Question is ⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh, Options are ⇒ (A) G(s) is an all-pass filter, (B) G(s) has a zero in the right-half plane, (C) G(s) is the impedance of a passive network, (D) G(s) is marginally stable, (E) , Leave your comments or Download question paper.

Question is ⇒ The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh, Options are ⇒ (A) G(s) is an all-pass filter, (B) G(s) has a zero in the right-half plane, (C) G(s) is the impedance of a passive network, (D) G(s) is marginally stable, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The Nyquist plot of a stable, transfer function G(s) is shown in the figure. We are interested in the stability of the closed loop system in the feedback configuration sh
A.	G(s) is an all-pass filter [Wrong Answer]
B.	G(s) has a zero in the right-half plane [Wrong Answer]
C.	G(s) is the impedance of a passive network [Correct Answer]
D.	G(s) is marginally stable [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statements in amplitude modulation

The harmonic and intermodulation distortion may occur in audio and RF amplifiers
The sum and difference frequencies are present in the output of mixer
The diode detector has audio frequencies in its output
A balanced modulator cannot produce an AM with suppressed carrier

Which of the above are true?
1, 2, 3, 4
1, 2, 3
1, 2
3, 4

⇒ In the transformer shown in figure, the inductance measured across terminal 1 and 2 was 4 H with terminals 3 and 4 open. It was 3H when terminals 3 and 4 are short circuited. The coefficient of couplin
1
0.707
0.5
indeterminate due to insufficient data

⇒ Special circuits using neon tubes, contact relays and capacitors are used in many domestic appliances. The role of capacitor in figure i
reduce power loss
function as resistor when relay is on
delay the operation of the contact relay after switching on
open circuit the relay terminals

⇒ The attenuation factor in parallel plane guides is given by
a = power lost/power transmitted
a = 2 x power lost/power transmitted
a = power lost per unit length/2 x power transmitted
a is always constant

⇒ The cut in voltage
is the same for silicon and germanium diodes
is a forward voltage
is a reverse voltage
is a forward voltage below which the current is very small

⇒ The sensitivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ The energy of constant-amplitude complex valued exponential sequence is __________ (where A is the constant amplitude)
0
1
∞
A²

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ A line has an attenuation of 0.054 Np/m. The attenuation in decibels is
4.7 dB/m
0.47 dB/m
0.54 dB/m
5.4 dB/m

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ The effective length of antenna is different from actual length due to
top loading
end effects
both (a) and (b)
none of the above

⇒ For measuring temperatures below 800°C with high accuracy, the best instrument is
optical pyrometer
thermistor based thermometer
GaAs junction diode thermometer
platinum resistance thermometer

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ Which of the following oscillators is suitable for frequencies in the range of mega hertz?
RC phase shift
Wien bridge
Hartley
Both (a) and (c)

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ Which antenna is frequently used for local area transmission at UHF/VHF?
Ground monopole
Turnstile antenna
Slot antenna
Loop antenna

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒ Use of high permeability core in moving iron instrument helps in
reducing size of meter
increasing sensitivity
reducing temperature error
all of the above

⇒ In an RL series circuit the inductance is 1H and current at an instant is 0.6 A. The energy stored in magnetic field is
0.36 J
0.18 J
0.09 J
0.03 J

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next : 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, - 5, - 10
42.2 V
19.098 V
38.2 V
none of these

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
0.001
0.005
0.01
0.02

⇒ For Disk partitioning th DOS command is
F DISK
H DISK
A DISK
D DISK

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ A modem is
a form of commutator
a device for digitizing speech
a circuit used for suppressing microwave mterference
an electronic circuit which carries out modulation and demodulation of a carrier frequency

⇒ In a CE amplifier it is desired that the signal should be able to swing equally in both directions. Then the Q point should be
at the centre of ac load line
at the centre of dc load line
at the centre of collector voltage
at the centre of collector current