Question is ⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is, Options are ⇒ (A) 1.6 dB, (B) 2 dB, (C) 3.6 dB, (D) 6 dB, (E) , Leave your comments or Download question paper.

Question is ⇒ An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is, Options are ⇒ (A) 1.6 dB, (B) 2 dB, (C) 3.6 dB, (D) 6 dB, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An antenna has a resistance of 50 Ω and an equivalent noise resistance of 30 Ω The noise figure in decibels is
A.	1.6 dB [Wrong Answer]
B.	2 dB [Correct Answer]
C.	3.6 dB [Wrong Answer]
D.	6 dB [Wrong Answer]
View Answer 5 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a high speed modem the data rate handled is about
1000 bps
5000 bps
20000 bps
50000 bps

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then R_{B200 kΩ
265 kΩ
150 kΩ
100 kΩ}

⇒ Which of the following is an active device?
Transformer
Silicon controlled rectifier
Electric bulb
Loudspeaker

⇒ A circular waveguide has an infinite set of TE and TM modes.
TRUE
FALSE

⇒ In a bipolar transistor
recombination in base regions of both n-p-n and p-n-p transistor is low
recombination in base regions of both n-p-n and p-n-p transistors is high
recombination in base region of n-p-n transistor is low but that in p-n-p transistor is high
recombination in base region of p-n-p transistor is low but that in n-p-n transistor is high

⇒ If the poles lie in second quadrant, damping ratio is
1
less than 1
zero
more than 1

⇒

Match the following:

	List I (Theorems)		List II (Property of Network)
A.	Reciprocity	1.	Impedance matching
B.	Tellegen's	2.	Bilateral
C.	Superposition	3.	∑ V_jk I_jk = 0
D.	Maximum power transfer	4.	Linear
		5.	Non linear

A-1, B-2, C-3, D-4
A-1, B-2, C-3, D-5
A-2, B-3, C-4, D-1
A-2, B-3, C-5, D-1

⇒ A number of impulses spaced fron one another form an impulse train.
TRUE
FALSE

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ In a class C power amplifier the input frequency of ac signal is 1 MHz. If tank circuit has C = 1000 pF, the value of L =
25 μH
50 μH
100 μH
200 μH

⇒ The following components are used to measure power output of a 2 kW TWT amplifier:

TWTA
Low pass/high pass filter
20 dB attenuator
40 dB directional complex with matched load
Power load

What is the correct sequence of connection of these components?
2 - 4 - 1 - 3 - 5
1 - 3 - 4 - 2 - 5
1 - 2 - 4 - 3 - 5
2 - 4 - 1 - 5 - 3

⇒

Assertion (A): The resistance of a copper specimen changes by about 22% when temperature is increased from room temperature to 700°C.

Reason (R): The physical properties of a material are determined mostly by the extent of impurities.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one is a linear system?
y[n] = x[n] x x[n - 1]
y[n] = x[n] + x[n - 10]
y[n] = x²[n]
(a) and (c)

⇒ The symbol in figure is
SUS
SBS
SCS
Shockley diode

⇒ The depletion layer consists of immobile ions.
TRUE
FALSE

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watt
1 watt
0.1 watt
0.01 watt

⇒ In a pulsed RADAR, the transmitter is connected to the antenna
during pulse interval
during interval between pulses
all the time
only during a fraction of pulse interval

⇒ Consider the following statement : If a network has an impedance of (1 - j) as a specific frequency, the circuit would consist of series

R and C
R and L
R, L and C

Which of the statement are correct?
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ If transmission path, in PCM, is very long then
repeater stations are used
pulse width may be increased
pulse amplitude is increased
pulse spacing is reduced

⇒ In the circuit of figure the current through 5 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ Robotic manipulator arms mostly use
hydraulic actuator
pneumatic actuator
electric motor actuator
none of the above

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ The system with given pole-zero diagram is _______
Causal
Anti-causal
Both sided
Cannot be determined

⇒ In an oscillator the total phase shift around the loop must be
180°
90°
270°
0°

⇒ A conditionally stable system has
one phase crossover frequency
two phase crossover frequencies
two or more phase crossover frequencies
one or more phase crossover frequencies

⇒ In most of instruments, the controlling torque is provided by
fluid fraction
spring
eddy current
either (a) or (c)

⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
-90°
0°
90°
-180°

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above