Question is ⇒ Which of the following binary product is incorrect?, Options are ⇒ (A) 1100 x 1010 = 1111000, (B) 1.01 x 10.1 = 11.001, (C) 1100110 x 1000 = 1100110000, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following binary product is incorrect?, Options are ⇒ (A) 1100 x 1010 = 1111000, (B) 1.01 x 10.1 = 11.001, (C) 1100110 x 1000 = 1100110000, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following binary product is incorrect?
A.	1100 x 1010 = 1111000 [Wrong Answer]
B.	1.01 x 10.1 = 11.001 [Wrong Answer]
C.	1100110 x 1000 = 1100110000 [Wrong Answer]
D.	None of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ At resonance the network function magnitude will be
k/a
k/b
c
k/a + b

⇒ For the logic circuit of the given figure the simplified Boolean expressio
A + BC
A + BC
A + B C
A + BC

⇒ Which one of the following type of negative feedback increases the input resistance and decreases the output resistance of an amplifier?
Current series feedback
Voltage series feedback
Current shunt feedback
Voltage shunt feedback

⇒ Fleming's left hand rule is used to find
direction of force on a current carrying conductor
direction of flux in solenoid
direction of magnetic field due to a current carrying conductor
direction of induced emf

⇒ In the given figure the line voltage after a number of reflections wil
30 V
-30 V
10 V
-10 V

⇒ Hexadecimal number E is equal to binary number
1110
1101
1001
1111

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒

Match the following:

	List I		List II
A.	Coastals receiver	1.	VSB
B.	Stereo-multiplexing	2.	Demodulating DSB-SC
C.	TV broad casting	3.	FM radio broad casting
		4.	Slope overload
		5.	Matched filter

A-1, B-3, C-2
A-2, B-3, C-1
A-2, B-1, C-4
A-4, B-3, C-1

⇒ Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represe
unit circles
constant resistance circles
constant reactance circles
constant reflection coefficient circles

⇒ In Bode analysis the correction at corner frequency is 3 dB.
TRUE
FALSE

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ The standard deviation of a set of observations is the rms value of the deviation from the arithmetic mean.
TRUE
FALSE

⇒

Assertion (A): For most metals, Fermi energy E_F is less than 10 eV.

Reason (R): Fermi level of a metal is given by E_F = 3.64 x 10^-19 (n)^2/3 where n is number of free electrons/m³ of metal.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the inputs to a 2 input XOR gate are high then, the output is high.
TRUE
FALSE

⇒ The Wheatstone bridge method of measuring resistance is ideally suited for the measurement of resistance values in the range of
0.001 to 1 Ω
0.1 to 100 Ω
100 Ω to 10 kΩ
100 kΩ to 10 MΩ

⇒ How many cascaded stage of CE amplifiers will result in polarity inversion of the input signal?
Two
Three
Four
None

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD

⇒ Which one of the following is transferred locking electron device C antenna?
BARITT diode
IMPATT diode
Gunn diode
Step recovery diode

⇒ The impedance parameter z₂₁ is
transfer impedance at port 1 with port 2 open circuited
transfer impedance at port 1 with port 2 short circuited
transfer impedance at port 2 with port 1 open circuited
transfer impedance at port 2 with port 1 short circuited

⇒ The increase in intensity of trace in a CRO causes a change in
beam current
frequency of time base
gain of Y amplifier
accelerating voltage

⇒ A battery charger can drive a current of 5A with 1Ω resistance connected at its output. If it can charge 2 V battery at 7 A rate, its Thevenin's equivalent circuit will be
7.5 in series with 0.5 Ω resistance
1.25 V in series with 1.5 Ω resistance
7.5 V in parallel with 0.5 Ω resistance
12.5 V in parallel with 1.5 Ω resistance

⇒ A carrier is simultaneously modulated by two sine waves having modulation indices of 0.4 and 0.3. The total modulation index will be
0.1
0.7
0.5
0.35

⇒ The gate current required to turn on an SCR is
few amperes
a few mA
almost equal to anode current
about 50% of anode current

⇒ If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
498 ± 8
498 ± 4
498 ± 11
498 ± 13

⇒ Colour picture tube needs higher anode voltage and needs larger beam and cathode currents than monochrome tube because
it is bigger in size
it has higher level of illumination
the tube has to illuminate three phosphors simultaneously
the tube has lower efficiency because of aperture mask

⇒ The velocity factor of a transmission line depends on
temperature
skin effect
relative permittivity of dielectric
none of the above

⇒ For a second order system, the position of poles is shown in the given figure. This syste
undamped
overdamped
underdamped
critically damped

⇒ In which of the following logical group instructions of 8085 do the contents of accumulator remain unchanged?
ORA r
ORA M
ORI data
CMP r

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒

Assertion (A): Hollow waveguides are frequently used as transmission lines at microwave frequencies.

Reason (R): Waveguide has high power handling capacity, low loss and simple structure.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct