Question is ⇒ Figure shows a pole zero plot of I(s). The likely current response in time domai, Options are ⇒ (A) i (t) = e-1 - e-3t, (B) i (t) = e-1 - 2e-2t, (C) i (t) = e-1 - e-2t, (D) i (t) = e-1 - e-4t, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure shows a pole zero plot of I(s). The likely current response in time domai, Options are ⇒ (A) i (t) = e-1 - e-3t, (B) i (t) = e-1 - 2e-2t, (C) i (t) = e-1 - e-2t, (D) i (t) = e-1 - e-4t, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure shows a pole zero plot of I(s). The likely current response in time domai
A.	i (t) = e^-1 - e^-3t [Wrong Answer]
B.	i (t) = e^-1 - 2e^-2t [Correct Answer]
C.	i (t) = e^-1 - e^-2t [Wrong Answer]
D.	i (t) = e^-1 - e^-4t [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ ∇² is
vector
scalar
depend on direction
none

⇒ An electromagnetic wave incident on a perfect conductor is
fully transmitted
partially transmitted
entirely reflected
none of the above

⇒ Which of the following noise sources is different from others?
Cosmic
Solar
Atmospheric
Galactic

⇒ A FET is to be operated as voltage variable resistor. For this drain to source voltage V_DS should be,
74
= V_P
< V_P
> V_P

⇒ A Yagi antenna has a driven antenna
only
with a reflector
with one or more directors
with a reflector and one or more directors

⇒ Percentage increase in the reverse saturation current of a diode if the temperature is increased from 25°C to 50°C
0.5
5
5.657
5.756

⇒ A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then
all the coils are in series
all coils are in parallel
the coils are in series-parallel
either (a) or (b)

⇒ Which of the following DO statements is invalid in FORTRAN 77?
DO 161 = 1, 15
DO 16 1 = 1, 10, 1
DO 16 I = - 5, 5, 2
none of the above

⇒ For transistor 2 N 338 the manufacturer specifies P_max = 100 mW at 250°C free air temperature and maximum junction temperature of 125°C. Its thermal resistance is
10° C/W
100° C/W
1000° C/W
5000° C/W

⇒ Frequencies in the UHF range propagate by means of
space wave
surface waves
sky waves
ground waves

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be
38.5 W
400 W
512.5 W
615.5 W

⇒ In Pascal if I = 55, 10 * I div 10 =
55
50
5.5
5

⇒ What is the direction of control
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into μp an some others out of μp

⇒ An ohmmeter is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ The ac input voltage of an amplifier
is always equal to ac signal voltage
may be equal to or more than ac signal voltage
is always less than ac signal voltage
may be equal or more or less than ac signal voltage

⇒ The number of essential prime implicant for the logic express
3
5
4
6

⇒ A balun provides an impedance transformation of
0.667361111111111
0.334027777777778
0.167361111111111
0.0840277777777778

⇒ Three inductors each 30 mH are connected in delta. The value of inductance or each arm of equivalent star is
10 mH
15 mH
30 mH
90 mH

⇒ For a waveguide, which of the following statements is wrong?
It is usually made of brass or aluminium
It is usually rectangular or circular in shape
The dielectric region is usually air
The wall thickness is very small as compared to skin depth

⇒ In grid bias modulation system the power required for modulating amplifier
is negligibly low since grid is negative
is large as compared to that for plate modulation
is almost the same as compared with plate modulation
is small as compared to that for plate modulation

⇒ A hot wire instrument is not affected by stray magnetic fields.
TRUE
FALSE

⇒ The attenuation factor in parallel plane guides is given by
a = power lost/power transmitted
a = 2 x power lost/power transmitted
a = power lost per unit length/2 x power transmitted
a is always constant

⇒ In 8085 the instruction MOV A, B is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ A network is said to be two port network if there is

no independent source in the network
no dependent source in the network
non-linear component in the circuit
no external connection exist between I/P and 0/P

1, 2, 3
3, 4, 2
1, 3, 4
4, 3, 1, 2

⇒ Which of the following are synonymous?
MOSFET and IGEFT
FET and JFET
JFET and MOSFET
P-N-P and N-P-N

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ For a two- port reciprocal network, the output open circuit voltage divided by the input current is equal to
B
Z₁₂
1/y₁₂
h₁₂

⇒ A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.4624 V
113.462 V
113.46 V
113 V

⇒ Which of the following lines behaves as infinite line?
a line terminated in inductance
a line terminated in capacitance
a short line
a line terminated in z₀

⇒ In a push pull circuit
each transistor conducts for 180°
each transistor conducts for more than 180° but less than 360°
each transistor conducts for less than 180°
the period of conduction of each transistor depends on circuit configuration