Question is ⇒ An excitation is applied to a system at t = T and the response in zero for -∞ < t < T. This system is, Options are ⇒ (A) non casual, (B) stable, (C) casual, (D) unstable, (E) , Leave your comments or Download question paper.

Question is ⇒ An excitation is applied to a system at t = T and the response in zero for -∞ < t < T. This system is, Options are ⇒ (A) non casual, (B) stable, (C) casual, (D) unstable, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An excitation is applied to a system at t = T and the response in zero for -∞ < t < T. This system is
A.	non casual [Wrong Answer]
B.	stable [Wrong Answer]
C.	casual [Correct Answer]
D.	unstable [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the transfer function has zeros only on jω axis or in left half plane, it is a minimum phase function.
TRUE
FALSE

⇒ A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at t =
zero
infinity
L/R
R/L

⇒ A Wien bridge is suitable for
audio frequencies only
radio frequencies only
both audio and radio frequencies
very low frequencies only

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒

Assertion (A): In class A amplifier the distortion is minimum

Reason (R): In class A amplifier collector current exists for 360° of input cycle

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following characteristics is not true for TTL Logic?
Good speed
Low power dissipation per gate
High cost
None of these

⇒ A reverse voltage of 18 V is applied to a semiconductor diode. The voltage across the depletion layer is
0 V
0.7 V
about 10 V
18 V

⇒ Two transistors have same value of a but different gain (G) bandwidth (B) product. The transistors have similar geometry. However one of them is germanium and the other is silicon. The transistor with lower GB product
is germanium
is silicon
may be either of two
cannot be identified on the basis of above data

⇒ For an unstable system the gain margin is indicative of how much the gain should be decreased to make the system stable.
TRUE
FALSE

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ For a Gaussian process, auto-correlation sequence also implies that
statistical independence
statistical dependence
ergodic process
all

⇒ Magnetic amplifier is used for
voltage amplification
power amplification
current amplification
frequency amplification

⇒ A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
10 sin (200t + 90°)
10 sin (200t - 90°)
10 sin(1000t + 90°)
10 sin (1000t - 90°)

⇒ Which of the following statement is false?
The gate of DMOSFET may be biased positively, zero or negatively
N-channel enhancement-only MOSFET conducts only when its gate is highly positive
JFET has lower input impedance than MOSFET
The bipolar base is forward biased, JFET gate must also be forward biased

⇒ Secondary emission is always decremental.
TRUE
FALSE

⇒ In a P-N-P junction transistor as compared to base region is more heavily doped so that
leakage current is minimized
recombination will be increased in the base region
the flow across the base regional is only because of electrons
the flow across the base region is mainly because of holes

⇒ Which of the following combinations is not used in thermocouple transducer measurement of temperature?
Iron-constantan
Chromel-aluminium
Copper-constantan
Iron-silver

⇒ Figure shows an 8-bit LED display. A light circle means that a LED is ON (binary 1) and a dark circle means a LED is OFF (binary 0). What is the decimal equivalent of the binary number displa
100
121
144
172

⇒ System bus is the communication channel between microprocessor and peripherals.
TRUE
FALSE

⇒ When a plane wave travelling in free space is incident normally on a medium having ε_r = 4.0, then fraction of power transmitted into the medium is given by
42956
42737
42738
42861

⇒ In figure, the switch is closed at t = 0. At t = 0⁺, di/dt = 4 A/s. Then
10 V
20 V
40 V
80 V

⇒ In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
100 v
0 v
∞
- 100 v

⇒ An RLC series circuit has R = 1 Ω, L = 1 H, C = 1 F. The damping ratio is
More than 1
1
0.5
Zero

⇒ The noise figure of klystron amplifier is about
25 dB
3 dB
zero
1 dB

⇒ A system is highly oscillatory if
gain margin is high
gain margin is close to 1
gain margin is close to 1 or phase margin is zero
gain margin is high and phase margin is 180°

⇒ A transmission line having 50 Ω impedance is terminated in a load of (40 + j 30) Ω. The VSWR is
j 0.033
0.8.+ j 0.6
1
2

⇒

Assertion (A): The impedance of a matched load is equal to characteristic impedance of line.

Reason (R): A matched termination absorbs all the power incident on it.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A FET
has two P-N junctions
has three P-N junctions
depends on the variation of the depletion layer width with reverse voltage, for its operation
depends on the variation of a magnetic field for its operation