Question is ⇒ Assertion (A): Microprocessor 8085 has 16 address bus lines and 8 data bus lines.Reason (R): Address bus in 8085 is unidirectional., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is correct R is wrong, (D) A is wrong R is correct, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Microprocessor 8085 has 16 address bus lines and 8 data bus lines.Reason (R): Address bus in 8085 is unidirectional., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is correct R is wrong, (D) A is wrong R is correct, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Microprocessor 8085 has 16 address bus lines and 8 data bus lines. Reason (R): Address bus in 8085 is unidirectional.
A.	Both A and R are correct and R is correct explanation of A [Wrong Answer]
B.	Both A and R are correct but R is not correct explanation of A [Correct Answer]
C.	A is correct R is wrong [Wrong Answer]
D.	A is wrong R is correct [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ From the given circuit below, we can conclude t
BJT is pnp
BJT is npn
transistor is faulty
not possible to determined

⇒ In a valence crystal, the valence electrons
are not shared
are shared between neighbouring atoms
are shared by all atoms
any of the above

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ Which one of the following is correct?
Coding reduces the noise in the signal
Coding deliberately introduces redundancy into messages
Coding increases the information rate
Coding increases the channel bandwidth

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate
is more than 50% of total energy
is less than 50% of total energy
depends on the materials of the three plates
may be more or less than 50% of total energy

⇒ A second order active bandpass filter can be obtained by cascading LP second order filter having higher cut off frequency f_OH with a second order HP filter having lower cut off frequency f_OL provided
f_OL < f_OH
f_OL > f_OH
f_OH = f_OL
f_OH < 0.5 f_OL

⇒ The current through R₁ is(If β = 99, V_BE = 0.7
0.1 mA
0.35 mA
0.2 mA
none

⇒ Which of the following represents a stable system?

Impulse response decreases exponentially.
Area within the impulse response in finite.
Eigen values of the system are positive and real.
Roots of the characteristic equation of the system are real and positive.

Select the answer using the following codes:
1 and 4
1 and 3
2, 3 and 4
1, 2

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ Consider the following stateme
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ The v-i characteristic of an element is shown in below figure the elemen
non-linear, active, non-bilateral
linear, active, non-bilateral
non-linear, passive, non-bilateral
non-linear, active, bilateral

⇒ A MOD - 2 counter, the FF has a t_pd = 60 nsec. The NOR gate has a t_pd of 30 nsec. The clock frequency is
37 MHz
40 MHz
111 MHz
none

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The minimum sampling rate is :
62831.9 V/sec
125663.8 V/sec
31415.95 V/sec
None

⇒

Match the following:

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ Symbol shown in figure represen
P-channel DMOSFET
N-channel DMOSFET
UJT with P-type base
UJT with N-type base

⇒ A CE amplifier is the most common BJT amplifier.
TRUE
FALSE

⇒ Varactor diode is forward biased when it is used.
TRUE
FALSE

⇒ Which one is correct?
Sky wave propagation (2 to 30 MHz)
Space wave propagation (> 30 MHz)
Tropospheric propagation (> 300 MHz)
All of the above

⇒ Which of the following is not correct for two phase servomotor?
Rotor diameter is small
Applied voltages are seldom balanced
Rotor resistance is low
Torque speed curve is linear

⇒ Piezoelectric materials serves as a source of
microwaves
ultrasonic waves
musical waves
resonant waves

⇒ The attraction between the nucleus and valence electron of copper atom is
zero
weak
strong
either zero or strong

⇒ The minimal function that can detect a "divisible by 3" 8421 BCD code digit (representation D₈D₄D₂D₁) is given by
D₈D₁ + D₄D₂ + D₈D₂D₁
D₈D₁ + D₄D₂ D₁ + D₄D₂D₁ + D₈D₄D₂D₁
D₄D₁ + D₄D₂ + D₈D₄ D₂D₁
D₄D₂D₁ + D₄D₂D₁ + D₈D₄D₂D₁

⇒ E_g is the band gap, A is pre-factor, k is Boltzmann constant? Which one of the following is the remaining grade of paper used in paper capacitor, besides the other two grade of paper-low and extra low loss?
Strong dielectric
Regular
Rough
High loss

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒ The amplitude of a pair of composite sinusoidal signal y(n) = x₁(n) + x₂(n) with x₁(n) = sin (5pn) x₂(n) = 3 sin (5pn) is __________ .
2
3
4
1

⇒ A dynamometer wattmeter is suitable for both dc and ac.
TRUE
FALSE

⇒ Consider the following statements

In a pulsed radar, the transmitted pulses are of high frequency
In a pulsed radar, the transmitted pulses are of high power
In a pulsed radar, the transmitted pulses are of brief duration
In a pulsed radar, the transmitted pulses are of square wave shape.

Of the above statements the correct statements are
1 only
1, 2 and 3 only
1, 2, 3, 4
1 and 3 only

⇒ The behaviour of a JFET is similar to that of
NPN transistor
PNP transistor
SCR
Vacuum triode