Question is ⇒ A cycloconverter is, Options are ⇒ (A) ac-dc converter, (B) dc-ac converter, (C) dc-dc converter, (D) ac-ac converter, (E) , Leave your comments or Download question paper.

Question is ⇒ A cycloconverter is, Options are ⇒ (A) ac-dc converter, (B) dc-ac converter, (C) dc-dc converter, (D) ac-ac converter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A cycloconverter is
A.	ac-dc converter [Wrong Answer]
B.	dc-ac converter [Wrong Answer]
C.	dc-dc converter [Wrong Answer]
D.	ac-ac converter [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The forbidden energy gap between the valence band and conduction band will be least in case of
metals
semiconductors
insulators
all of the above

⇒ The minimum step size required for a Delta modulator operating at 36 samples/sec to track the signal (here u(t) is the unit step function) x(t) = 125t (u(t) - u(t - 1)) + (250 - 125t) (u(t - 1) - u(t - 2)) So that slope overload is avoided, would be
2^-10
2^-8
2^-6
2^-4

⇒ At t = ∞; V_R2 and V_C wil
4, 4
2, 4
0, 2
2, 0

⇒ Which of the following is a valid variable in FORTRAN 77?
0.125
ALPHA -3
ALPHA 3
BALPHAC

⇒ X(t) is a stationary process with the power spectral density S_x(f) > 0 for all f. The process is passed through a system shown be
S_y(f) > 0 for all f
S_y(f) = 0 for |f| > 1kHz
S_y(f) = 0 for f = nf₀, f₀ = 2kHz, n any integer
S_y(f) = 0 for f = (2n + 1)f₀ = 1 kHz, n any integer

⇒ In LIFO
only the top of the stack is immediately accessible
only the top of the stack is never accessible
only the first-in is accessible
only the first-in is not accessible

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ The total field produced by an antenna array system at a distance from it is
sum of the field produced by the individual antennas of the array system
directional gain of antenna
linear antenna gain
vector sum of the field produced by the individual antennas of the array system

⇒ Fourier transform o the function f(t) = 1 is
2p δ (ω)
p δ (ω)
δ(ω)/2p
δ(ω)/p

⇒ If a fuse is higher than required current rating is employed in a circuit, it will
blow more frequently since it carries more current
afford better protection to the circuit
seriously overload the circuit
lead to larger maintenance cost

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ Decimal number 46 in excess 3 code =
1000 1001
0111 1001
0111 1111
1000 1111

⇒ In a transistor CE mode, V_CC = +30 V. If the transistor is in cut off region, V_CE =
+30 V
+20 V
10 V
zero

⇒ The input resistance R, of an ideal voltage amplifier is __________ and that of a current amplifier is __________ .
zero, zero
infinite, infinite
zero, infinite
infinite, zero

⇒ Which of the following antenna is best guided by a waveguide?
Biconical
Horn
Helical
Dish

⇒ When two coupled coils of equal self inductance are cormected in series in one way the net inductance is 12 mH and when they are connected in the other way the net inductance is 4 mH. The maximum value of inductance when they are connected in parallel is
2 mH
3 mH
4 mH
6 mH

⇒ For a push pull circuit the most favoured biasing method is
self bias
emitter bias
diode bias
collector bias

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
0.0125
0.025
-0.0125
-0.025

⇒ A series circuit has R = 5 Ω and C = 10 μF. It is switched on to a 12 V dc battery at t = 0. The current in the circuit will be maximum
at t = RC
at t = ∞
at t = 0⁺
none of the above

⇒ Half wave sysmmetry means f(t) = - f(t ± T/2).
TRUE
FALSE

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
be doubled
be increased four times
remain the same
become half

⇒ DC ampere hour meter is an indicating instrument.
TRUE
FALSE

⇒ The energy of highest value of Autocorrelation of a function 100 cos 50 pt is
50
10
200
zero

⇒ For the circuit shown in the following figure I₀-I₃ are inputs to the 4:1 multiplexer R(MSB) and S are control
PQ + PQ S + Q R S
P Q + PQ R + P Q S
P Q R + P QR + PQRS + Q R S
PQ R + PQR S + P Q R S + Q R S

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation

⇒

Assertion (A): When all inputs of a NAND-gate are shorted to get a one input, one output gate, it becomes an inverter.

Reason (R): When all inputs of a NAND-gate are at logic 'O' level, the output is at logic 'I' level.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In binary data transmission DPSK is preferred to PSK because
a coherent carrier is not required to the generated at the receiver
for a given energy per bit, the probability for zero is less
the 180° phase shifts of the carrier
more protection is provided against impulse noise

⇒ In TV signals colour burst is used
to maintain colour sequence
to ensure I and Q phase correctly
to synchronise colours
for interlacing of horizontal lines