Question is ⇒ In gases the flow of current is due to, Options are ⇒ (A) positive ions only, (B) electrons only, (C) electrons, positive ions and negative ions, (D) electrons and positive ions, (E) , Leave your comments or Download question paper.

Question is ⇒ In gases the flow of current is due to, Options are ⇒ (A) positive ions only, (B) electrons only, (C) electrons, positive ions and negative ions, (D) electrons and positive ions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In gases the flow of current is due to
A.	positive ions only [Wrong Answer]
B.	electrons only [Wrong Answer]
C.	electrons, positive ions and negative ions [Correct Answer]
D.	electrons and positive ions [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The most commonly used magnetron is
cylindrical
parallel plate
inclined plate
flat plate

⇒ A medium is said to be isotropic when
∈ = 0
∈ = μ
∈ = σ
∈ is scalar constant

⇒ A series RC circuit has fixed R and C and variable f. The current locus will lie in the first quadrant.
TRUE
FALSE

⇒ On load tap changer using thyristors can have a maximum of two taps.
TRUE
FALSE

⇒ The force required to initiate motion between two contacting surfaces is called
coulomb friction
viscous friction
static friction
none of the above

⇒ The use of a capacitor filter in a rectifier circuit gives satisfactory performance only when the load
current is high
current is low
voltage is high
voltage is low

⇒ Ionospheric storm causes an abnormal decrease in the critical frequency.
TRUE
FALSE

⇒ In a lead acid cell, the positive plate has spongy lead.
TRUE
FALSE

⇒ How is an N-channel junction Field Effect Transistor operated as an amplifier?
With a forward bias gate source junction
With a reverse bias gate-source junction
With a open gate source junction
With a shorted gate source junction

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ Consider the following in C 4.2 and 300
4 and 300 respectively
4.2 and 300.00 respectively
4 and 300.00 respectively

⇒ In 8085 microprocessor, how many I/O ports can be accessed by direct method?
8
256
32 K
64 K

⇒ The first and the last critical frequency of an RC driving point impedance function must respectively by
a zero and a pole
a zero and a zero
a pole and a pole
a pole and a zero

⇒ If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is
0
1
∞
2

⇒

Assertion (A): A ballistic galvanometer is used to measure charge.

Reason (R): In a flux meter, the damping is large.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Assignment
B.	\| \|	2.	Logical AND
C.	=	3.	Logical OR

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
1 mV
2 mV
1.414 mV
4 mV

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ An electromagnetic wave incident on a perfect conductor is
fully transmitted
partially transmitted
entirely reflected
none of the above

⇒ Hollow waveguides are used as transmission lines at frequencies
above 1 GHz
above 5 GHz
above 10 MHz
above 1 MHz

⇒ The advantage of semiconductor strain gauge over resistance strain gauge is
it is more sensitve
it is more linear
it is less temperature dependent
it is cheaper

⇒ In forward active region, the operation of a BJT
both junctions are forward biased
both junctions are reverse biased
emitter base junction is forward biased and base collector junction is reverse biased
emitter base junction is reverse biased and base collector junction is reverse biased

⇒ A certain JK FF has t_pd = 12 n sec the largest MOD counter that can be constructed from these FF and still operate up to 10 MHz is
any
8
256
10

⇒ For a Mod 64 parallel counter we need
6 flip flops
6 flip flops and 2 AND gates
6 flip flops and 4 AND gates
none of the above

⇒ CMRR is the ratio of differential voltage gain to common mode gain.
TRUE
FALSE

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒

Assertion (A): In KVL equations involving mutually coupled circuits the sign of M terms can be positive or negative.

Reason (R): Dot convention helps in determining sign of M terms in KVL equations.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The purpose of impedance matching in an amplifier circuit is to achieve
high efficiency
reduce distortion
maximum power transfer
none of the above

⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement 13
16
9
14

⇒ A variable resistance R and capacitive reactance X_C are fed by an voltage. The current locus is
a semi circle in 4th quadrant
a semi circle in first quadrant
a straight line in 4th quadrant
a straight line first quadrant