Question is ⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ ., Options are ⇒ (A) maskable, non-maskable, (B) maskable, maskable, (C) non-maskable, non-maskable, (D) non-maskable, maskable, (E) , Leave your comments or Download question paper.

Question is ⇒ TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ ., Options are ⇒ (A) maskable, non-maskable, (B) maskable, maskable, (C) non-maskable, non-maskable, (D) non-maskable, maskable, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	TRAP is __________ whereas RST 7.5, RST 6.5, RST 5.5 are __________ .
A.	maskable, non-maskable [Wrong Answer]
B.	maskable, maskable [Wrong Answer]
C.	non-maskable, non-maskable [Wrong Answer]
D.	non-maskable, maskable [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An one sided abrupt junction has 10²¹/m³ of dopants on the lightly doped side, zero bias voltage and a built-in potential of 0.2 V. The depletion width of abrupt junction.(q = 1.6 x 10^-19 C, ε_r =16, ε₀ = 8.87 x 10^-12 F/m) is
0.036 nm
0.6 μm
3 mm
1.5 mm

⇒ Which of the following is used as a passive component in electronic circuits?
Tunnel diode
Capacitor
Transistor
Vacuum tube

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Decimal number 9 in gray code =
1100
1101
110
1111

⇒ The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback would be.
0.4
0.05
0.2
0.8

⇒

Assertion (A): A DIAC has four layers but only two terminals.

Reason (R): A DIAC can conduct in both directions.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ To select one out of N equally probable events, the number of bits required is
log₂ N
log₁₀ N
log_e N
N

⇒ Two identical NMOS transistors M₁ and M₂ are connected as shown below. V_bias is chosen so that both transistors are in saturation. The equivalent g_m of the pair is defined t
the sum of individual g_m's of the transistors
the product of individual g_m's of the transistors
nearly equal to the g_m of M₁
nearly equal to g_m / g₀ of M₂

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ The disturbance from adjacent telephone line is known as
cross fire
cross talk
inductive disturbance
none of the above

⇒ A parity detector can detect
single error only
single error or odd number of errors
two errors
single or two errors

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒ The language PL / I has
one character set having 60 characters
one character set having 48 characters
one character set having 60 characters and another character set having 48 character
none of the above

⇒ The gain of an FET amplifier can be changed by changing
r_m
g_m
R_d
none of the above

⇒ The voltage of single phase supply to residential consumers in India is
400 V
230 V
2.2 kV
11 kV

⇒ If two network is connected in series-parallel connection then
h = [h_a] + [h_b]
[a_a] + [b_b]
[Z] = [Z_a] - [Z_b]
none

⇒ Which has volatile memory?
Magnetic tape
RAM
Diskette
Hard disk

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ Consider the following instruments

Tangent galvanometer
Rayleigh current balance
Household energy meter
Hot wire ammeter

Out of above absolute instruments are
1, 2 and 3
1, 2 and 4
1 and 2
2, 3 and 4

⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒

Assertion (A): Radio transmission is by sky waves

Reason (R): Waves having frequencies higher than 30 MHz penetrate the atmosphere and do not return to earth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,
stationary
ergodic
Gaussian
BIBO stable

⇒ Good smoothing factor of a coil depends on
inductance of the coil
terminal voltage
cross-sectional area of the wire of the coil
property of the wire of the coil

⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
15.58 x 10⁶
15.58 kHz
1.58 x 10³
None of the above

⇒ In microwave circuits, a mode transducer is used to
change mode of wave transmission
change direction of wave transmission
change polarization of wave transmission
change mode, direction or polarization wave transmission

⇒ The radiation resistance of a circular loop of one turn is 0.01 ohm. For 5 turn loop the radiation resistance is
0.002 Ω
0.01 Ω
0.05 Ω
0.25 Ω