Question is ⇒ An ungrounded antenna near the ground, Options are ⇒ (A) is horizontally polarized, (B) acts as an antenna array, (C) acts as a single antenna of twice the height, (D) is not likely to need an earth mat, (E) , Leave your comments or Download question paper.

Question is ⇒ An ungrounded antenna near the ground, Options are ⇒ (A) is horizontally polarized, (B) acts as an antenna array, (C) acts as a single antenna of twice the height, (D) is not likely to need an earth mat, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An ungrounded antenna near the ground
A.	is horizontally polarized [Wrong Answer]
B.	acts as an antenna array [Wrong Answer]
C.	acts as a single antenna of twice the height [Correct Answer]
D.	is not likely to need an earth mat [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The modulation of effective base width by collector voltage is known as Early effect, hence reverse collector voltage
increases both a and β
decrease both a and β
increase a but decrease β
decrease a but increase β

⇒

Assertion (A): If source and destination addresses are made implicit the length of instruction is reduced.

Reason (R): 8085 has only 3 addressing modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A two-input OR gate is designed for positive logic. However, it is operated with negative logic. The resulting logic operation will then be
OR
AND
NOR
EX-OR

⇒ One of the following can be used to generate a pulse whenever triggered
flip-flop
monostable multivibrator
stable multivibrator
Schmitt trigger

⇒ The sensitivity of electromagnetic digital flow meter can be increased by increasing
circumferential width of rotor teeth
radial depth of rotor teeth
thickness of rotor teeth
number of teeth

⇒

Assertion (A): Oxide coated cathodes are very commonly used.

Reason (R): Work function of oxide coated cathode is 1 eV whereas it is 4.5 eV for pure tungsten.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Square law modulators utilise
linear range of V-I characteristics of a diode
linear range of V-I characteristics of a triode
non-linear region of V-I dynamic characteristics of a diode
non-linear region of V-I dynamic characteristics of a triode

⇒ A series RLC circuit is supplied from a variable frequency source. The resonant frequency is ω₀. The voltage across L is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ In force voltage analogy, displacement is analogous to
current
voltage
charge
none of the above

⇒ The number of switching functions of 3 variables are
3
8
16
32

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna

⇒

Assertion (A): Divide-64 counter is a Mod-64 counter and divides the input frequency by 64

Reason (R): A Mod 64 counter can be obtained by cascading Mod 16 and Mod 4 counters.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above

⇒ Which of the following is a passive component?
Semiconductor devices
Vacuum tube devices
Capacitors
All of the above

⇒ The circuit of figure give an output which
a frequency modulated signal
an amplitude modulated signal
a phase modulated signal
none of the above

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ In register index addressing mode the effective address is given by
index register value
sum of the index register value and the operand
operand
difference of the index register value and the operand

⇒ One commercial unit of energy is equal to
1 watt-sec
1 kilowatt-sec
1 kilowatt-hour
One watt-hour

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ Indium, aluminium, arsenic are all p type impurities.
TRUE
FALSE

⇒ CMRR of an op-amp is about 0.1.
TRUE
FALSE

⇒ In a klystron amplifier the force on all electrons
causes acceleration of all electrons
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ When subjected to alternating stresses, an insulating material is characterised by complex dielectric constant ∈^'_r - j∈^"_r . In such materials, the dielectric losses under alternating stress is proportional
∈^"_r
both ∈^'_r and ∈^"_r
∈^'_r
(∈^"_r)²

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ For a short dipole having an effective length less than half the wavelength the radiation resistance is
proportional to length
proportional to square root of length
proportional to square of length
none of the above

⇒ A radar receiver has a noise figure of 10 dB at 300 K having a bandwidth of 2.5 MHz. The minimum power it can receive is
3.45 x 10^-15 W
1.38 x 10^-15 W
7.5 x 10^-15 W
93.15 x 10^-15 W

⇒ An inductor filter has a ripple that __________ with load resistance and consequently is used only with relatively __________ load currents.
decreases, low
decreases, high
increases, low
increases, high