Question is ⇒ Resonant circuits are used in, Options are ⇒ (A) audio amplifiers, (B) RF amplifiers, (C) both audio and RF amplifiers, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Resonant circuits are used in, Options are ⇒ (A) audio amplifiers, (B) RF amplifiers, (C) both audio and RF amplifiers, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Resonant circuits are used in
A.	audio amplifiers [Wrong Answer]
B.	RF amplifiers [Correct Answer]
C.	both audio and RF amplifiers [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The two terms used to describe performance of a directional coupler are
coupling and directivity
gain and coupling
gain and directivity
gain and isolation

⇒ Consider the following statements regarding phase sensitive detector

The detector reads zero when phases of input signal and reference signal are different.
The detector acts as a linear rectifier.
The detector can be used as vector voltmeter.

Of the above statements which are correct?
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ A 1 MHz sinusoidal carrier is amplitude modulated by a symmetrical square wave of period 100 μ sec. Which of the following frequencies will not be in the modulated signal?
990 kHz
1010 kHz
1020 kHz
1030 kHz

⇒ In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup
0210 H
0.211 H
0118 H
020 FH

⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω

⇒ If B_max is the maximum flux density, eddy current loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ Which of the following element does not have three valence electrons?
Boron
Aluminium
Gallium
Phosphorus

⇒

Assertion (A): A class C amplifier is a timed amplifier which needs a tank circuit as the load in the collector circuit of the transistor for its proper operation

Reason (R): In class C operation collector current flows for less than 180° of the ac cycle and thus flows in pulses

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The number of protons in germanium atom is
4
16
28
32

⇒ What will be equipotential surfaces for a pair of equal and opposite line charges?
Spheres
Concentric cylinders
Non-concentric cylinders
None of the above

⇒ In the circuit of figure the current through C at t = &infin
0.166666666666667
2.5 A
3.1 A
0

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa

⇒ Discharge breakdown in insulators is due to voids.
TRUE
FALSE

⇒ TE₁₀ mode of propagation of electromagnetic energy in waveguides can be thought of as
three TEM waves travelling along length of wave-guide
One TEM wave travelling along length of wave guide and one TEM wave propagation in the transverse plane
One TEM wave travelling along the length of wave guide and two TEM waves
none of the above

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒

Assertion (A): Dynamic RAM needs refreshing.

Reason (R): Capacitors tend to loose charge.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following statements is not correct?
Propagation delay is the time required for a gate to change its state
Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state
Fan-in of a gate is always equal to fan-out of the same gate
Operating speed is the maximum frequency at which digital data can be applied to a gate

⇒ In a perfect conductor the resistor noise is
maximum
zero
very high
almost infinite

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒

Assertion (A): If the duty cycle of chopper is low the current would not become discontinuous

Reason (R): If the time constant L/R of the load in chopper is low the current may become discontinuous.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ Figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
0
1
AB
AB

⇒ In case of a transistor amplifier the emitter resistance R_e is removed
the gain of the amplifier will reduce
heat sink will not be required
Q-point will become unstable
base to emitter function will be less forward biased

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

⇒ ROC of sequence x[n] = (3)ⁿ ∪[n] + (4)ⁿ ∪[- n - 1]
|z| > 4
3 < |z| < 4
|z| < 4
|z| > 3

⇒ Varactor diodes use
silicon
GaAs
either (a) or (b)
neither (a) nor (b)

⇒ Figure sho
bipolar transistor
JFET
p-channel MOSFET
n-channel enhancement MOSFET

⇒ Choose proper substitutes for x and y to make the following statement corr
x : Reverse, y : Reverse
x : Reverse, y : forward
x : Forward, y : Reverse
x : forward, y : forward

⇒ Which of the following is not considered as a useful quantity in comparing noise performance of receivers?
Noise temperature
Noise figure
Noise resistance
Input noise voltage