Question is ⇒ In 2's complement addition, the carry generated in the last stage is, Options are ⇒ (A) added to LSB, (B) neglected, (C) added to bit next to MSB, (D) added to the bit next to LSB, (E) , Leave your comments or Download question paper.

Question is ⇒ In 2's complement addition, the carry generated in the last stage is, Options are ⇒ (A) added to LSB, (B) neglected, (C) added to bit next to MSB, (D) added to the bit next to LSB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In 2's complement addition, the carry generated in the last stage is
A.	added to LSB [Wrong Answer]
B.	neglected [Correct Answer]
C.	added to bit next to MSB [Wrong Answer]
D.	added to the bit next to LSB [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The attenuation factor in parallel plane guides is given by
a = power lost/power transmitted
a = 2 x power lost/power transmitted
a = power lost per unit length/2 x power transmitted
a is always constant

⇒ In a three phase series inverter, the firing frequency is
three times output frequency
six times output frequency
twice the output frequency
equal to output frequency

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ Which of the following antennas is circularly polarized?
Yagi-Uda
Parabolic reflector
Small circular loop
Helical

⇒ Hall's effect can be used to measure
magnetic field intensity
average number of holes
carriers concentration
electrostatic field intensity

⇒ Two capacitors of 2 μF and 4 μF capacitance are connected in series across a 30 V dc battery. After the capacitors have been charged, the voltage across them will be
15 V each
10 V and 20 V
20 V and 10 V
30 V each

⇒ At 0 K, silicon and germanium behave like monoatomic crystals.
TRUE
FALSE

⇒ Aperture circuit produces __________ in sample hold circuit.
the total sampling time
delay between the instance at which hold command is initiated and the instance at which O/P starts tracking I/P
the time taken by O/P to settle within the specified 1% error band, that of the I/P
time required by holding capacitor to reach upto the level close to input

⇒ The input impedance of short-circuited line of length l where l < λ/4
inductive
capacitive
resistive
none of the above

⇒ The number of noise sources in a BJT are
3
2
1
4

⇒ Highest value of Autocorrelation of a function 100 cos 50 pt is
50
100
zero
100/p

⇒ For the shaded area in Venn diagram of the given figure, the Boolean expressio
AB + BC + CA
ABC + A B C
ABC + A B C
ABC+AB

⇒ Which of the following statements is not true in regard to storage time of a transistor?
The transistor is in active region
Both junctions are forward-biased
The collector injects electrons or holes into the base region
It is the time taken by the carriers to leave the base region

⇒

Assertion (A): ECL is fast as compared to TTL.

Reason (R): ECL dissipates less power than TTL.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A practical Parallel resonant circuit has a coil in Parallel with a 0.14 μf capacitor. The coil has an inductance of 1 mH and a resistance of 10 ohms. The Q of the circuit is
1000
100
10
1

⇒ Find equivalent capacitance if each capacitance is
5/12 F
12/5 F
6/5 F
5/6 F

⇒ Which of the following describe the correct properties of an emitter follower circuit?

It is a voltage series feedback circuit.
It is a current series feedback circuit.
Its voltage gain in less than unity.
Its output impedance is very low.

Select the correct answer from the codes given below:
1, 3 and 4
2, 3 and 4
2 and 3 only
2 and 4 only

⇒ Which of the following DO statements is invalid in FORTRAN 77?
DO 161 = 1, 15
DO 16 1 = 1, 10, 1
DO 16 I = - 5, 5, 2
none of the above

⇒

Match the following:

	List I		List II
A.	Television	1.	Either AM or FM used
B.	Radio	2.	Both AM and FM are used
C.	Radar	3.	PCM is used
D.	Data Communication	4.	Digital system

A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ In a D-type latch EN = 1, D = 1, the O/P is
1
0
don't care
blocked

⇒ A parabolic antenna produces a radiation pattern which is
circularly polarized
highly directional
omnidirectional
linearly polarized

⇒ The use of a capacitor filter in a rectifier circuit gives satisfactory performance only when the load
current is high
current is low
voltage is high
voltage is low

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒ In a transmission line terminated with a load equal to the characteristic impedance, the reflection coefficient is
0
1
-1
Infinity

⇒

Assertion (A): When a PID controller is added to a system, the peak overshoot to step input cannot be determined easily.

Reason (R): Use of PID controller introduces a zero in the forward path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The "boundary sphere" between antenna region and free space region appears to "opaque"
along the dipole axis
along perpendicular direction
along the dipole axis as well as perpendicular direction
neither along the dipole axis nor along the perpendicular direction

⇒ Refer to the NAND and NOR latches shown in the figure. The inputs (P₁, P₂) for both the latches are first made (0, 1) and then, after a few seconds, made (1, 1). The corresponding stable outputs (Q₁, Q₂)
NAND: first (0, 1) then (0, 1) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (1, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 1) NOR: first (0, 1) then (0, 1)

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz