Question is ⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following, Options are ⇒ (A) An astable multivibrator, (B) Stable multivibrator, (C) A bistable multivibrator, (D) A J-K flip-flop, (E) , Leave your comments or Download question paper.

Question is ⇒ A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following, Options are ⇒ (A) An astable multivibrator, (B) Stable multivibrator, (C) A bistable multivibrator, (D) A J-K flip-flop, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 1 ms pulse can be converted into a 10 ms pulse by using which one of the following
A.	An astable multivibrator [Wrong Answer]
B.	Stable multivibrator [Correct Answer]
C.	A bistable multivibrator [Wrong Answer]
D.	A J-K flip-flop [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the given fi
0 rad/sec
2 rad/sec
3/2 rad/sec
None of these

⇒ In a 3 phase semiconverter, the dc output voltage for a certain firing angle is 50% of the maximum possible value. The firing angle is
30°
60°
90°
120°

⇒ Under ordinary circumstances, impulse noise can be reduced in
FM only
AM only
both AM and FM
none of the above

⇒ The circuit shown I/P in the figure repres
Low pass filter
High pass filter
Band Pass filter
Band stop filter

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ Zip floppy has a capacity of
50 MB
500 MB
25 MB
100 MB or 250 MB

⇒ Which one of the following is a regulated power supply?
IC 555
IC 844
IC 3080
IC 723

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ Which of the following lines behaves as infinite line?
a line terminated in inductance
a line terminated in capacitance
a short line
a line terminated in z₀

⇒ Four sig
2f₀
3f₀
4f₀
8f₀

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ The transfer function G₁₂ (s) for a two port is
V₂/V₁
V₂ (s)/V₁ (s)
V₂ (s)/I₁ (s)
I₂ (s)/I₁ (s)

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following is high frequency transmission line?
An impedance transformer
Frequency compensator
Flying resistor
None of the above

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ A voltage DAC is generally slower than current DAC
because of more accuracy
because of higher resolution
because of response time of op-amp current to voltage converter
none of the above

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ In register index addressing mode the effective address is given by
index register value
sum of the index register value and the operand
operand
difference of the index register value and the operand

⇒ A reactance function
has a pole at origin
has a zero at origin
may have a pole or zero at origin
has a pole or zero at origin and a pole or zero at infinity

⇒ In disc mounting of SCR
SCR is clamped on one side of disc shaped heat sink
SCR is clamped between two disc shaped heat sinks
The SCR has low current rating
None of the above

⇒ Fields are said to be circularly polarised if their magnitudes are
equal and they are in phase
equal but they differ in phase by ± 90°
unequal and differ in phase by ± 90°
unequal but are in phase

⇒ The number of bits in EBCDIC is
12
10
8
6

⇒ Find I for circuit shown b
0.125
0.0416666666666667
0.0833333333333333
0

⇒ A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is
resistance
inductance
capacitance
R and C in series

⇒ In a receiver, which of the following device has IF input but RF output?
Demodulator
Loudspeaker
Audio amplifier
Frequency changer

⇒

Assertion (A): Microprocessor 8085 has an 8 bit register called accumulator which stores intermediate answers during a computer operation.

Reason (R): Accumulator can send or receive data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ A cascade amplifier stage is equivalent to
a common emitter stage followed by a common stage
a common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒ Consider the following statements as regards DPSK and DEPSK

DPSK demodulator requires a device which operates at carrier frequency and provides a delay of bit time T_b
In DPSK, synchronous demodulation recovers the signal b(t) and the decoding of b(t) to generate d(t) is done at base band
In both DPSK and DEPSK errors always occur in pairs

Which of the above statements are correct?
1 and 3
1 and 2
2 and 3
1, 2 and 3