Question is ⇒ Given figure is the voltage transfer characteristi, Options are ⇒ (A) an N MOS inverter with enhanced mode transistor as load, (B) an N MOS inverter with depletion mode transistor as load, (C) a CMOS inverter, (D) BJT inverter, (E) , Leave your comments or Download question paper.

Question is ⇒ Given figure is the voltage transfer characteristi, Options are ⇒ (A) an N MOS inverter with enhanced mode transistor as load, (B) an N MOS inverter with depletion mode transistor as load, (C) a CMOS inverter, (D) BJT inverter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Given figure is the voltage transfer characteristi
A.	an N MOS inverter with enhanced mode transistor as load [Wrong Answer]
B.	an N MOS inverter with depletion mode transistor as load [Wrong Answer]
C.	a CMOS inverter [Correct Answer]
D.	BJT inverter [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13

⇒ The average load current supplied by a thyristor depends on
firing angle
firing frequency
magnitude of gate current
all of the above

⇒ A balun should have
low SWR at both ports
high SWR at both ports
high SWR at input port and low SWR at output port
low SWR at input port and high SWR at output

⇒ McMurray Bedford full bridge inverter uses
natural commutation
auxiliary commutation
complementary commutation
any of the above

⇒ SCR turns of from conducting state to blocking state on
reducing gate current
reversing gate voltage
reducing anode current below holding current value
applying ac to the gate

⇒ Figure shows the terminals of a transistor in plastic package TO 18. T
terminals 1, 2, 3 are emitter, collector, base respectively
terminals 1, 2, 3 are emitter, base, collector respectively
terminals 1, 2, 3 are base, emitter collector, respectively
terminals 1, 2, 3 are collector, emitter, base respectively

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ In TV transmitter, the function of duplexer is
to amplify video signal
to remove distortions in audio signal
to combine outputs of visual and audio transmitters
to amplify audio signal

⇒ The static electric field in a conductor is
zero
unity
infinity
none of the above

⇒ Which of the following oscillator circuits uses three capacitors in the phase shifting network?
Hartley
Clapp
Colpitt's
Both (b) and (c)

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ For full wave rectification four diode bridge rectifier is claimed to have following advantages:

Less expensive transformer
Small size transformer
Suitable for higher voltage applications

Which of these are correct?
1 and 2 only
1 and 3 only
2 and 2 only
1, 2, 3

⇒ What will be maximum input that can be converted for a 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9 V
9.45
10 V
8 V

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will accumulator (A) and carry (CY) contain after ANA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ In a common Emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche breakdown of Base emitter junction
collector to Base Breakdown voltage with emitter open (βV_CBO)
collector Emitter Breakdown voltage with base open (βV_CBO)
zener breakdown voltage of the emitter base Junction

⇒ A nibble corresponds to
2 successive bits of data
4 successive bits of data
8 successive bits of data
16 successive bits of data

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒

Assertion (A): A balun is an RF impedance matching transformer.

Reason (R): Sometimes a booster amplifier is used with a TV set.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ What happens when forward bias is applied to a junction diode?
Majority carrier current is reduced to zero
Minority carrier current is reduced to zero
Potential barrier is increased
Potential barrier is decreased

⇒ In a microstrip transmission the signal can be easily redirected by changing the centre strip.
TRUE
FALSE

⇒ The number of spectral component when two cosine waves are multiplied of different frequency
1
2
8
4

⇒

Assertion (A): The dual of a circuit can be drawn by window-dot method.

Reason (R): The principle of duality is of great help in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒ In digital circuits Schottky transistors are preferred over normal transistors because of their
lower propagation delay
lower power dissipation
higher propagation delay
higher power dissipation

⇒ For a transmission line open circuit and short circuit impedances are 20 Ω and 5 Ω. Then characteristic impedance is
100 Ω
50 Ω
25 Ω
10 Ω

⇒ A synchro transmitter receiver unit is a
two phase ac device
3 phase ac device
dc device
1 phase ac device

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM