Question is ⇒ In a P-N-P transistor, with normal bias, the emitter junction, Options are ⇒ (A) is always reverse biased, (B) offers very high resistance, (C) offers a low resistance, (D) remains open, (E) , Leave your comments or Download question paper.

Question is ⇒ In a P-N-P transistor, with normal bias, the emitter junction, Options are ⇒ (A) is always reverse biased, (B) offers very high resistance, (C) offers a low resistance, (D) remains open, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a P-N-P transistor, with normal bias, the emitter junction
A.	is always reverse biased [Wrong Answer]
B.	offers very high resistance [Wrong Answer]
C.	offers a low resistance [Correct Answer]
D.	remains open [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒ An RLC series circuit has R = 30 Ω, X_L = 30 Ω and X_C = 30 W. Its impedance is
30 ∠0°.
30 ∠45°
42.42 ∠45°
90 ∠45°.

⇒ If the height of transmitting and receiving antenna in a LOS system are 49 meter and a 9 meter respectively then the distance up to which communication may be possible is about
40 km
110 km
400 km
1100 km

⇒ A 3 phase balanced supply feeds 3 phase unbalanced load. Power supplied to the load can be measured by using

2 wattmeter
one wattmeter
3 wattmeter

Which of the above statements is correct?
1 and 2
1 and 3
2 and 3
3 alone

⇒ In a minimum phase system
all poles lie in the left half plane
all zeros lie in the left half plane
all poles lie in the right half plane
all except one pole or zero lie in the left half plane

⇒ The circuit show in the figure has 4 boxes each described by inputs P, Q, R and outputs y, z
4 bit adder giving P + Q
4 bit subtractor P - Q
4 bit subtractor Q - P
4 bit adder P + Q + R

⇒

Assertion (A): The part of root locus on the real axis is not dependent on the poles and zeros which are not on the real axis.

Reason (R): Poles and zeros which are not on the real axis occur in conjugate pairs

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If f(t) = 1, F(jω) = 2p δ(ω).
TRUE
FALSE

⇒ Hue of a colour means
amount of light energy received by eye
predominant spectral purity of colour light
amount of other colours present
none of the above

⇒ An active network has
an e.m.f source
a current source
neither of the above
either (a) or (b)

⇒ Which stage generates RF carri
Amplifier
Oscillator
Power supply
All of the above

⇒

Assertion (A): Tunnel diode is used in many pulse and digital circuits.

Reason (R): The v-i curve of a tunnel diode resembles letter 'N'.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the given figure assume that initially Q = 1 with Clock Pulses being given, the subsequent states of Q wil
1, 0, 1, 0, 1......
0, 0, 0, 0, 0......
1, 1, 1, 1, 1......
0, 1, 0, 1, 0......

⇒ For 0 < M < 1, the centres of M circle lie to the right of origin.
TRUE
FALSE

⇒ The Boolean function A + BC is reduced form of
AB + BC
AB + ABC
(A + B) (A + C)
(A + C)B

⇒ Q of a coil

increases with Q increasing frequency
varies linearly with frequency
increase with increasing frequency because R increases at high frequency
decrease after the peak frequency because R increases at H.F. the correct statements are

A, B
C, D
A, C
B, D

⇒ In figure, Z₁ = 200∠60° Ω, Z₂ = 400∠ - 90° Ω, Z₃ = 300∠0°. Then Z₄ for bridge to be balanced
150∠30° Ω
400∠ - 90° Ω
300∠90° Ω
600∠ - 150° Ω

⇒ The MOS symbol shown indicates that

It is depletion type
It is enhancement type
It is channel
It is P-channel
Electrons flow from s to D
Holes flow from D to s

The true statements
1, 3, 6
1, 3, 5
2, 4, 6
2, 3, 5

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒ The conductivity of a semiconductor crystal due to any current carrier is not proportional to
mobility of the carrier
effective density of states in the conduction band
electronic charge
surface states in the semiconductor

⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as
f
f²
f⁴
f^1/2

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ In 8085 microprocessor, how many lines are there in data bus?
6
8
2
16

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ Light dependent resistor is
photo resistive device
photo voltaic device
photo emissive device
either (a) or (c)

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ The total bandwidth needed for an AM signal at 55.25 MHz with 0.5 MHz video modulation is
0.25 MHz
0.5 MHz
1 MHz
10 MHz

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true