 V
16 V
4 V
0.4 V}

⇒ In 8085 microprocessor, which of the following interrupts has the highest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ The output of a Piezoelectric crystal has
low amplitude and low impedance
high amplitude and low impedance
low amplitude and high impedance
high amplitude and high impedance

⇒ For 200V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
280 V
346 V

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)