Question is ⇒ In the given figure the reflected voltage wave after first reflectio, Options are ⇒ (A) 18 V, (B) -18 V, (C) 30 V, (D) -30 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure the reflected voltage wave after first reflectio, Options are ⇒ (A) 18 V, (B) -18 V, (C) 30 V, (D) -30 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure the reflected voltage wave after first reflectio
A.	18 V [Wrong Answer]
B.	-18 V [Correct Answer]
C.	30 V [Wrong Answer]
D.	-30 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The important postulate arising out of Maxwell's modification of Ampere's law is
a changing magnetic field produces an electric field
a changing electric field produces a magnetic field
a motional e.m.f. is produced by a coil moving in a magnetic field
a steady current produce a magnetic field

⇒ The circuit shown in the figure is tha
non-inverting amplifier
Inverting amplifier
an oscillator
Schmitt trigger

⇒ The depletion layer consists of immobile ions.
TRUE
FALSE

⇒ If an admittance Y(s) has a term Ks, the realization would give
an inductance of value K
a resistance of value K
a capacitance of value K
either (a) or(c)

⇒ In laboratory experiment the output from reflex klystron is moderated by square wave because
it is easy to generate a square wave
crystal diode operates in square law region of i-v characteristics
it prevents frequency modulation
detector circuit is less complicated

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒

Match the following:

	List I (BHE, A0)		List II (Word is read/write)
A.	0, 0	1.	1 byte from/to odd address
B.	0, 1	2.	1 byte from/to even address
C.	1, 0	3.	16 bit word
D.	1, 1	4.	None

A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ VLF waves are used for communication system because
of low power requirement
they are least prone to distortion
they penetrate the ionosphere easily
the transmitting antennas are of convenient size

⇒ At a very low temperature, a semiconductor
becomes a conductor
becomes an insulator
may become a conductor or an insulator
will remain a semiconductor becomes a conductor or an insulator

⇒ A flip-flop circuit is
monostable
bistable
multistable
unstable

⇒ Out of multiplexer and demultiplexer, which has select inputs?
Multiplexer only
Demultiplexer only
Both multiplexer and demultiplexer
None

⇒ Troposphere is the portion of atmosphere
nearest to ground
between 50 to 90 km above ground
between 110 to 220 km above ground
between 250 to 350 km above ground

⇒ A silicon sample A is doped with 10¹⁸ Atoms/cm³ of Boron. Another sample B of identical dimensions is doped with 10¹⁸ atoms/cm³ of phosphorus. The ratio of electron to hole mobility is 3. The ratio of conductivity of the sample A to B is
3
42738
42769
42796

⇒

Assertion (A): A good op-amp should have very large band width

Reason (R): An ideal op-amp should have infinite input resistance and zero output resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In decimal system the base of radix is
0
1
10
e

⇒ Consider the following statements regarding sources or error in a Q-meter:

If a coil with resistance R is connected in direct measurement mode and if the residual resistance of Q-meter is 0.1 R, then the measure Q of the coil would be 1.1 times the actual Q.
If the inductance to be measured is less than 0.1 mH, the error due to presence of residual inductance cannot be neglected.
The presence of distributed capacitance in a coil modifies the effective Q of the coil.

Which of the above statements are correct?
1, 2 and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ Microwaves are used for
telephony
radio broadcast
TV systems
all of the above

⇒ Using 2's complement, the largest positive and negative number which can be stored with 8 bits are
+128 and -127
+128 and -128
+127 and -128
+127 and -127

⇒ What will be conversion time of a successive approximation A/D converter which uses 2 MHz clock and 5 bit binary ladder containing 8 V reference.?
2.5 μ sec
25 μ sec
3 μ sec
4 μ sec

⇒ Long distance short-wave radio broadcasting uses
ground wave
ionospheric wave
direct wave
any of the above

⇒ In a TV, studio the function of vision switcher is to
edit television programs
relay television programs
control zoom lens
mix audio and video signals

⇒ The multiplication of two n bit numbers gives a product of length less than or equal to
n bits
2ⁿ bits
2n bits
2ⁿ - 1 bits

⇒ A pulse width signal can be governed by
free running multi-vibrator
monostable multi-vibrator
Schmitt trigger
JK flip-flop

⇒ The current through a resistance R is shown in figure. The computed value of power
400 ± 0.42 W
400 ± 4.6 W
400 ± 8.85 W
400 ± 10.65 W

⇒ In PAL system
phase of U signal is reversed on alternating lines
phase of V signal is reversed on alternating lines
phases of both U and V signals are reversed on alternating lines
none of the above

⇒

Match the following:

	List I		List II
A.	D Layer	1.	110 km
B.	E layer	2.	10 km
C.	F layer	3.	60 km
D.	Troposphere	4.	350 km

A-3, B-1, C-4, D-2
A-2, B-1, C-4, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-1, D-2

⇒ The output Y of the circuit shown in the figur
(A + B) C + DE
AB + C(D + E)
(A + B) C + D + E
(AB + C) . DE

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ Registers and counters are similar in the sense that they both
count pulses
store binary information
are made from an array of flip-flops and gates integrated on a single chip
are shift registers

⇒ Frequency response approach is a simple approach to control system design.
TRUE
FALSE